Building Environmentally and Economically Sustainable Transportation Infrastructure: Green Highway Rating System
Publication: Journal of Construction Engineering and Management
Volume 139, Issue 12
Abstract
A rating system is introduced that employs life-cycle analysis techniques to provide a quantitative assessment of the environmental and economic sustainability of highway designs. Energy consumption, greenhouse gas emissions, life-cycle cost, and other factors are considered. On the basis of the score received, a design is assigned a label commensurate with the level of sustainability achieved. Analysis of a pilot project shows that relatively modest changes in a highway pavement design, such as using recycled materials, results in significant environmental and economic benefits. The system can be used to motivate material recycling, resulting in more sustainable construction and growth.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Support for this study was provided by the Recycled Materials Resource Center. Dr. Pat Eagan of the University of Wisconsin-Madison, Mr. Gary Whited of the Wisconsin Construction and Materials Support Center, and Mr. Steve Krebs of Wisconsin Department of Transportation assisted in the study. The Wisconsin Department of Transportation provided input as a stakeholder. Mr. Charles Coulter of Lafarge North American provided source and cost data for fly ash.
References
American Association of State Highway, and Transportation Officials (AASHTO). (2008). “Primer on transportation and climate change.” 〈http://downloads.transportation.org/ClimateChange.pdf〉 (Feb. 16, 2009).
ASCE. (2007). “The vision for civil engineering in 2025.” The Summit on the Future of Civil Engineering, Reston, VA.
Bell, S., and Morse, S. (2008). Sustainability indicator: Measuring the immeasurable? Earthscan Publications, London.
Bull, J. W. (1993). “Life cycle costing for construction”, Chapman & Hall, London.
Carpenter, A. C., Gardner, K. H., Fopiano, J., Benson, C. H., and Edil, T. B. (2007). “Life cycle based risk assessment of recycled materials in roadway construction.” Waste Manage., 27(10), 1458–1464.
Dasgupta, S., and Tam, E. K. L. (2005). “Indicators and framework for assessing sustainable infrastructure.” Can. J. Civ. Eng., 32(1), 30–44.
Demich, G. (2010). “STEED-A transportation green scale for continuous improvement.” Proc., 1st T&DI Green Streets & Highway Conf, ASCE, Reston, VA.
Dreelin, E. A., Fowler, L., and Carroll, C. R. (2006). Managing stormwater in your community: A guide for building an effective post-construction program, Center for Watershed Protection, Ellicott City, MD.
Eagan, P., and Weinberg, L. (1999). “Application of analytic hierarchy process techniques to streamlined life-cycle analysis of two anodizing processes.” Environ. Sci. Technol., 33(9), 1495–1500.
Ebrahimi, A., Kootstra, B., Edil, T. B., and Benson, C. H. (2012). “Practical approach for designing flexible pavements using recycled roadway materials as base course.” Road Mater. Pavements Des., 13(4), 731–748.
Egan, S. J. (1998). Rethinking construction, Dept. of Trade and Industry, Westminster, UK.
Elkington, J. (1994). “Towards the sustainability corporation: Win-win-win business strategies for sustainability development.” Calif. Manage. Rev., 36(2), 90–100.
Federal Highway Administration (FHWA). (1998). Life-cycle cost analysis in pavement design—In search of better investment decision, Washington, DC.
Federal Highway Administration (FHWA). (2009). “RealCost version 2.5.2.” 〈http://www.fhwa.dot.gov/infrastructure/asstmgmt/lccasoft.cfm〉.
Federal Highway Administration (FHWA). (2004). “TNM version 2.5 look-up tables.” 〈http://www.fhwa.dot.gov/environment/noise/tnm/tn_ver25lu.htm〉 (Mar. 7, 2009).
Federal Highway Administration (FHWA). (2010). “Highway traffic noise.” 〈http://www.fhwa.dot.gov/environment/htnoise.htm〉 (Sep. 7, 2010).
Federal Highway Administration (FHWA). (2013). “Construction Noise.” 〈http://www.fhwa.dot.gov/environment/noise/construction_noise/〉 (May 20, 2013).
Gambatese, J. A. (2005). “Sustainable roadway construction: Energy consumption and material waste generation of roadways.” Proc., Construction Research Congress 183, ASCE, Reston, VA, 1–13.
Horvath, A. (2004). Pavement life-cycle assessment tool for environmental and economic effects (PaLATE) user manual, Recycled Materials Resource Center, Durham, NH.
Horvath, A., and Hendrickson, C. (1998). “Comparison of environmental implication of asphalt and steel-reinforced concrete pavements.”, Transportation Research Board, Washington, DC, 105–113.
