Experimental Study on the Dynamic Impacts of Service Train Loads on a Corrugated Steel Plate Culvert
Publication: Journal of Bridge Engineering
Volume 18, Issue 4
Abstract
The technical note presents the results and conclusions of the field tests under service loads that were conducted on a corrugated steel plate (CSP) railway culvert. On the basis of the measured displacements, use of the frequency domain decomposition method determined the frequencies of this culvert. Interferometric radar was used to monitor displacements of this culvert. The comparison between dynamic coefficients, received from three bridge standards and the experimental dynamic amplification factor (DAF), is also presented. The DAFs from tests were in the range of 1.10–1.375. The frequencies of the CSP culvert, caused by kinematic excitations, did not exceed 5.5 Hz. In turn, the maximum displacements of the CSP railway culvert ranged from to . Conclusions drawn from the tests can be helpful in the assessment of the dynamic behavior of such CSP culverts.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research project is funded by the Opole University of Technology. The author thanks W. Anigacz, A. Balut, K. Drozdzol, and R. Kocierz for excellent work during the tests.
References
Arockiasamy, M., Chaallal, O., and Limpeteeprakarn, T. (2006). “Full-scale field tests on flexible pipes under live load application.” J. Perform. Constr. Facil., 20(1), 21–27.
Bakht, B., and Pinjarkar, S. G. (1989). “Review of dynamic testing of highway bridges.” Rep. SRR-89-01, Ministry of Transportation of Ontario, Downsview, ON, Canada.
Bayoglu Flener, E. B. (2010). “Testing the response of box-type soil-steel structures under static service loads.” J. Bridge Eng., 15(1), 90–97.
Bayoğlu Flener, E. B., and Karoumi, R. (2009). “Dynamic testing of a soil-steel composite railway bridge.” Eng. Struct., 31(12), 2803–2811.
Bayoğlu Flener, E. B., Karoumi, R., and Sundquist, H. (2005). “Field testing of a long-span arch steel culvert during backfilling and in service.” J. Struct. Infrastruct. Eng., 1(3), 181–188.
Beben, D. (2005). “Soil-structure interaction in bridges made from steel corrugated plates.” Ph.D. thesis, Faculty of Civil Engineering, Opole Univ. of Technology, Opole, Poland.
Beben, D. (2011). “Application of the interferometric radar for dynamic tests of corrugated steel plate (CSP) culvert.” NDT Int., 44(5), 405–412.
Beben, D., and Manko, Z. (2010). “Dynamic testing of a soil-steel bridge.” Struct. Eng. Mech., 35(3), 301–314.
Brachman, R. W. I., Elshimi, T. M., Mak, A. C., and Moore, I. D. (2012). “Testing and analysis of a deep-corrugated large-span box culvert prior to burial.” J. Bridge Eng., 17(1), 81–88.
Brincker, R., Andersen, P., and Zhang, L. (2000). “Modal identification from ambient responses using frequency domain decomposition.” Proc., 18th Int., Modal Analysis Conf., Society for Experimental Mechanics, Bethel, CT, 625–630.
British Standards Institution (BSI). (2006). “Steel, concrete and composite bridges. Part 2: Specification for loads.” British Standard BS 5400-2, London.
BV Bro. (2006). “The Swedish rail administration: Design standard for railway bridges.” Standard BUS 583.10, Banverket (Swedish Rail Administration), Borlänge, Sweden.
Dei, D., Pieraccini, M., Fratini, M., Atzeni, C., and Bartoli, G. (2009). “Detection of vertical bending and torsional movements of a bridge using a coherent radar.” NDT Int., 42(8), 741–747.
European Committee for Standardization (CEN). (2002). “Actions on Structures—Part 2: Traffic loads on bridges.” Eurocode 1, Brussels, Belgium.
Gentile, C. (2010). “Deflection measurement on vibrating stay cables by non-contact microwave interferometer.” NDT Int., 43(3), 231–240.
Manko, Z., and Beben, D. (2005). “Static load tests of a road bridge with a flexible structure made from Super Cor type steel corrugated plates.” J. Bridge Eng., 10(5), 604–621.
Manko, Z., and Beben, D. (2008). “Dynamic testing of a corrugated steel arch bridge.” Can. J. Civ. Eng., 35(3), 246–257.
McLean, D. I., and Marsh, M. L. (1998). “Dynamic impact factors for bridges.” NCHRP Synthesis 266, National Cooperative Highway Research Program, Transportation Research Board, National Research Council, Washington, DC.
Paultre, P., Chaallal, O., and Proulx, J. (1992). “Bridge dynamics and dynamics amplification factors—A review of analytical and experimental findings.” Can. J. Civ. Eng., 19(2), 260–278.
Pieraccini, M., Parrini, F., Fratini, M., Atzeni, C., Spinelli, P., and Micheloni, M. (2007). “Static and dynamic testing of bridges through microwave interferometry.” NDT Int., 40(3), 208–214.
Union Internationale des Chemins de Fer (UIC). (1979). “Loads to be considered in the design of railway bridges.” UIC 776-1R, International Union of Railways, Paris.
Yeau, K. Y., Sezen, H., and Fox, P. J. (2009). “Load performance of in situ corrugated steel highway culverts.” J. Perform. Constr. Facil., 23(1), 32–39.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Jul 19, 2011
Accepted: Mar 19, 2012
Published online: Mar 21, 2012
Published in print: Apr 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.