Seismic Behavior of High-Strength Concrete Columns Confined by Fiber-Reinforced Polymer Tubes
Publication: Journal of Composites for Construction
Volume 10, Issue 6
Abstract
The use of high-strength concrete (HSC) in seismically active regions poses a major concern because of the brittle nature of material. The confinement requirements for HSC columns may be prohibitively stringent when ordinary grade transverse steel reinforcement is used. An alternative to conventional confinement reinforcement is the use of fiber-reinforced polymer (FRP) tubes in the form of stay-in-place formwork which can fulfill multiple functions of: (1) formwork; (2) confinement reinforcement; and (3) protective shell against corrosion, weathering and chemical attacks. The use of stay-in-place FRP formwork is investigated as concrete confinement reinforcement for HSC and normal strength concrete (NSC) columns with circular cross sections. Large-scale specimens with circular cross-sections and different concrete strengths were tested under constant axial compression and incrementally increasing lateral deformation reversals. FRP tubes were manufactured from carbon fiber sheets and epoxy resin. The results indicate that inelastic deformability of HSC and NSC columns can be improved significantly by using FRP tubes, beyond the performance level usually expected of comparable columns confined with conventional steel reinforcement.
Get full access to this article
View all available purchase options and get full access to this article.
References
American Concrete Institute (ACI). (2002). “Design and construction of externally bonded FRP systems for strengthening concrete structures (440.2R-02).” Committee 440, Detroit.
American Concrete Institute (ACI). (2005). “Building code requirements for structural concrete (ACI 318-05) and commentary (318R-05).” Committee 318, Farmington Hills, Mich.
Buckle, I. G., and Friedland, I. M. (1994). “Seismic retrofitting manual for highway bridges.” Rep. No. FHWA-94-052, U.S. Department of Transportation, Washington, D.C.
Canadian Standards Association (CSA). (2002). “Design and construction of building components with fibre-reinforced polymers (S806-02).” Committee S806, Rexdale Ont., Canada.
Davol, A., Burgueño, R., and Seible, F. (2001). “Flexural behavior of circular concrete filled FRP shells.” J. Struct. Eng., 127(7), 810–817.
Fam, A., Flisak, B., and Rizkalla, S. (2003). “Experimental and analytical modeling of concrete-filled FRP tubes subjected to combined bending and axial loads.” ACI Struct. J., 100(4), 499–509.
Fam, A., Mandal, S., and Rizkalla, S. (2005). “Rectangular filament-wound glass fiber-reinforced polymer tubes filled with concrete under flexural and axial loading: Experimental investigation.” J. Compos. Constr., 9(1), 25–33.
Fam, A., and Rizkalla, S. (2002). “Flexural behavior of concrete-filled fiber-reinforced polymer circular tubes.” J. Compos. Constr., 6(2), 123–132.
Iacobucci, R. D., Sheikh, S. A., and Bayrak, O. (2002). “Retrofit of square concrete columns with carbon fiber-reinforced polymer for seismic resistance.” ACI Struct. J., 100(6), 785–794.
Lam, L., and Teng, J. G. (2002). “Strength models for fiber-reinforced plastic-confined concrete.” J. Struct. Eng., 128(5), 612–623.
Lam, L., and Teng, J. G. (2003). “Design-oriented stress-strain model for FRP-confined concrete.” Constr. Build. Mater., 17(6 and 7), 471–489.
Mander, J. B., Priestley, M. J. N., and Park, R. (1988). “Theoretical stress-strain model for confined concrete.” J. Struct. Eng., 114(8), 1804–1826.
Mirmiran, A., and Shahawy, M. (1997). “Behavior of concrete columns confined by fiber composites.” J. Struct. Eng., 123(5), 583–590.
Mirmiran, A., Shahawy, M., El Khoury, C., and Naguib, W. (2000). “Large beam-column tests on concrete-filled composite tubes.” ACI Struct. J., 97(2), 268–276.
Mirmiran, A., Shahawy, M., and Samaan, M. (1999). “Strength and ductility of hybrid FRP-concrete beam columns.” J. Struct. Eng., 125(10), 1085–1093.
Miyauchi, K., Nishibayashi, S., and Inoue, S. (1997). “Estimation of strengthening effects with carbon fiber sheet for concrete column.” Proc., Nonmetallic (FRP) Reinforcement for Concrete Structures, Sapporo, Japan, Vol. 1, 217–223.
Moran, D. A., and Pantelides, C. P. (2002). “Stress-strain model for fiber-reinforced polymer-confined concrete.” J. Compos. Constr., 6(4), 233–240.
Ozbakkaloglu, T., and Saatcioglu, M. (2004). “Rectangular stress block for high-strength concrete.” ACI Struct. J., 101(4), 475–483.
Ozbakkaloglu, T., and Saatcioglu, M. (2006). “Seismic performance of square high-strength concrete columns in stay-in-place FRP formwork.” J. Struct. Eng., 133(1), in press.