Institute for Sustainable Infrastructure. (2012). “Envision checklist.” 〈http://www.sustainableinfrastructure.org/portal/envision2/checklist.cfm〉.
Kandhal, P. S. (2004). “Asphalt pavements mitigate tire/pavement noise.” Hot Mix Asphalt Technol., 9(2), 22–31.
Kelly, T. D. (2002). “Raw materials and technology fuel U.S. economic growth.” Min. Eng., 54, 17–21.
Kibert, C. J. (2002). “Policy instruments for a sustainable built environment.” J. Land Use Environ. Law, 17(2), 379–394.
Kirk, S. J., and Dell’isola, A. J. (1998). “Life cycle costing for design professionals”, McGraw-Hill, New York.
Knuth, D., and Fortmann, J. (2010). “The development of I-LAST Illinois—Livable and sustainable transportation.” Proc., 1st T&DI Green Streets and Highway Conf, ASCE, Reston, VA.
Lee, J. C., Edil, T. B., Tinjum, J. M., and Benson, C. H. (2010). “Quantitative assessment of environmental and economic benefits of using recycled construction materials in highway construction.”, Transportation Research Board, Washington, DC, 138–142.
R.S. Means (1995). “R.S. Means building construction cost data.” R.S. Means, Kingston, MA.
Mendler, F. S., and Odell, W. (2000). The HOK guidebook to sustainable design, Wiley, New York.
Minnesota Department of Transportation. (2006). “Impact of alternative stormwater management approaches on highway infrastructure: Guide for section of best management practices.”, Vol. 1, St. Paul, MN.
Muench, S. (2010). “About greenroads rating system.” Univ. of Washington 〈http://www.greenroads.us/347/about-the-greenroads-rating-system.html〉 (Nov. 19, 2010).
National Cooperative Highway Research Program (NCHRP). (2002). “Guidebook for assessing the social and economic effects of transportation projects.”, National Academy Press, Washington, DC.
National Cooperative Highway Research Program (NCHRP). (2006). “Mechanistic-empirical design of new and rehabilitated pavement structures.” 〈http://www.trb.org/mepdg/software.html〉 (Feb. 16, 2009).
New York State Department of Transportation. (2010). “NYSDOT sustainability & GreenLITES.” 〈https://www.nysdot.gov/programs/greenlites/repository/GreenLITES-sustainability-flyer-handout.pdf〉 (Nov. 19, 2010).
Parliament of the Commonwealth of Australia. (2011). Clean energy bill 2011(exposure draft), Canberra, Australia.
Piper, J. M. (2002). “CAE and sustainable development evidence from UK case studies.” Environ. Impact Assess. Rev., 22(1), 17–36.
Saaty, T. L. (1980). The analytical hierarchy process, McGraw-Hill, New York.
Schendler, A., and Udall, R. (2005). “LEED is broken, let’s fix it.” 〈http://www.igreenbuild.com/cd_1706.aspx〉 (Jul. 28, 2010).
Shepherd, G. (2010). “FHWA’s sustainable highways self-evaluation tool.” 〈http://www.transportation.org/sites/aashto/docs/FHWA%20Sustainable%20Highways%20Tool%20-%20AASHTO%2010-29-10%20v2%20(2)final.pdf〉 (Nov. 19, 2010).
Truitt, P. (2009). Potential for reducing greenhouse gas emission in the construction sector, U.S. Environmental Protection Agency, Washington, DC.
U.S. Census Bureau. (2006). “Annual demographic survey.” 〈http://pubdb3.census.gov/macro/032006/perinc/new03_028.htm〉 (Nov. 19, 2009).
U.S. Department of Energy (U.S. DOE). (2010). “Energy conservation program: Energy conservation standards for small electric motors final rule.” 〈http://www.federalregister.gov/articles/2010/03/09/2010-4358/energy-conservation-program-energy-conservation-standards-for-small-electric-motors〉 (Sep. 9, 2010).
U.S. Energy Information Administration. (2010). “International energy outlook 2010—Highlights.” 〈http://www.eia.doe.gov/oiaf/ieo/highlights.html〉 (Sep. 9, 2010).
U.S. Environmental Protection Agency. (2008). “Study on increasing the usage of recovered mineral components in cement and concrete projects.”, Washington, DC.
Wisconsin Department of Transportation. (2009). “2010 standard specifications.” 〈http://roadwaystandards.dot.wi.gov/standards/stndspec/index.htm〉 (Feb. 15, 2010).
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Sep 16, 2012
Accepted: May 21, 2013
Published online: May 23, 2013
Published in print: Dec 1, 2013
Discussion open until: Jan 27, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.