Spatial Variability in Soils: High Resolution Assessment with Electrical Needle Probe
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 130, Issue 8
Abstract
The global response of a soil is affected by spatial as well as temporal scales. An electrical needle-size probe is developed to effectively assess one-dimensional spatial variability. The probe is designed for laboratory specimens (needle diameter 1.2–2.2 mm), and it can be scaled for field applications. Design considerations include the tip shape, insertion disturbance, electrochemical effects, corrosion, operating frequency, and electrical resonance. Two calibration methods are presented to determine local soil permittivity and resistivity from the measured complex impedance; the simplified calibration procedure is based on resistance measurements only. The local electrical parameters permit one to infer the soil porosity and the electrolyte conductivity. The attainable spatial resolution depends on the needle diameter; submillimetric resolution is typically achieved in laboratory applications. Reconstituted sand specimens and undisturbed clayey specimens are tested to explore the resolution potential of this probe. The electrical needle probe clearly detects the spatial variability that results from different specimen preparation methods in sands and soil layering from natural formation histories such as those in varved clays.
Get full access to this article
View all available purchase options and get full access to this article.
References
Archie, G. E.(1942). “The electrical resistivity log as an aid in determining some reservoir characteristics.” Trans. Am. Inst. Min., Metall. Pet. Eng., 146, 54–62.
Baligh, M. M., and Scott, R. F.(1976). “Quasi-static deep penetration in clay.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng., 101(11), 1119–1133.
Bradford, S. A. (1993). Corrosion control, Van Nostrand Reinhold, New York.
Cho, G. C. (2001). “Unsaturated soil stiffness and postliquefaction shear strength.” PhD thesis, Georgia Inst. of Technology, Atlanta.
Davidson, J. L., and Boghrat, A. (1983). “Displacement and strains around probes in sand.” Proc., Conf. on Geotech. Practice in Offshore Engineering, S. G. Wright, ed., Univ. of Texas at Austin, Austin, Tex., 181–202.
DeGregorio, V. B.(1990). “Loading systems, sample penetration, and liquefaction.” J. Geotech. Eng., 116(5), 805–821.
DeGroot, D. J., and Lutenegger, A. J. (2002). “Geology and engineering properties of Connecticut Valley varved clay.” Characterisation and Engineering Properties of Natural Soils, T. S. Tan, K. K. Phoon, D. W. Hight, and S. Leroueil, eds., 693–724.
De Jong, J. T., DeGroot, D. J., Yafrate, N. J., and Jakubowski, J. (2003). “Detection of soil layering using a miniature piezoprobe.” 12th PanAmerican Conf. on Soil Mechanics and Geotechnical Engineering, P. J. Culligan, H. H. Eistein, and A. J. Whittle, eds., 151–156.
Desrues, J., Chambon, R., Mokni, M., and Mazerolle, F.(1996). “Void ratio evolution inside shear bands in triaxial sand specimens studied by computed tomography.” Geotechnique, 46(3), 529–546.
Daz-Rodrguez, J. A. (2002). “Characterization and engineering properties of Mexico City lacustrine soils.” Characterisation and engineering properties of natural soils, T. S. Tan, K. K. Phoon, D. W. Hight, and S. Leroueil, eds., 725–755.
Fenton, G. A., and Griffiths, D. V.(1996). “Statistics of free surface flow through stochastic earth dam.” J. Geotech. Eng., 122(6), 427–436.
Griffiths, D. V., and Fenton, G. A.(1993). “Seepage beneath water retaining structures founded on spatially random soil.” Geotechnique, 43(4), 577–587.
Ishihara, K.(1993). “Liquefaction and flow failure during earthquakes.” Geotechnique, 43(3), 351–415.
Jang, D. J., Frost, J. D., and Park, J. Y.(1999). “Preparation of epoxy impregnated sand coupons for image analysis.” Geotech. Test. J., 22(2), 147–158.
