Damage Detection of Tension Pendulums in Cable-Stayed Bridges Using Structural Frequency Variance
Publication: Journal of Performance of Constructed Facilities
Volume 35, Issue 1
Abstract
Structural health monitoring represents an efficient way to diagnose the condition of cable-stayed bridges. Most studies assessing the condition of cable-stayed bridges and detecting damage to them have been developed to monitor the longitudinal performance of bridge bearings. However, few studies have aimed to detect the damage to tension pendulums, which are usually tie-down cables that resist girder uplift from auxiliary piers. This study aims to develop an effective method for detecting the damage of tension pendulums in cable-stayed bridges using structural modal frequencies. First, the sensitivity of the bridge frequency to tension pendulum damage is derived according to the Rayleigh method. Then, a finite-element simulation of a cable-stayed bridge is conducted to validate the rationality of the frequency index. Finally, a case study on tension pendulum damage is carried out for the cable-stayed Yonghe Bridge. The results indicate that the frequency change is far more sensitive to the damage of the tension pendulums than to the damage of the stay cables. The failure of tie-down cables will result in a substantial decrease in the bridge frequency, up to approximately 35% for the first vertical bending mode of the bridge. In practice, the damage of tension pendulums can be effectively detected by a sudden decrease in the measured frequency of cable-stayed bridges.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All the data, models, or code generated or used during the study are available from the corresponding author by request.
Acknowledgments
This research work was jointly supported by the National Natural Science Foundation of China (Grants Nos. 51625802, 51978128, and 51708088), the LiaoNing Revitalization Talents Program (Grant XLYC1802035), and the Foundation for High Level Talent Innovation Support Program of Dalian (Grant No. 2017RD03).
References
Ala, N., E. H. Power, and A. Azizinamini. 2016. “Predicting the service life of sliding surfaces in bridge bearings.” J. Bridge Eng. 21 (2): 04015035. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000767.
Brownjohn, J. M. W., K. Y. Koo, A. Scullion, and D. List. 2015. “Operational deformations in long-span bridges.” Struct. Infrastruct. Eng. 11 (4): 556–574. https://doi.org/10.1080/15732479.2014.951857.
Calvi, G. M., M. Moratti, G. J. O’Reilly, N. Scattarreggia, R. Monteiro, D. Malomo, P. M. Calvi, and R. Pinho. 2019. “Once upon a time in Italy: The tale of the Morandi Bridge.” Struct. Eng. Int. 29 (2): 198–217. https://doi.org/10.1080/10168664.2018.1558033.
Chen, C.-C., W.-H. Wu, F. Shih, and S.-W. Wang. 2014. “Scour evaluation for foundation of a cable-stayed bridge based on ambient vibration measurements of superstructure.” NDT & E. Int. 66 (Sep): 16–27. https://doi.org/10.1016/j.ndteint.2014.04.005.
Chen, Y., K. Chen, and J. Lv. 2011. “Analysis of construction control for rehabilitation of tension rocker bearings of subsidiary piers in PC cable-stayed bridge.” [In Chinese.] J. Highway Transp. Res. Dev. 28 (4): 79–83.
Clough, R. W., and J. Penzien. 1975. Dynamics of structures. New York: McGraw-Hill.
Fayyadh, M. M., and H. Abdul Razak. 2012. “Condition assessment of elastic bearing supports using vibration data.” Constr. Build. Mater. 30 (May): 616–628. https://doi.org/10.1016/j.conbuildmat.2011.12.043.
Guo, T., J. Liu, and L. Y. Huang. 2016. “Investigation and control of excessive cumulative girder movements of long-span steel suspension bridges.” Eng. Struct. 125 (Oct): 217–226. https://doi.org/10.1016/j.engstruct.2016.07.003.
Hoult, N. A., P. R. A. Fidler, P. G. Hill, and C. R. Middleton. 2010. “Long-term wireless structural health monitoring of the Ferriby Road Bridge.” J. Bridge Eng. 15 (2): 153–159. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000049.
Huang, P., and X. Liu. 2007. “Dynamic characteristics analysis of cable-stayed bridges with single tower under various boundary conditions.” Highway (8): 1–5.
Huang, X., and M. Lai. 2016. “Analysis on the tension pressure bearing disease of PC cable-stayed bridge.” J. Wuhan Inst. Shipbuild. Technol. (3): 21–23.
Kaloop, M. R., and J. W. Hu. 2015. “Stayed-cable bridge damage detection and localization based on accelerometer health monitoring measurements.” Shock Vib. 2015: 1–11. https://doi.org/10.1155/2015/102680.
Kromanis, R., P. Kripakaran, and B. Harvey. 2016. “Long-term structural health monitoring of the Cleddau bridge: Evaluation of quasi-static temperature effects on bearing movements.” Struct. Infrastruct. Eng. 12 (10): 1342–1355. https://doi.org/10.1080/15732479.2015.1117113.
Kuihua, M., S. Shengjiang, J. Guoqing, and S. Yamin. 2017. “Static and dynamic mechanical properties of long-span cable-stayed bridges using CFRP cables.” Adv. Civ. Eng. 2017 (4): 1–11. https://doi.org/10.1155/2017/6198296.
