A New Method for the Correlation of Residual Shear Strength of the Soil with Mineralogical Composition
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 131, Issue 9
Abstract
Mineralogical composition, measured with x-ray diffraction for soil specimens collected from more than 80 natural disaster areas, show smectite, kaolinite, mica, feldspar, and quartz as major constituent minerals. Based on the results of more than 35 mixtures of smectite, kaolinite, and quartz in different proportions, a new correlation method was proposed for estimation of the residual friction angle with the proportion of the minerals. The mineralogical compositions of the natural samples were used to estimate the based on the proposed triangular model. The estimation method resulted in values as close as 90% to the measured , and as close as 80% to the case of 53 samples tested by other researchers. The paper incorporates the correlation of with the liquid limit, the plasticity index, the clay fraction, the specific surface area, and the proportion of smectite. Various ranges are proposed, according to the influence of the constituent clay minerals. In addition, the applicable range of the correlation methods in practice were also verified.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers would like to thank Sabo Technical Center, Japan for the grant to conduct a part of this research. They would like to extend their heartfelt gratitude to Professor Thomas L. Brandon of Virginia Polytechnic Institute and State University for various technical as well as editorial suggestions on the paper.
References
Binnie, M. A., Clark, J. F. F., and Skempton, A. W. (1967). “The effect of discontinuities in clay bedrock on the design of dams in the Mangla project.” Proc., Trans. 9th International Congress of Large Dams, Istanbul, Turkey, Vol. 1, 165–183.
Bishop, A. W. (1971). “Shear strength parameters for undisturbed and remolded soil specimens.” Proc., The Roscoe Memorial Symp., Cambridge, Mass., 3–58.
Bishop, A. W., Green, G. E., Garga, V. K., Andresen, A., and Brown, J. D. (1971). “New ring shear apparatus and its application to the measurement of residual strength.” Geotechnique, 21(4), 273–328.
Borowicka, H. (1965). “The influence of the colloidal content on the shear strength of clay.” Proc., 6th International Conf. of Soil Mechanics, Montreal, Vol. 1, 175–178.
Bromhead, E. N. (1992). Stability of slopes, 2nd Ed., Surrey University Press, London.
Collotta, T., Cantoni, R., Pavesi, U., Ruberl, E., and Moretti, P. C. (1989). “A correlation between residual friction angle, gradation and the index properties of cohesive soils.” Geotechnique, 39(2), 343–346.
Gibo, S., Egashira, K., and Hayashi, Y. (1992). “Measurement of residual strength of slip surface soil with a ring shear apparatus and its relation to physical and mineralogical properties of the soils.” J. Japan Agricultural Engineering Society, 159, 57–63.
Haefeli, R. (1951). “Investigation and measurements of the shear strength of saturated cohesive soils.” Geotechnique, 2(3), 186–187.
Iwamitsu, K., Tanaka, N., and Tamada, B. (1995). “A study on the qualitative analysis of clay minerals found on the sliding surface of landslides.” J. Japan Landslide Society, 32(1), 34–40.
Japan Geotechnical Society. (1992). Soil testing manual, Tokyo, Japan (in Jananese).
Kanji, M. A., and Wolle, C. M. (1977). “Residual strength—New testing and microstructure.” Proc., 9th International Conf. of Soil Mechanics, Tokyo, Vol. 1, 153–154.
Kenney, T. C. (1967). “The influence of mineral composition on the residual strength of natural soils.” Proc., Geotechnical Conf., Oslo, Norway, Vol. 1, 123–129.
Kenney, T. C. (1977). “Residual strength of mineral mixtures.” Proc., 9th International Conf. on Soil Mechanics, Tokyo, Vol. 1, 155–160.
Lambe, T. W. (1985). “Amuay landslide.” Proc., 6th International Conf. of Soil Mechanics and Foundation Engineering, San Francisco.
Lupini, J. F., Skinner, A. E., and Vaughan, P. R. (1981). “The drained residual strength of the cohesive soils.” Geotechnique, 31(2), 181–213.
Mesri, G., and Cepeda-Diaz, A. F. (1986). “Residual shear strength of clays and shales.” Geotechnique, 36(2), 269–273.
Mitchell, J. K. (1993). Fundamental of soil behavour, 2nd Ed., Wiley, New York.
Oslon, R. E. (1974). “Shearing strength of kaolinite, illite, and montmorillonite.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng., 100(11), 1215–1229.
Seycek, J. (1978). “Residual shear strength of soils.” Bull. Int. Assoc. Eng. Geol., 17, 73–75.
Skempton, A. W. (1964). “Long-term stability of clay slopes.” Geotechnique, 14(2), 77–102.
Skempton, A. W. (1985). “Residual strength of clays in landslides, folded strata and the laboratory.” Geotechnique, 35(1), 3–18.
Skempton, A. W., and Petley, D. J. (1967). “The strength along structural discontunities in stiff clays.” Proc., Geotechnical Conf., Oslo, Norway, 29–46.
Stark, T. D., and Eid, H. T. (1994). “Drained residual shear strength of cohesive soils.” J. Geotech. Geoenviron. Eng., 120(1), 269–273.
Tiwari, B., and Marui, H. (2001). “Shearing behaviour of landslide sliding surface and main scarp soil during drained ring shear test.” Proc., 15th International Conf. on Soil Mechanics and Geotechnical Engineering, Istanbul, Turkey, Vol. 1, 295–298.
Tiwari, B., and Marui, H. (2004). “Objective oriented multi-stage ring shear test for the shear strength of landslide soil.” J. Geotech. Geoenviron. Eng., 130(2), 217–222.
Vaughan, P. R., Hight, D. W., Sodha, V. G., and Walbancke, H. J. (1979). “Factors controlling the stability of clay fills in Britain.” Clay fills, London, 203–217.
Voight, B. (1973). “Correlation between Atterberg plasticity limits and residual shear strength of natural soils.” Geotechnique, 23(2), 265–267.
Wisley, L. D. (2003). “Residual strength of clays and correlations using Atterberg limits.” Geotechnique, 53(7), 669–672.
Wu, T. H. (1996). “Soil strength properties and their measurements.” Landslides-Investigation and Mitigation, Special Rep. No. 247, Transportation Research Board, Washington, D.C., 319–334.
Yamasaki, T., and Mayumi, T. (2000). “Ring shear characteristics of high purity clay minerals—correlation with natural slip surface clay.” J. Japan Landslide Society, 37(2), 30–39.
Information & Authors
Information
Published In
Copyright
© 2005 ASCE.
History
Received: Feb 13, 2004
Accepted: Feb 7, 2005
Published online: Sep 1, 2005
Published in print: Sep 2005
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.