Shear Properties of Tapered Box Girders with Steel Trapezoidally Corrugated Webs Considering Resal Effect
Publication: Journal of Bridge Engineering
Volume 25, Issue 1
Abstract
A study on the shear properties of tapered box girders with steel trapezoidally corrugated webs (STCWs) considering the Resal effect was carried out based on theoretical analysis, experimental testing, and numerical simulation. This study verifies the Resal effect in tapered box girders with STCWs, which is the dominant factor that contributes to the significant differences in mechanical properties between prismatic and tapered box girders with STCWs. This paper points out that it is too conservative to accept that STCWs carry the entire vertical shear force in tapered box girders because a considerable percentage of the shear force is resisted by the inclined concrete slabs, which cannot be ignored especially in regions of large bending moments. Through analysis of a linearly tapered cantilever box girder with a single vertical force acting at the unrestrained end, the study found that the average shear stress of the STCWs decreases from the unrestrained end to the cantilever’s supported end, which is different from the case of prismatic members. Also, it was found that the root section near the support is not the most unfavorable position for the shear design of STCWs. Accordingly, the traditional method and assumptions for determining the shear stress of a prismatic beam with STCWs will cause considerable errors when applied to tapered members. Thus, a simple and effective equation for determining the shear stress of tapered girders with STCWs is suggested that considers the Resal effect. The correctness of the proposed equation was verified by comparing the theoretical predictions with both experimental data and finite-element simulation.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All data, models, and code generated or used during the study appear in the submitted article.
Acknowledgments
The experiment was conducted at the Key Laboratory of Large-Span Bridge Health Inspection and Diagnosis Technology at the Jiangsu Transportation Research Institute. The authors wish to thank Professor Jiandong Zhang and Dr Wenqin Deng for their valuable suggestions on experiment design. The research presented is a part of study conducted under Grant No. 51808559 from the National Natural Science Foundation of China and Grant No. 2019JJ50770 from the Natural Science Foundation of Hunan Province. The financial support of these institutions is appreciated. Any findings, opinions, conclusions, or recommendations expressed here are those of the authors and not necessarily those of the sponsors.
References
Barakat, S., A. Mansouri, and S. Altoubat. 2015. “Shear strength of steel beams with trapezoidal corrugated webs using regression analysis.” Steel Compos. Struct. 18 (3): 757–773. https://doi.org/10.12989/scs.2015.18.3.757.
Chen, X. C., M. Pandey, Z. Z. Bai, and F. T. K. Au. 2017. “Long-term behavior of prestressed concrete bridges with corrugated steel webs.” J. Bridge Eng. 22 (8): 04017040. https://doi.org/10.1061/(ASCE)BE.1943-5592.0001074.
Chinese Standard. 2010. Standard for evaluation of concrete compressive strength. GB/T 50107-2010. Beijing: China Architecture & Building Press.
Deng, Y., M. Zhou, M. Hassanein, J. Zhang, D. Liu, and L. An. 2018. “Growth of prestressed concrete bridges with corrugated steel webs in China.” Proc. Inst. Civ. Eng. Civ. Eng. 171 (2): 77–84. https://doi.org/10.1680/jcien.17.00045.
Driver, R., H. Abbas, and R. Sause. 2006. “Shear behavior of corrugated web bridge girders.” J. Struct. Eng. 132 (2): 195–203. https://doi.org/10.1061/(ASCE)0733-9445(2006)132:2(195).
Elgaaly, M., R. Hamilton, and A. Seshadri. 1996. “Shear strength of beams with corrugated webs.” J. Struct. Eng. 122 (4): 390–398. https://doi.org/10.1061/(ASCE)0733-9445(1996)122:4(390).
Hamilton, R. 1993. “Behavior of welded girders with corrugated webs.” Ph.D. thesis, Dept. of Civil Engineering, Univ. of Maine.
Hassanein, M., and O. Kharoob. 2013. “Behavior of bridge girders with corrugated webs: (I) Real boundary conditions at the juncture of the web and flanges.” Eng. Struct. 57 (2): 554–564. https://doi.org/10.1016/j.engstruct.2013.03.004.
Hassanein, M., and O. Kharoob. 2014. “Shear buckling behavior of tapered bridge girders with steel corrugated webs.” Eng. Struct. 74 (Sep): 157–169. https://doi.org/10.1016/j.engstruct.2014.05.021.
Hassanein, M., and O. Kharoob. 2015. “Linearly tapered bridge girder panels with steel corrugated webs near intermediate supports of continuous bridges.” Thin Walled Struct. 88 (Mar): 119–128. https://doi.org/10.1016/j.tws.2014.11.021.