Klein, K., and Santamarina, J. C.(1995). “Polarization and conduction of clay-water-electrolyte systems.” J. Geotech. Eng., 121(3), 243–248.
Kokusho, T.(1999). “Water film in liquefied sand and its effect on lateral spread.” J. Geotech. Geoenviron. Eng., 125(10), 817–826.
Ladd, R. S.(1977). “Specimen preparation and cyclic stability of sands.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng., 103(6), 535–547.
Lee, J. S. (2003). “High resolution geophysical techniques for small-scale soil model testing.” PhD thesis, Georgia Inst. of Technology, Atlanta.
Marcuson, III, W. F., Hynes, M. E., and Fanklin, A. G.(1990). “Evaluation and use of residual strength in seismic safety analysis of embankments.” Earthquake Spectra, 6(3), 529–572.
Mitchell, J. K., Chatoian, J. M., and Carpenter, G. C. (1976). “The influences of sand fabric on liquefaction behavior.” Rep. No. TE 76-1, U.S. Army Engineer Waterways Experiment Station, Univ. of California, at Berkeley, Berkeley, Calif.
Miura, S., and Toki, S.(1982). “A sample preparation method and its effect on static and cyclic deformation-strength properties of sand.” Soils Found., 22(1), 61–77.
Mulilis, J. P., Chan, C. K., and Seed, H. B. (1975). “The effects of method of sample preparation on the cyclic stress strain behavior of sands.” EERC Rep. No. 75-18, Environmental Engineering Research Council.
Mulilis, J. P., Seed, H. B., Chan, C. K., Mitchell, J. K., and Arulanandan, K.(1977). “Effects of sample preparation on sand liquefaction.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng., 103(2), 91–108.
Paice, G. M., Griffiths, D. V., and Fenton, G. A.(1996). “Finite element modeling of settlements on spatially random soil.” J. Geotech. Eng., 122(9), 777–779.
Parkhomenko, E. I. (1967). Electrical properties of rocks, Plenum, New York.
Phoon, K. K., and Kulhawy, F. H.(1999). “Characterization of geotechnical variability.” Can. Geotech. J., 36(4), 612–624.
Popescu, R., and Prevost, J. H. (1996). “Influence of spatial variability of soil properties on seismically induced soil liquefaction.” Geotechnical Spec. Publ. No. 58, 1098–1112.
Popescu, R., Prevost, J. H., and Deodatis, G.(1997). “Effects of spatial variability on soil liquefaction: some design recommendations.” Geotechnique, 47(5), 1019–1036.
Santamarina, J. C. in collaboration with Klein, K. A., and Fam, M. A. (2001). Soils and waves—Particulate materials behavior, characterization and process monitoring, Wiley, New York.
Tonon, F., Bernardini, A., and Mammino, A.(2000). “Reliability analysis of rock mass response by means of random set theory.” Reliability Eng. Sys. Safety, 70(3), 263–282.
Townsend, F. C. (1978). “A review of factors affecting cyclic triaxial tests.” Dynamic Geotech. Testing, ASTM STP 654, 356–383.
Vasquez-Herrera, A., and Dobry, R. (1988). “Pore pressure buildup and liquefaction failure of anisotropically consolidated sand due to cyclic straining.” Geotechnical Spec. Publ. No. 21, 346–366.
Vesic, A. S. (1977). “Design of pile foundations, National Cooperative Highway Research Program, synthesis of highway proactive 42.” Transportation Research Board, Washington, D.C., 12–22.
Yong, R. N., Alonso, E., and Tabba, M. M.(1977). “Application of risk analysis to the prediction of slope stability.” Can. Geotech. J., 14(4), 540–553.
Information & Authors
Information
Published In
Copyright
Copyright © 2004 American Society of Civil Engineers.
History
Received: Feb 14, 2003
Accepted: Aug 13, 2003
Published online: Jul 15, 2004
Published in print: Aug 2004
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.