Innovative Repair of Severely Corroded T-Beams Using Fabric-Reinforced Cementitious Matrix
Publication: Journal of Composites for Construction
Volume 20, Issue 3
Abstract
This paper offers an innovative technique for rehabilitation of severely corroded reinforced concrete (RC) T-beams using fabric-reinforced cementitious matrix (FRCM). Eight RC T-beam specimens were constructed and tested to failure under four-point load configuration. One beam was neither corroded nor repaired to act as a benchmark. Seven beams were presubjected to accelerated corrosion for 5 months that corresponded to an average tensile steel mass loss of 22%. Corrosion was restricted to the tensile steel located in the middle third of the beam span. Six corroded beams were repaired with either carbon or basalt FRCM system whereas one corroded beam was left unrepaired. The fabrics were internally embedded within the clear cover of the corroded-repaired region and/or externally bonded along the beam span. Corrosion damage significantly reduced the flexural capacity and ductility of the unrepaired beam. The basalt FRCM system could not restore the original flexural capacity of the beam whereas the carbon FRCM system fully restored the capacity. Doubling the amount of the internally embedded carbon FRCM layers slightly increased the strength gain but restored only 90% of the original beam ductility. The use of a combination of internally embedded and externally bonded carbon FRCM layers was more effective in improving the flexural response than the use of same amount of FRCM layers internally embedded within the corroded-repaired region.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to express their gratitude to the UAEU for financing this project under Grant No. 31N121.
References
ACI (American Concrete Institute). (2013). “Guide to design and construction of externally bonded fabric-reinforced cementitious matrix (FRCM) systems for repair and strengthening concrete and masonry structures.” ACI 549.4R-13, Farmington Hills, MI.
Almusallam, A., Al-Gahtani, A. S., Aziz, A. R., Dakhil, F., and Rasheeduzzafar (1996). “Effect of reinforcement corrosion on flexural behavior of concrete slabs.” J. Mater. Civ. Eng., 123–127.
ASTM. (2011). “Standard practice for preparing, cleaning, and evaluating corrosion test specimens.” ASTM-G1-03, West Conshohocken, PA.
Bonacci, J. F., and Maalej, M. (2000). “Externally bonded fiber-reinforced polymer for rehabilitation of corrosion damaged concrete beams.” ACI Struct. J., 97(5), 703–711.
D’Ambrisi, A., Feo, L., and Focacci, F. (2012). “Bond-slip relations for PBO-FRCM materials externally bonded to concrete.” Composites Part B, 43(8), 2938–2949.
D’Ambrisi, A., Feo, L., and Focacci, F. (2013). “Experimental analysis on bond between PBO-FRCM strengthening materials and concrete.” Composites Part B, 44(1), 524–532.
D’Ambrisi, A., and Focacci, F. (2011). “Flexural strengthening of RC beams with cement-based composites.” J. Compos. Constr., 707–720.
El Maaddawy, T., Soudki, K., and Topper, T. (2005). “Long-term performance of corrosion-damaged reinforced concrete beams.” ACI Struct. J., 102(5), 649–656.
El Maaddawy, T., Soudki, K., and Topper, T. (2007). “Performance evaluation of carbon fiber-reinforced polymer-repaired beams under corrosive environmental conditions.” ACI Struct. J., 104(1), 3–11.
El Maaddawy, T. A., and Soudki, K. A. (2005). “Carbon-fiber-reinforced polymer repair to extend service life of corroded reinforced concrete beams.” J. Compos. Constr., 187–194.
Elsanadedy, H. M., Almusallam, H. M., Alsayed, S. H., and Al-Salloum, Y. A. (2013). “Flexural strengthening of RC beams using textile reinforced mortar—Experimental and numerical study.” Compos. Struct., 97, 40–55.
Gencoglu, M., and Mobasher, B. (2007). “Monotonic and cyclic flexural behavior of plain concrete beams strengthened by fabric-cement based composites.” 3rd Int. Conf. on Structural Engineering, Mechanics and Computation (SEMC 2007), A. Zingoni, ed., IOS Press, Amsterdam, Netherlands, 1961–1966.
Hashemi, S., and Al-Mahaidi, R. (2010). “Investigation of bond strength and flexural behavior of FRP strengthened RC beams using cement-based adhesives.” Aust. J. Struct. Eng., 11(2), 129–139.
Hashemi, S., and Al-Mahaidi, R. (2012). “Flexural performance of CFRP textile-retrofitted RC beams using cement-based adhesives at high temperature.” Constr. Build. Mater., 28(1), 791–797.
Loreto, G., Leardini, L., Arboleda, D., and Nanni, A. (2014). “Performance of RC slab-type elements strengthened with fabric-reinforced cementitious-matrix composites.” J. Compos. Constr., A4013003.
Mangat, P. S., and Elgarf, M. S. (1999). “Flexural strength of concrete beams with corroding reinforcement.” ACI Struct. J., 96(1), 149–158.
Papanicolaou, C. G., Triantafillou, T. C., Papantoniou, I., and Balioukos, C. (2009). “Strengthening of two-way slabs with textile-reinforced mortars (TRM).” 11th Int. Fib Symp., The Concrete Society, Blackwater, Camberley, U.K.
Schladitz, F., Frenzel, M., Ehlig, D., and Curbach, M. (2012). “Bending load capacity of reinforced concrete slabs strengthened with textile reinforced concrete.” Eng. Struct., 40, 317–326.
Sneed, L. H., D’Antino, T., and Carloni, C. (2014). “Investigation of bond behavior of PBO fiber reinforced cementitious matrix composite-concrete interface.” ACI Mater J., 111(5), 569–580.
Triantafillou, T. C. (2007). “Textile-reinforced mortars (TRM) versus fiber-reinforced polymers (FRP) as strengthening and seismic retrofitting materials for reinforced concrete and masonry structures.” Int. Conf. on Advanced Composites in Construction (ACIC07), Univ. of Bath, Bath, U.K.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Jun 3, 2015
Accepted: Sep 16, 2015
Published online: Oct 29, 2015
Discussion open until: Mar 29, 2016
Published in print: Jun 1, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.