Jiang, R., F. Au, and Y. Xiao. 2014. “Prestressed concrete girder bridges with corrugated steel webs: A review.” J. Struct. Eng. 141 (2): 1–8. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001040.
Kadotani, T., K. Aoki, K. Ashizuka, T. Mori, M. Tomimoto, and M. Kano. 2002. “Shear buckling behavior of prestressed concrete girders with corrugated steel webs.” In Proc., 1st fib Congress: Concrete Structures in the 21st Century, 269–276. Tokyo: Japan Concrete Institute.
Kim, K., D. Lee, S. Choi, Y. Choi, and S. Jung. 2011. “Flexural behavior of prestressed composite beams with corrugated web: Part I, development and analysis.” Composites Part B 42 (6): 1603–1616. https://doi.org/10.1016/j.compositesb.2011.04.020.
Li, Z., M. Dong, and B. Cui. 2012. “Calculation of shear stress for corrugated steel webs by considering concrete shear capability and erect of variable cross section.” [In Chinese.] China J. Civ. Eng. 45 (2): 85–89.
Libby, J. R. 1990. Modern prestressed concrete: Design principles and construction methods, 222–223. London: Taylor & Francis.
Moon, J., J. Yi, B. Choi, and H. Lee. 2009. “Shear strength and design of trapezoidally corrugated steel webs.” J. Constr. Steel Res. 65 (5): 1198–1205. https://doi.org/10.1016/j.jcsr.2008.07.018.
Nie, J., L. Zhu, M. Tao, and L. Tang. 2013. “Shear strength of trapezoidal corrugated steel webs.” J. Constr. Steel Res. 85 (6): 105–115. https://doi.org/10.1016/j.jcsr.2013.02.012.
Rosignoli, M. 1999. “Prestressed concrete box girder bridges with folded steel plate webs.” Inst. Civ. Eng. Struct. Build. 134: 77–85.
Sause, R., and T. Braxtan. 2011. “Shear strength of trapezoidal corrugated steel webs.” J. Constr. Steel Res. 67 (2): 223–236. https://doi.org/10.1016/j.jcsr.2010.08.004.
Sayed-Ahmed, E. 2001. “Behaviour of steel and (or) composite girders with corrugated steel webs.” Can. J. Civ. Eng. 28 (4): 656–672. https://doi.org/10.1139/l01-027.
Shiratani, H., K. Sakashita, H. Obi, and S. Fujikura. 2002. “Behavior of corrugated steel web girder around middle support.” In Proc., 1st fib Congress: Concrete structures in the 21st Century, 261–268. Tokyo: Japan Concrete Institute.
Shitou, K., A. Nakazono, and N. Suzuki. 2008. “Experimental research on shear behavior of corrugated steel web bridge.” J. Jpn. Soc. Civ. Eng. 64 (2): 223–234. https://doi.org/10.2208/jsceja.64.223.
Yi, J., H. Gil, K. Youm, and H. Lee. 2008. “Interactive shear buckling behavior of trapezoidally corrugated steel webs.” Eng. Struct. 30 (6): 1659–1666. https://doi.org/10.1016/j.engstruct.2007.11.009.
Zevallos, E., M. Hassanein, E. Real, and E. Mirambell. 2016. “Shear evaluation of tapered bridge girder panels with steel corrugated webs near the supports of continuous bridges.” Eng. Struct. 113 (Apr): 149–159. https://doi.org/10.1016/j.engstruct.2016.01.030.
Zhang, B. S., W. Z. Chen, and J. Xu. 2018. “Mechanical behavior of prefabricated composite box girders with corrugated steel webs under static loads.” J. Bridge Eng. 23 (10): 04018077. https://doi.org/10.1061/(ASCE)BE.1943-5592.0001290.
Zhou, M., D. Yang, J. Zhang, and L. An. 2017. “Stress analysis of linear elastic tapered beams with corrugated steel webs.” J. Bridge Eng. 22 (6): 04017012. https://doi.org/10.1061/(ASCE)BE.1943-5592.0001042.
Zhou, M., J. Zhang, J. Zhong, and Y. Zhao. 2016. “Shear stress calculation and distribution in variable cross sections of box girders with corrugated steel webs.” J. Struct. Eng. 142 (6): 04016022. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001477.
Information & Authors
Information
Published In
Copyright
©2019 American Society of Civil Engineers.
History
Received: Apr 22, 2019
Accepted: Aug 22, 2019
Published online: Oct 23, 2019
Published in print: Jan 1, 2020
Discussion open until: Mar 23, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.