Instantaneous Stepwise-Steady CFD Model of BMP Response to Unsteady PM Loadings
Publication: Journal of Environmental Engineering
Volume 139, Issue 11
Abstract
In the last several years, computational fluid dynamics (CFD) has emerged as a potential tool to accurately predict the response of best management practices (BMPs) to highly unsteady rainfall-runoff (storm water) and particulate matter (PM) loadings. However, such predictive capability for BMPs as unit operation (UO) systems subject to highly unsteady loadings requires much higher computational time than for steady loadings. Therefore, to reduce computational time at a given level of predictive accuracy, an instantaneous response stepwise-steady method was tested to reproduce the unsteady load response of three geometrically different BMP UO systems. The units are baffled and screened hydrodynamic separator systems [(BHS) and (SHS)], respectively, as well as a granular media-based volumetric clarifying filter (VCF) system. The measured PM response was variable, a function of influent unsteadiness and the UO system geometry. Each hydrograph loading of a UO system was represented as a cumulative distribution function (CDF) which was discretized into a number of steady-flow steps using a discretization number (DN) for which an instantaneous response was modeled. DN was the model tuning parameter used to examine the stepwise-steady method. Despite variability in measured load-response for a UO system, a similar number of instantaneous response steady steps (DN of 35–40) were required to achieve a mean relative percent difference (RPD) of less than 10% between measured and modeled load response. For each UO system, the stepwise-steady method reduced computational time by an order of magnitude compared with a fully unsteady method.
Get full access to this article
View all available purchase options and get full access to this article.
References
ASTM. (1999). “Standard test method for determining sediment concentration in water samples. Annual book of standards.” Water Environ. Technol., 11(02), 389–394.
Barth, T. J., and Jespersen, D. (1989). “The design and application of upwind schemes on unstructured meshes.”, AIAA 27th Aerospace Sciences Meeting, Reno, NV.
Berretta, C., and Sansalone, J. (2012). “Fate of phosphorus fractions in an adsorptive-filter subject to intra- and inter-event runoff phenomena.” J. Environ. Manage., 103, 83–94.
Cho, H.-C., and Sansalone, J. (2013). “Physical modeling of particulate matter washout from a hydrodynamic separator.” J. Environ. Eng., 139(1), 11–22.
Dickenson, J. A., and Sansalone, J. J. (2009). “Discrete phase model representation of particulate matter (PM) for simulating PM separation by hydrodynamic unit operations.” Env. Sci. Technol., 43(21), 8220–8226.
Elgobashi, S. E. (1991). “Particle laden turbulent flow: Direct simulation and closure models.” Appl. Sci. Res., 48(3–4), 301–314.
Ergun, S. (1952). “Fluid flow through packed column” Chem. Eng. Prog., 48(2), 89–94.
Fluent v 12.0 (2009). [Computer software]. User’s Guide, Fluent Inc., Lebanon, NH, 2070.
Garofalo, G., and Sansalone, J. (2011). “Transient elution of particulate matter from hydrodynamic unit operations as a function of computational parameters and runoff hydrograph unsteadiness.” Chem. Eng. J., 175, 150–159.
Kim, J., Pathapati, S., Liu, B., and Sansalone, J. J. (2007). “Treatment and maintenance of stormwater hydrodynamic separators: A case study.” Proc. 9th Biennial Conf. on Stormwater Res. and Watershed Manage., CHI, Guelph, ON.
Kim, J.-Y., and Sansalone, J. J. (2008a). “Hydrodynamic separator of particulate matter transported by source area runoff.” J. Environ. Eng., 134(11), 912–922.
Kim, J.-Y., and Sansalone, J. J. (2008b). “Event-based size distributions of particulate matter transported during urban rainfall-runoff events.” Water Res., 42(10–11), 2756–2768.
Launder, B. E., and Spalding, D. E. (1974). “The numerical computation of turbulent flows.” Comput. Methods Appl. Mech. Eng., 3(2), 269–289.
Lee, J. H., and Bang, K. W. (2000). “Characterization of urban stormwater runoff.” Water Res., 34(6), 1773–1780.
Lee, J. H., Bang, L. W., Choi, C. S., and Lim, H. S. (2010). “CFD modeling of flow field and particle tracking in a hydrodynamic stormwater separator.” Water Sci. Technol., 62(10), 2381–2388.
Liang, D., Cheng, L., and Li, G. (2005). “Numerical modeling flow and scour below a pipeline in currents. Part II. Scour simulation.” Coastal Eng., 52(1), 43–62.
Liu, B., Berretta, C., Ying, G., and Sansalone, J. J. (2008). “Control of highway stormwater during event and interevent retention in best management practices.”, Transportation Research Board of the National Academies, Washington, DC, 115–122.
Morin, A., Figue, J. F., Schaffner, J., and Steinhardt, J. (2008). Int. Conf. on Urban Drainage, International Water Association (IWA), Delft, Netherlands.
Morsi, S. A., and Alexander, A. J. (1972). “An investigation of particle trajectories in two-phase flow systems.” J. Fluid Mech., 55(02), 193–208.
Pathapati, S., and Sansalone, J. J. (2009). “CFD modeling of a storm-water hydrodynamic separator.” J. Environ. Eng., 135(4), 191–202.
Pathapati, S., and Sansalone, J. J. (2011). Can a stepwise steady flow computational fluid dynamics model reproduce unsteady particulate matter separation for common unit operations?” Env. Sci. Technol., 45(13), 5605–5613.
Pathapati, S., and Sansalone, J. J. (2012). “Modeling particulate matter re-suspension and washout from urban drainage hydrodynamic separators.” J. Environ. Eng., 138(1), 90–100.
Qi, D., and Lin, W. (2006). “T-Grid: A new grid environment.” Proc., 1st Int. Multi-Symp. on Computer and Computational Sciences Conf. (IMSCCS’06), IEEE, Washington, DC, 611–618.
Ranade, V. V. (2002). Computational flow modeling for chemical reactor engineering, 1st Ed., Academic Press, London.
Sansalone, J. J., Liu, B., and Kim, J. Y. (2009). “Volumetric clarifying filtration of urban source area rainfall runoff.” J. Environ. Eng., 135(8), 609–620.
Sansalone, J. J., and Pathapati, S. (2009). “Particle dynamics of a hydrodynamic separator subject to transient rainfall-runoff.” Water Resour. Res., 45(9), 1–14, W09408.
Wang, H., Hondzo, M., Xu, C., Poole, V., and Spacie, A. (2003). “Dissolved oxygen dynamics of streams draining an urbanized and an agricultural catchment.” Ecol. Model., 160(1–2), 145–161.
Wilson, M. A., Mohseni, O., Gulliver, J. S., Hozalski, R. M., and Stefan, H. G. (2009). “Assessment of hydrodynamic separators for storm-water treatment.” J. Hydraul. Eng., 135(5), 383–392.
Wong, T. H. F. (1997). “Continuous deflective separation: its mechanism and applications.” Proc. 70th Water Environment Federation Annual Technical Exhibition and Conf. (WEFTEC), Water Environment Federation, Alexandria, VA, 703–714.
Information & Authors
Information
Published In
Journal of Environmental Engineering
Volume 139 • Issue 11 • November 2013
Pages: 1350 - 1360
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Nov 12, 2012
Accepted: Jul 3, 2013
Published online: Jul 5, 2013
Published in print: Nov 1, 2013
Discussion open until: Dec 5, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.