Damage Detection of FRP-Strengthened Concrete Structures Using Capacitance Measurements
Publication: Journal of Composites for Construction
Volume 13, Issue 6
Abstract
In this study, a new concept for detecting air voids, water intrusion, and glue infiltration damages in fiber-reinforced polymers (FRPs)-strengthened concrete structures was developed. The concept, based on detecting the local dielectric permittivity variations, was employed to design coplanar capacitance sensors (CCSs) to detect such defects. An analytical model was used to introduce the sensor operation theory and analyze the influence of different sensor parameters on the output signals and to optimize sensor design. Two dimensional finite element (FE) simulations were performed to assess the validity of the analytical results and to evaluate other sensor design-related parameters. To experimentally verify the FE model, dielectric properties of various materials involved in FRP-strengthened concrete systems were measured. In addition, two concrete specimens strengthened with FRP laminates and containing preinduced defects were constructed and inspected in a laboratory setting. Good agreement was found between experimental capacitance measurements and those predicated by the FE simulations. The proposed CCS design, coupled with commercially available portable capacitance meters, would facilitate field implementation of the proposed technique for rapid inspection of FRP-strengthened concrete structures without the need for sophisticated data analyses usually required by other more expensive and time consuming methods.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This study forms a part of an ongoing research program in McMaster University, Centre for Effective Design of structures (CEDS), funded through the UNSPECIFIEDOntario Research and Development Challenge (ORDC) Fund, a program of the Ministry of Research and Innovation (MRI). This research falls under CEDS Focus Area III: Structural Rehabilitation. The financial support of the Centre is greatly appreciated. The writers would like to acknowledge the assistance of Edward Fyfe and Sarah Witt, Fyfe Co. LLC, California, for providing the composite materials.
References
Carlsson, E., and Gevorgian, S. (1999). “Conformal mapping of the field and charge distributions in multilayered substrate CPWs.” IEEE Trans. Microwaves Theory Tech., 47(8), 1544–1552.
Chang, F. H., Couchman, J. C., Eisenmann, J. R., and Yee, B. G. W. (1975). “Application of a special x-ray nondestructive testing technique for monitoring damage zone growth in composite laminates.” ASTM Spec. Tech. Publ., American Society for Testing and Materials, Philadelphia, Pa., 176–190.
Gevorgian, S., Berg, H., Jacobsson, H., and Lewin, T. (2003). “Basic parameters of coplanar-strip waveguides on multilayer dielectric/semiconductor substrates. Part 2: Low permittivity superstrates.” IEEE Microw. Mag., 4(3), 59–78.
Hillger, W., Ahrholdt, M., Rohling, H., and Henrich, R. (2004). “Non-contact ultrasonic imaging techniques for composite components.” Proc., 16th World Conf. on Nondestructive Testing, Montréal, Canada.
Jama, H. A., Hussein, E. M. A., and Lee-Sullivan, P. (1998). “Detection of debonding in composite-aluminum joints using gamma-ray Compton scattering.” NDT Int., 31(2), 99–103.
Krishnapillai, M., Jones, R., Marshall, I. H., Bannister, M., and Rajic, N. (2005). “Thermography as a tool for damage assessment.” Compos. Struct., 67(2), 149–155.
Kyung Suk, O., Kuznetsov, D., and Schutt-Aine, J. E. (1994). “Capacitance computations in a multilayered dielectric medium using closed-form spatial Green’s functions.” IEEE Trans. Microwave Theor. Tech., 42(8), 1443–1453.
Li, X. B., Larson, S. D., Zyuzin, A. S., and Mamishev, A. V. (2004). “Design of multichannel fringing electric field sensors for imaging. Part I. General design principles.” Proc., IEEE Int. Symp. on Electrical Insulation, 406–409.
Maxwell 2D. (2003). Ansoft Corporation V.10, Pittsburgh, Pa.
Mouritz, A. P., Townsend, C., and Shah Khan, M. Z. (2000). “Non-destructive detection of fatigue damage in thick composites by pulse-echo ultrasonics.” Compos. Sci. Technol., 60(1), 23–32.
Schinzinger, R., and Laura, P. (1991). Conformal mapping: Methods and applications, Elsevier, New York.
Starnes, M. A., Carino, N. J., and Kausel, E. A. (2003). “Preliminary thermography studies for quality control of concrete structures strengthened with fiber-reinforced polymer composites.” J. Mater. Civ. Eng., 15(3), 266–273.
Ulaby, F. T. (2005). Electromagnetics for engineers, Prentice-Hall, Upper Saddle River, N.J.
Vendik, O. G., Zubko, S. P., and Nikol’skii, M. A. (1999). “Modeling and calculation of the capacitance of a planar capacitor containing a ferroelectric thin film.” Tech. Phys., 44(4), 349–355.
Ying, Z., Zhuo, L., and Weiping, S. (2007). “Fast capacitance extraction in multilayer, conformal and embedded dielectric using hybrid boundary element method.” Proc., Design Automation Conf. DAC ’07. 44th ACM/IEEE, San Dieego, Calif., 835–840.
Zhu, H., Liu, S., and Hong, W. (2006). “Nonoverlapping domain decomposition method for the capacitance extraction of multilayered multiconductor transmission lines.” Microwave Opt. Technol. Lett., 48(4), 794–798.
Information & Authors
Information
Published In
Journal of Composites for Construction
Volume 13 • Issue 6 • December 2009
Pages: 486 - 497
Copyright
© 2009 ASCE.
History
Received: Jul 25, 2008
Accepted: Mar 26, 2009
Published online: Apr 20, 2009
Published in print: Dec 2009
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.