Long-Term Modal Analysis of Wireless Structural Monitoring Data from a Suspension Bridge under Varying Environmental and Operational Conditions: System Design and Automated Modal Analysis
Publication: Journal of Engineering Mechanics
Volume 143, Issue 4
Abstract
Structural monitoring systems installed on cable-supported bridges have the potential to generate large data repositories from which a deeper understanding of bridge behavior can be obtained. The core focus of this study is the use of response and environmental data collected by a permanent wireless monitoring system operating on the New Carquinez Bridge (Vallejo, California) since 2010. Given the large amount of data available, the study proposes an automated stochastic subspace identification approach for the extraction of bridge modal properties. The study fits logistic distributions to the extracted modal frequencies and modal damping ratios to provide statistical models for these important bridge properties. Low levels of modal damping well below 0.8% are reported for the majority of structural modes. Bridge modal properties exhibit sensitivity to the environmental and operational conditions of the bridge. Ridge regression and Gaussian process regression (GPR) are used to model the dependency of modal frequency on bridge environmental and operational conditions. The GPR models are shown capable of accurately modeling the relationship between modal frequency and bridge environmental and operational conditions.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to gratefully acknowledge the generous support offered by the U.S. Department of Commerce, National Institute of Standards and Technology (NIST) Technology Innovation Program (TIP) under Cooperative Agreement Number 70NANB9H9008. Additional support was provided by the California Department of Transportation (Caltrans); the help provided by Li Hong Sheng, Patrick Hipley, Ed Thometz, and Mark Efe was invaluable to the execution of the monitoring study. Additional support was provided by the National Science Foundation Grant Numbers CCF-0910765, CMMI-1362513, CMMI-1436631, and ECCS-1446521.
References
Brincker, R., Andersen, P., and Jacobsen, N. J. (2007). “Automated frequency domain decomposition for operational modal analysis.” Conf. 2007 IMAC-XXV: Conf. and Exposition on Structural Dynamics, Society for Experimental Mechanics, Bethel, CT.
Brownjohn, J., Moyo, P., Omenzetter, P., and Lu, Y. (2003). “Assessment of highway bridge upgrading by dynamic testing and finite-element model updating.” J. Bridge Eng., 162–172.
Catbas, F. N., Susoy, M., and Frangopol, D. M. (2008). “Structural health monitoring and reliability estimation: Long span truss bridge application with environmental monitoring data.” Eng. Struct., 30(9), 2347–2359.
Conte, J. P., et al. (2008). “Dynamic testing of Alfred Zampa memorial bridge.” J. Struct. Eng., 1006–1015.
Cornwell, P., Farrar, C. R., Doebling, S. W., and Sohn, H. (1999). “Environmental variability of modal properties.” Exp. Tech., 23(6), 45–48.
Cross, E. J., Koo, K. Y., Brownjohn, J. M. W., and Worden, K. (2013). “Long-term monitoring and data analysis of the Tamar bridge.” Mech. Syst. Sig. Process., 35(1-2), 16–34.
Ewins, D. J. (2000). Modal testing, theory, practice, and application (Mechanical engineering research studies: Engineering dynamics series), 2nd Ed., Research Studies Press, Baldock, Hertfordshire, England.
Fraser, M., Elgamal, A., He, X., and Conte, J. P. (2010). “Sensor network for structural health monitoring of a highway bridge.” J. Comput. Civil. Eng., 11–24.
Friswell, M., and Mottershead, J. (1995). Finite element model updating in structural dynamics, Springer, Dordrecht, Netherlands.
Fujino, Y., Kimura, K., and Tanaka, H. (2012). “Wind resistant design codes for bridges in Japan.” Wind resistant design of bridges in Japan, Springer, Tokyo.
Häckell, M. W., and Rolfes, R. (2013). “Monitoring a 5MW offshore wind energy converter—Condition parameters and triangulation based extraction of modal parameters.” Mech. Syst. Sig. Process., 40(1), 322–343.
He, X., Moaveni, B., Conte, J. P., Elgamal, A., and Masri, S. F. (2009). “System identification of Alfred Zampa memorial bridge using dynamic field test data.” J. Struct. Eng., 54–66.
Hoerl, A. E., and Kennard, R. W. (1970). “Ridge regression: Biased estimation for nonorthogonal problems.” Technometrics, 12(1), 55–67.
Hong, A. L., Ubertini, F., and Betti, R. (2011). “Wind analysis of a suspension bridge: Identification and finite element model simulation.” J. Struct. Eng., 133–142.
Hua, X. G., Ni, Y. Q., Ko, J. M., and Wong, K. Y. (2007). “Modeling of temperature-frequency correlation using combined principal component analysis and support vector regression technique.” J. Comput. Civil. Eng., 122–135.
Kim, J., and Lynch, J. P. (2012). “Autonomous decentralized system identification by Markov parameter estimation using distributed smart wireless sensor networks.” J. Eng. Mech., 478–490.
Kurata, M., Kim, J., Lynch, J. P., van der Linden, G. W., Sedarat, H., Thometz, E., Hipley, P., and Sheng, L.-H. (2013). “Internet-enabled wireless structural monitoring systems: Development and permanent deployment at the New Carquinez suspension bridge.” J. Struct. Eng., 1688–1702.
