Intermediate Debonding Failure of RC Beams Retrofitted in Flexure with FRP: Experimental Results versus Prediction of Codes of Practice
Publication: Journal of Composites for Construction
Volume 16, Issue 2
Abstract
An experimental investigation has been conducted with the aim to investigate on the midspan debonding failure of reinforced concrete (RC) beams retrofitted in flexure by means of the application of a fiber-reinforced polymer (FRP) lamina externally applied to concrete substratum. Experimental tests on a series of RC beams with different geometries and type of internal steel reinforcing bars have been carried out in four-point bending up to failure to evaluate the influence of flexural/shear cracks on the debonding of FRP reinforcement from concrete substratum. It is widely known that the overall performance of a standard RC element is primarily influenced by the interaction between FRP and concrete substratum rather than by the strength of the FRP. The failure of such innovative retrofitting techniques may be attributed to an inadequate anchorage length; in other cases, when the FRP is correctly applied at the ends of beam, debonding starts in the vicinity of cracks and propagates toward the supports. The results of the experimental tests are used to investigate on the effectiveness of design procedures currently recommended for such debonding failure mode by the codes of practice. The results of the analytical calculations based on such models are presented in this paper and will provide an element of comparison and discussion with the experimental results. The codes of practice propose different analytical models based on the extensive research done in the last two decades, which involve different types of approximation and often yield quite different results.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work has been conducted within the research project “New cohesive-zone models and solution algorithms for the numerical analysis of delamination and decohesion problem” funded by Regione Campania (legge 5/2002). The authors wish to thank Clarem s.r.l., in particular, its managing director, Geom. Francesco Cervaso, for providing and applying the FRP reinforcement and Calcestruzzi Capuano s.a.s., in particular, Ing. Massimo Capuano, for providing and casting the concrete. The technical assistance of both of them was greatly appreciated.
References
American Concrete Institute (ACI). (2008). “Guide for the design and construction of externally bonded FRP systems for strengthening concrete structures.” ACI 440 2R-08, Farmington Hills, MI.
Buyukozturk, O., and Hearing, B. (1998). “Failure behaviour of precracked concrete beams retrofitted with FRP.” J. Compos. Constr.JCCOF2, 2(3), 138–144.
CEB. (1985). “Design manual on cracking and deformations.” Comitè Euro-International du Bèton.
Chen, J. F., Yuan, H., and Teng, J. G. (2007). “Debonding failure along a softening FRP-to-concrete interface between two adjacent cracks in concrete members.” Eng. Struct.ENSTDF, 29(2), 259–270.
Consiglio Nazionale delle Ricerche(CNR), Rome (in Italian). (2004). “Istruzioni per la progettazione, l’esecuzione e il controllo di interventi di consolidamento statico mediante l’utilizzo di compositi fibrorinforzati.” CNR DT-200.
Eshwar, N., Nanni, A., and Ibell, T. J. (2008). “Performance of two-anchor systems of externally bonded fiber-reinforced polymer laminates.” ACI Mater. J.AMAJEF, 105(1), 72–80.
fib: bulletin International Federation for Structural Concrete (fib). (2001). “Externally bonded FRP reinforcement for RC structures.” Bulletin No. 14, Lausanne, Switzerland.
Grace, N. F., Abdel-Sayed, G., and Ragheb, W. F. (2002). “Strengthening of concrete beams using innovative ductile fiber-reinforced polymer fabric” ACI Struct. J., 99(5), 692–700.
Japan Society of Civil Engineers (JSCE). (2001). “Recommendations for upgrading of concrete structures with use of continuous fiber sheets.” Concrete Engineering Series 41, Tokyo.
Li, V. C., and Wang, S. (2002). “Flexural behaviors of glass fiber-reinforced polymers (GFRP) reinforced engineered cementitious composite beams.” ACI Mater. J.AMAJEF, 99(1), 11–21.
Lu, X. Z., Teng, J. G., and Jiang, J. J. (2005). “Bond-slip models for FRP sheets/plates bonded to concrete.” Eng. Struct.ENSTDF, 27(6), 920–937.
Matthys, S. (2000). “Structural behaviour and design of concrete members strengthened with externally bonded FRP reinforcement.” Doctoral thesis, Ghent Univ., Belgium.
Niedermeier, R. (2000). “Zugkraftdeckung bei klebearnierten bauteilen (Envelope line of tensile forces while using externally bonded reinforcement).” Doctoral thesis, TU München, Germany.
Rahimi, H., and Hutchinson, A. (2001). “Concrete beams strengthened with externally bonded FRP plates.” J. Compos. Constr.JCCOF2, 5(1), 44–56.
Said, H., and Wu, Z. (2008). “Evaluating and proposing models of predicting IC debonding.” J. Struct. Eng.JSENEI, 12(3), 284–299.
Sebastian, W. M. (2001). “Significance of mid-span debonding failure in FRP-plated concrete beams.” J. Struct. Eng.JSENDH, 127(7), 792–798.
Smith, S. T., and Teng, J. G. (2002). “FRP-strengthened RC beams. Part II: Assessment of debonding strength models.” Eng. Struct.ENSTDF, 24(4), 397–417.
Teng, J. G., Chen, J. F., Smith, S. T., and Lam, L. (2002). “FRP strengthened RC structures.” Wiley, Chichester, UK, 36–43.
Teng, J. G., Smith, S. T., Yao, J., and Chen, J. F. (2003). “Intermediate crack-induced debonding in RC beams and slabs.” Constr. Build. Mater.CBUMEZ, 17(6–7), 447–462.
Teng, J. G., Yuan, H., and Chen, J. F. (2006). “FRP-to-concrete interfaces between two adjacent cracks: Theoretical model for debonding failure.” Int. J. Solids Struct.IJSOAD, 43(18–19), 5750–5778.
Wang, W., and Li, G. (2006). “Experimental study and analysis of RC beams strengthened with CFRP laminates under sustaining load.” Int. J. Solids Struct.IJSOAD, 43(6), 1372–1387.
Yang, J., Teng, J. G., and Chen, J. F. (2004). “Interfacial stresses in soffit-plated reinforced concrete beams.” Proc. Inst. Civ. Eng. Struct. Build., 157(1), 77–89.
Yu, P., Silva, P. F., and Nanni, A. (2008). “Flexural strength of reinforced concrete beams strengthened with prestressed carbon fiber-reinforced polymer sheets—Part II.” ACI Struct. J., 105(1), 11–20.
Zeris, C., Anastasakis, J., and Kyriakidis, J. (2009). “Investigation of monotonic and cyclic response of fiber-reinforced polymer strengthened beams.” ACI Struct. J., 106(1), 3–13.
Information & Authors
Information
Published In
Journal of Composites for Construction
Volume 16 • Issue 2 • April 2012
Pages: 185 - 195
Copyright
© 2012. American Society of Civil Engineers.
History
Received: Mar 22, 2011
Accepted: Aug 15, 2011
Published online: Aug 17, 2011
Published in print: Apr 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.