Park, R., and Paulay, T. (1975). Reinforced concrete structures, Wiley, New York.
Pessiki, S., Harries, K. A., Kestner, J. T., Sause, R., and Ricles, J. M. (2001). “Axial behavior of reinforced concrete columns confined with FRP jackets.” J. Compos. Constr., 5(4), 237–245.
Popovics, S. (1973). “Analytical approach to complete stress-strain curves.” Cem. Concr. Res., 3(5), 583–599.
Priestley, M. J. N., and Paulay, T. (1992). Seismic design of reinforced concrete and masonry buildings, Wiley, New York.
Priestley, M. N., Verma, R., and Xiao, Y. (1994). “Seismic shear strength of reinforced concrete columns.” J. Struct. Eng., 120(8), 2310–2329.
Razvi, S., and Saatcioglu, M. (1999). “Confinement model for high-strength concrete.” J. Struct. Eng., 125(3), 281–289.
Saadatmanesh, H., Ehsani, M. R., and Jin, L. (1996). “Seismic strengthening of circular bridge pier models with fiber composites.” ACI Struct. J., 93(6), 639–647.
Saadatmanesh, H., Ehsani, M. R., and Jin, L. (1997). “Repair of earthquake-damaged R/C columns with FRP wraps.” ACI Struct. J., 94(2), 206–215.
Saafi, M., Toutanji, H. A., and Li, Z. (1999). “Behavior of concrete columns confined with fiber-reinforced polymer tubes.” ACI Struct. J., 96(4), 500–509.
Saatcioglu, M. (1991). “Deformability of reinforced concrete columns.” Earthquake Resistant Concrete Structures, Inelastic Response and Design, ACI SP-127-10, American Concrete Institute, Detroit, 421–452.
Saatcioglu, M., and Razvi, S. R. (1992). “Strength and ductility of confined concrete.” J. Struct. Eng., 118(6), 1590–1607.
Saatcioglu, M., and Razvi, S. R. (2002). “Displacement-based design of reinforced concrete columns for confinement.” ACI Struct. J., 99(1), 3–11.
Samaan, M., Mirmiran, A., and Shahawy, M. (1998). “Model of concrete confined by fiber composites.” J. Struct. Eng., 124(9), 1025–1031.
Seible, F., Burgueño, R., Abdallah, M. G., and Nuismer, R. (1996). “Development of advanced composite carbon shell systems for concrete columns in seismic zones.” Proc., 11th World Conf. Earthquake Engineering, Pergamon, Elsevier Science, Oxford, U.K., Paper No. 1375.
Seible, F., Priestley, M. J. N., Hegemier, G. A., and Innamorato, D. (1997). “Seismic retrofit of RC columns with continuous carbon fiber jackets.” J. Compos. Constr., 1(2), 52–62.
Shahawy, M., Mirmiran, A., and Beitelman, A. (2000). “Test and modeling of carbon-wrapped concrete columns.” Composites, Part B, 31, 471–480.
Shao, Y. (2005). “Experimental investigation of cyclic behavior of concrete-filled fiber-reinforced polymer tubes.” J. Compos. Constr., 9(3), 263–273.
Sheikh, S. A., and Khoury, S. S. (1993). “Confined concrete columns with stubs.” ACI Struct. J., 90(4), 414–431.
Sheikh, S. A., and Uzumeri, S. M. (1980). “Strength and ductility of tied concrete columns.” J. Struct. Div., 106(5), 1079–1102.
Sheikh, S. A., and Yau, G. (2002). “Seismic behaviour of concrete columns confined with steel and fiber-reinforced polymers.” ACI Struct. J., 99(1), 72–80.
Spoelstra, M. R., and Monti, G. (1999). “FRP-confined concrete model.” J. Compos. Constr., 3(3), 143–150.
Toutanji, H. A. (1999). “Stress-strain characteristics of concrete columns externally confined with advanced fiber composite sheets.” ACI Mater. J., 96(3), 397–404.
Xiao, Y., and Ma, R. (1997). “Seismic retrofit of RC circular columns using prefabricated composite jacketing.” J. Struct. Eng., 123(10), 1357–1364.
Xiao, Y., and Wu, H. (2000). “Compressive behavior of concrete confined by carbon fiber composite jackets.” J. Mater. Civ. Eng., 12(2), 139–146.
Xiao, Y., and Wu, H. (2003). “Compressive behavior of concrete confined by various types of FRP composites jackets.” J. Reinf. Plast. Compos., 22(13), 1187–1202.
Zhu, Z. (2004). “Joint construction and seismic performance of concrete-filled fiber-reinforced polymer tubes.” Ph.D. thesis, North Carolina State Univ., Raleigh, N.C.
Information & Authors
Information
Published In
Copyright
© 2006 ASCE.
History
Received: Nov 15, 2005
Accepted: Feb 7, 2006
Published online: Dec 1, 2006
Published in print: Dec 2006
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.