Kurata, M., Lynch, J. P., van der Linden, G., Jacob, V., and Hipley, P. (2010). “Preliminary study of a wireless structural monitoring system for the New Carquinez suspension bridge.” 5th World Conf. of Structural Control and Monitoring, International Association for Structural Control and Monitoring, Los Angeles, 1–14.
Li, H., Li, S., Ou, J., and Li, H. (2010). “Modal identification of bridges under varying environmental conditions: Temperature and wind effects.” Struct. Control Health Monit., 17(1), 495–512.
Loh, C.-H., and Chen, M. (2013). “Modeling of environmental effects for vibration-based SHM using recursive stochastic subspace identification analysis.” Key Eng. Mater., 558, 52–64.
Magalhães, F., Cunha, Á., and Caetano, E. (2009). “Online automatic identification of the modal parameters of a long span arch bridge.” Mech. Syst. Sig. Process., 23(2), 316–329.
MATLAB [Computer software]. Mathworks, Matick, MA.
Meng, F., Ozbek, M., Rixen, D. J., and van Tooren, M. J. L. (2011). “Comparison of system identification techniques for predicting dynamic properties of large scale wind turbine by using the simulated time response.” Structural dynamics and renewable energy, Vol. 1, Springer, New York, 339–349.
Michael, B., Mertz, D. R., and Commander, B. (1997). “Experimental load rating of a posted bridge.” J. Bridge Eng., 1–10.
Moser, P., and Moaveni, B. (2011). “Environmental effects on the identified natural frequencies of the Dowling Hall Footbridge.” Mech. Syst. Sig. Process., 25(7), 2336–2357.
Ni, Y. Q., Hua, X. G., Fan, K. Q., and Ko, J. M. (2005). “Correlating modal properties with temperature using long-term monitoring data and support vector machine technique.” Eng. Struct., 27(12), 1762–1773.
O’Connor, S. M., Zhang, Y., Lynch, J. P., Ettouney, M., and Jansson, P. (2016). “Long-term performance assessment of the Telegraph Road Bridge using a permanent wireless monitoring system and automated statistical process control analytics.” Struct. Infrastruct. Eng., 1–21.
OPAC Consulting Engineers. (2016). “Third Carquinez Strait bridge.” ⟨http://www.opacengineers.com/features/carquinez⟩ (May 27, 2016).
Peeters, B., and De Roeck, G. (2001). “One year monitoring of the Z24 Bridge: Environmental influences versus damage events.” Earthquake Eng. Struct. Dyn., 30(2), 149–171.
Peeters, B., De Roeck, G., Pollet, T., and Schueremans, L. (1997). “Stochastic subspace techniques applied to parameter identification of civil engineering structures.” New advances in modal synthesis of large structures, A. A. Balkema, Rotterdam, Netherlands, 145–156.
Pridham, B. A., and Wilson, J. C. (2003). “A study of damping errors in correlation-driven stochastic realizations using short data sets.” Probab. Eng. Mech., 18(1), 61–77.
Rasmussen, C. E., and Williams, C. K. I. (2006). Gaussian processes for machine learning, MIT Press, Cambridge, MA.
Smola, A., and Schölkopf, B. (2004). “A tutorial on support vector regression.” Stat. Comput., 14(3), 199–222.
Sohn, H., Dzwonczyk, M., Straser, E. G., Kiremidjian, A. S., Law, K. H., and Meng, T. (1999). “An experimental study of temperature effect on modal parameters of the Alamosa Canyon bridge.” Earthquake Eng. Struct. Dyn., 28(8), 879–897.
Spence, S., and Kareem, A. (2014). “Tall buildings and damping: A concept-based data-driven model.” J. Struct. Eng., 04014005.
Swartz, R., et al. (2012). “Hybrid wireless hull monitoring system for naval combat vessels.” Struct. Infrastruct. Eng., 8(7), 621–638.
Swartz, R., Jung, D., Lynch, J. P., Wang, Y., Shi, D., and Flynn, M. P. (2005). “Design of a wireless sensor for scalable distributed in-network computation in a structural health monitoring system.” 5th Int. Workshop on Structural Health Monitoring (IWSHM), Structures and Composites Laboratory, Stanford, CA.
Swartz, R., Lynch, J., Sweetman, B., and Rolfes, R. (2010). “Structural monitoring of wind turbines using wireless sensor networks.” Smart Struct. Syst., 6(3), 183–196.
Trefethen, L. N., and Bau, D. I. (1997). “Computing the SVD.” Numerical linear algebra, Society for Industrial and Applied Mathematics, Philadelphia.
Van Overschee, P., and De Moor, B. (2012). Subspace identification for linear systems: Theory—Implementation—Applications, Springer Science and Business Media, New York.
Zhang, Y., Häckell, M., Lynch, J. P., and Rolfes, R. (2014). “Automated modal parameter extraction and statistical analysis of the New Carquinez bridge response to ambient excitations.” Model Validation Uncertainty Quantif., 3, 161–170.
Information & Authors
Information
Published In
Copyright
©2016 American Society of Civil Engineers.
History
Received: Jun 20, 2016
Accepted: Sep 19, 2016
Published online: Nov 28, 2016
Published in print: Apr 1, 2017
Discussion open until: Apr 28, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.