Effect of Water on the Degradation of Gypsum Plaster Coatings: Inspection, Diagnosis, and Repair
Publication: Journal of Performance of Constructed Facilities
Volume 26, Issue 4
Abstract
This paper presents an expert system designed to support the inspection and diagnosis of gypsum plaster coatings applied to partition walls and ceilings [interior gypsum plaster (IGP)]. It includes a classification of the defects that may affect IGP and their probable causes, the correlation matrices amongst defects and between defects and probable causes, and a classification of diagnostic methods and repair techniques suitable for each type of IGP defect. This inspection system was validated through standard IGP inspections undertaken on 119 walls or ceilings in 23 buildings located throughout Portugal. A statistical analysis of the results of the inspection is given that provides details on, in particular, the pathological problems related to the action of water on IGP because the presence of moisture within or on the surface of IGP coatings was shown to affect the severity of the problems of inspected samples. The characteristics and frequency of occurrence of dampness, biodeterioration, and efflorescence and cryptoflorescence are presented, together with the primary causes for their presence in the sample. The most suitable diagnostic methods, preventive measures, and repair solutions prescribed for these defects are also analyzed, in detail.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors gratefully acknowledge the support of the ICIST Research Institute, IST, Technical University of Lisbon, and of the Foundation for Science and Technology (FCT).
References
Arnold, A., and Zehnder, K. (1987). “Monitoring wall paintings affected by soluble salts.” The conservation of wall paintings, Cather, Sharon, ed., Symp. of the Courtauld Institute of Art and the Getty Conservation Institute, London, 103–135.
Cotrim, H., Veiga, R., and de Brito, J. (2008). “Freixo Palace: Rehabilitation of decorative gypsum plasters.” Constr. Build. Mater.CBUMEZ, 22(1), 41–49.
Derome, D., and Saneinejad, S. (2010). “Inward vapor diffusion due to high temperature gradients in experimentally tested large-scale wall assemblies.” Build. Environ.BUSCBC, 45(12), 2790–2797.
Dias, T. (2007). “Salt crystallization in plastered or rendered walls.” Ph.D. thesis, Instituto Superior Técnico, Technical Univ. of Lisbon, Lisbon, Portugal.
European Commission (EC). (2002). Directive 2002/91/EC of the European Parliament and of the Council of 16 December 2002 on the energy performance of buildings (EPBD), Brussels, Belgium.
Gaião, C., de Brito, J., and Silvestre, J. D. (2010a). “Inspection and diagnosis of gypsum plasterboard walls.” J. Perform. Constr. Facil.JPCFEV, 25(3), 172–180.
Gaião, C., de Brito, J., and Silvestre, J. D. (2010b). “Technical note: Gypsum plasterboard walls: Inspection, pathological characterization and statistical survey using an expert system.” Materiales de Construcción, in press,.
Goudie, A., and Viles, H. (1997). Salt weathering hazard, Wiley, Chichester, UK.
Henriques, F. (1992). “Action of moisture in walls: Types of defects quantification criteria and repair solutions.” Ph.D. thesis, Instituto Superior Técnico, Technical Univ. of Lisbon, Lisbon, Portugal (in Portuguese).
Kildeso, J., et al. (2003). “Determination of fungal spore release from wet building materials.” Indoor AirINAIE5, 13(2), 148–155.
National Gypsum (NG). (2008). “Veneer plaster systems.” 12th gypsum construction guide, Charlotte, NC.
Palha, F. (2008). “Technology and rehabilitation of gypsum plasters in partition walls.” M.S. thesis, Instituto Superior Técnico, Lisbon, Portugal (in Portuguese).
Pereira, A. (2008). “System for inspection and diagnosis of gypsum plasters in partition walls.” M.S. thesis, Instituto Superior Técnico, Lisbon, Portugal (in Portuguese).
Pereira, A., Palha, F., de Brito, J., and Silvestre, J. D. (2011). “Inspection and diagnosis system for gypsum plasters in partition walls and ceilings.” Constr. Build. Mater.CBUMEZ, 25(4), 2146–2156.
PetkovićJ., Huinink, H. P., Pel, L., Kopinga, K., and van Hees, R. P. J. (2010). “Moisture and salt transport in three-layer plaster/substrate systems.” Constr. Build. Mater.CBUMEZ, 24(1), 118–127.
Pühringer, J. (1983). “Salt disintegration, salt migration and degradation by salt—A hypothesis.” Document D15, Swedish Council for Building Research, Stockholm, Sweden.
Rodrigues, J., Gonçalves, T., Luxán, M., Vergès-Belmin, V., Wijffels, T., and Lubelli, B. (2005). “A proposal for classification of salt crystallisation behaviour of plasters and renders.” COMPASS End-Rep., Netherlands Organization for Applied Scientific Research (TNO), Delft, Netherlands.
Silveira, P., Veiga, R., and de Brito, J. (2007). “Gypsum coatings in ancient buildings.” Constr. Build. Mater.CBUMEZ, 21(1), 126–131.
Silvestre, J. D., and de Brito, J. (2009). “Ceramic tiling inspection system.” Constr. Build. Mater.CBUMEZ, 23(2), 653–668.
Vergès-Belmin, V., Wijffels, T., Gonçalves, T., and Nasraoui, M. (2005). “The compass salt crystallization test (compass-test) as way to figure out how salts migrate and accumulate in renovation plasters.” COMPASS End-Rep., Netherlands Organization for Applied Scientific Research (TNO), Delft, Netherlands.
World Health Organization (WHO). (2009). “Who guidelines for indoor air quality: Dampness and mold.” World Health Organization Regional Office for Europe, Copenhagen, Denmark, 〈www.euro.who.int/document/E92645.pdf〉 (Jan. 2011).
Information & Authors
Information
Published In
Copyright
© 2012. American Society of Civil Engineers.
History
Received: Feb 1, 2011
Accepted: Jun 14, 2011
Published online: Jun 16, 2011
Published in print: Aug 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.