Lee, Y. J., S. H. Lee, and H. S. Lee. 2015. “Reliability assessment of tie-down cables for cable-stayed bridges subject to negative reactions: Case study.” J. Bridge Eng. 20 (10): 4014108. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000717.
Li, H. 2010. “Fracture cause analysis of tension rocker bearing cables at subsidiary piers in a prestressed concrete cable-stayed bridge.” Supplement, Eng. Mech. 27 (1): 210–215.
Li, H., S. Li, J. Ou, and H. Li. 2010. “Modal identification of bridges under varying environmental conditions: Temperature and wind effects.” Struct. Control Health 17 (5): 495–512. https://doi.org/10.1002/stc.319.
Li, S., H. Li, Y. Liu, C. Lan, W. Zhou, and J. Ou. 2014. “SMC structural health monitoring benchmark problem using monitored data from an actual cable-stayed bridge.” Struct. Control Health 21 (2): 156–172. https://doi.org/10.1002/stc.1559.
Malomo, D., N. Scattarreggia, A. Orgnoni, R. Pinho, M. Moratti, and G. M. Calvi. 2020. “Numerical study on the collapse of the Morandi Bridge.” J. Perform. Constr. Facil. 34 (4): 4020044. https://doi.org/10.1061/(ASCE)CF.1943-5509.0001428.
Miao, Y., and X. Guo. 2016. “Analysis of the influence of auxiliary piers to the coupled vibration of vehicle and long span cable-stayed bridge with hybrid girder.” J. Railway Sci. Eng. 13 (5): 876–881.
Ministry of Transport of the People’s Republic of China. 2007. Guidelines for design of highway cable-stayed bridge. JTG/T D65-01-2007. [In Chinese.] Beijing: China Communications Press.
Noade, B. M., and T. C. Becker. 2019. “Probabilistic framework for lifetime bridge-bearing demands.” J. Bridge Eng. 24 (7): 4019065. https://doi.org/10.1061/(ASCE)BE.1943-5592.0001430.
Svensson, H. 2012. Cable-stayed bridges. Weinheim, Germany: Wiley.
Swiggum, K. E., S. D. Anderson, and J. S. Russell. 1994. “Case study of Burlington cable-stayed bridge.” J. Constr. Eng. Manage. 120 (3): 649–666. https://doi.org/10.1061/(ASCE)0733-9364(1994)120:3(649).
Webb, G. T., P. J. Vardanega, P. R. A. Fidler, and C. R. Middleton. 2014. “Analysis of structural health monitoring data from Hammersmith flyover.” J. Bridge Eng. 19 (6): 5014003. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000587.
Wolff, M., and U. Starossek. 2009. “Cable loss and progressive collapse in cable-stayed bridges.” Bridge Struct. 5 (1): 17–28. https://doi.org/10.1080/15732480902775615.
Wu, G.-M., D.-H. Yang, T.-H. Yi, H.-N. Li, and H. Liu. 2020. “Sliding life prediction of sliding bearings using dynamic monitoring data of bridges.” Struct. Control Health 27 (5): e2515. https://doi.org/10.1002/stc.2515.
Xing, C., H. Wang, A. Li, and Y. Xu. 2014. “Study on wind-induced vibration control of a long-span cable-stayed bridge using TMD-type counterweight.” J. Bridge Eng. 19 (1): 141–148. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000500.
Xu, X., Q. Huang, Y. Ren, D.-Y. Zhao, J. Yang, and D.-Y. Zhang. 2019. “Modeling and separation of thermal effects from cable-stayed bridge response.” J. Bridge Eng. 24 (5): 4019028. https://doi.org/10.1061/(ASCE)BE.1943-5592.0001387.
Yang, X.-M., T.-H. Yi, C.-X. Qu, H.-N. Li, and H. Liu. 2019. “Automated eigensystem realization algorithm for operational modal identification of bridge structures.” J. Aerosp. Eng. 32 (2): 4018148. https://doi.org/10.1061/(ASCE)AS.1943-5525.0000984.
Zhou, Q. 2013. “The impact of auxiliary pier tension-compression bearing on cable-stayed bridge with unequal height pylons dynamic characteristics and seismic response.” [In Chinese.] Ph.D. dissertation, School of Civil Engineering and Architecture, Changsha Univ. of Science and Technology.
Zhu, J., W. Zhang, K. F. Zheng, and H. G. Li. 2016. “Seismic design of a long-span cable-stayed bridge with fluid viscous dampers.” Pract. Period. Struct. Des. Constr. 21 (1): 04015006. https://doi.org/10.1061/(ASCE)SC.1943-5576.0000262.
Information & Authors
Information
Published In
Copyright
© 2020 American Society of Civil Engineers.
History
Received: Mar 7, 2020
Accepted: Jul 27, 2020
Published online: Oct 24, 2020
Published in print: Feb 1, 2021
Discussion open until: Mar 24, 2021
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.