Engineering Behavior of a Sand Reinforced with Plastic Waste
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 128, Issue 6
Abstract
Unconfined compression tests, splitting tensile tests, and saturated drained triaxial compression tests with local strain measurement were carried out to evaluate the benefit of utilizing randomly distributed polyethylene terephthalate fiber, obtained from recycling waste plastic bottles, alone or combined with rapid hardening Portland cement to improve the engineering behavior of a uniform fine sand. The separate and the joint effects of fiber content (up to 0.9 wt %), fiber length (up to 36 mm), cement content (from 0 to 7 wt %), and initial mean effective stress (20, 60, and 100 kN/m2) on the deformation and strength characteristics of the soil were investigated using design of experiments and multiple regression analysis. The results show that the polyethylene terephthalate fiber reinforcement improved the peak and ultimate strength of both cemented and uncemented soil and somewhat reduced the brittleness of the cemented sand. In addition, the initial stiffness was not significantly changed by the inclusion of fibers.
Get full access to this article
View all available purchase options and get full access to this article.
References
Airey, D. W.(1993). “Triaxial testing of naturally cemented carbonate soil.” J. Geotech. Eng., 119(9), 1379–1398.
Al-Refeai, T. O.(1991). “Behavior of granular soils reinforced with discrete randomly oriented inclusions.” Geotext. Geomembr., 10, 319–333.
American Society for Testing and Materials (ASTM). (1990a). “Standard test method for compressive strength of molded soil-cement cylinders.” ASTM D 1633-84, Philadelphia.
American Society for Testing and Materials (ASTM). (1990b). “Standard test method for splitting tensile strength of cylindrical concrete specimens.” ASTM C 496-90, Philadelphia.
Beckwith, G. H., and Hansen, L. A. (1982). “Calcareous soils of the southwestern United States.” Proc., Geotech. Properties, Behavior, and Perf. of Calcareoius Soils, American Society for Testing and Materials, West Conshohocken, Pa., Vol. 1, 16–35.
Box, G. E. P., and Draper, N. (1987). Empirical model building and response surfaces, Wiley, New York.
Campos, T. M. P. (1984). “Two low plasticity clays under cyclic and transient loading.” PhD thesis, Univ. of London, London.
Cavey, J. K., Krizek, R. J., Sobhan, K., and Baker, W. H. (1995). “Waste fibers in cement-stabilized recycled aggregate base course material.” Proc., Environmental Testing and Evaluation of Stabilized Wastes, Performance of Stabilized Materials, and New Aggregate Tests, Transportation Research Board Record 1486, National Research Council, Washington, D.C., 97–106.
Clayton, C. R. I., and Khatrush, S. A.(1986). “A new device for measuring local axial strain on triaxial specimens.” Geotechnique, 25, 657–670.
Clayton, C. R. I., Khatrush, S. A., Bica, A. V. D., and Siddique, A.(1989). “The use of Hall effect semiconductor in geotechnical instrumentation.” Geotech. Testing J. 12(1), 69–76.
Clough, G. W., Sitar, N., Bachus, R. C., and Rad, N. S.(1981). “Cemented sands under static loading.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng., 107(6), 799–817.
Consoli, N. C., Prietto, P. D. M., and Ulbrich, L. A.(1998b). “The influence of fiber and cement addition on behavior of a sandy soil.” J. Geotech. Geoenviron. Eng., 124(12), 1211–1214.
Consoli, N. C., Prietto, P. D. M., and Ulbrich, L. A.(1999). “The behaviour of a fibre-reinforced cemented soil.” Ground Improvement, London, 3(1), 21–30.
Consoli, N. C., Rotta, G. V., and Prietto, P. D. M.(2000). “The influence of curing under stress on the triaxial response of cemented soils.” Geotechnique, 50(1), 99–105.
Consoli, N. C., Schnaid, F., and Milititsky, J.(1998a). “Interpretation of plate load tests on residual soil site.” J. Geotech. Geoenviron. Eng., 124(9), 857–867.
Consoli, N. C., Ulbrich, L. A., and Prietto, P. D. M. (1997). “Engineering behavior of randomly distributed fiber-reinforced cemented soil.” Proc., Symp. on Recent Developments on Soil and Pavement Mechanics, Balkema, Rotterdam, The Netherlands, 481–486.
Coop, M. R., and Atkinson, J. H.(1993). “The mechanics of cemented carbonate sands.” Geotechnique, 43(1), 53–67.
Cuccovillo, T., and Coop, M. R.(1997). “Yielding and pre-failure deformation of structured sands.” Geotechnique, 47, 481–508.
Dupas, J., and Pecker, A.(1979). “Static and dynamic properties of sand-cement.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng., 105(3), 419–436.
Gray, D. H., and Al-Refeai, T.(1986). “Behavior of fabric versus fiber-reinforced sand.” J. Geotech. Eng., 112(8), 804–820.
Gray, D. H., and Ohashi, H.(1983). “Mechanics of fiber reinforcement in sand.” J. Geotech. Eng., 109(3), 335–353.
Hardingham, A. D. (1994). “Development of an engineering description of cemented soils and calcrete duricrusts.” Proc., 1st Int. Symp. on Engineering Characteristics of Arid Soils, Balkema, Rotterdam, The Netherlands, Vol. 1, 87–90.
Hicks, C. R. (1993). Fundamental concepts in the design of experiments, 4th Ed., Saunders College Publishing, New York.
Jardine, R. J., Fourie, A., Maswoswe, J., and Burland, J. B. (1985). “Field and laboratory measurements of soil stiffness.” Proc., 11th Int. Conf. on Soil Mechanics and Foundation Engineering, ISSMFE, London, 511–514.
La Rochelle, P., Leroueil, S., Trak, B., Blais-Leroux, L., and Tavenas, F. (1988). “Observational approach to membrane and area corrections in triaxial tests.” Proc., Symp. on Advanced Triaxial Testing of Soil andRock, American Society for Testing and Materials, West Conshohocken, Pa., 715–731.
Ladd, R. S.(1978). “Preparing test specimens using undercompaction.” Geotech. Testing J. 1(1), 16–23.
Lagioia, R., and Nova, R.(1995). “An experimental and theoretical study of the behavior of a calcarenite in triaxial compression.” Geotechnique, 45(4), 633–648.
Leroueil, S., and Vaughan, P. R.(1990). “The general and congruent effects of structure in natural soils and weak rocks.” Geotechnique, 40(3), 467–488.
Maher, M. H., and Gray, D. H.(1990). “Static response of sands reinforced with randomly distributed fibers.” J. Geotech. Eng., 116(11), 1661–1677.
Maher, M. H., and Ho, Y. C.(1993). “Behavior of fiber-reinforced cemented sand under static and cyclic loads.” Geotech. Testing J., 16, 330–338.
Maswoswe, J. J. (1985). “Stress path method for a compacted soil during collapse due to wetting.” PhD thesis, Univ. of London, London.
Montardo, J. P. (1999). “Mechanical behavior of soil-cement-fiber composites: The effect of constituent material properties.” MSc thesis, Federal Univ. of Rio Grande do Sul, Porto Alegre, Brazil (in Portuguese).
Montardo, J. P., Vendruscolo, M. A., Consoli, N. C., and Prietto, P. D. M. (1998). “Shear strength and deformation characteristics of a PET fiber reinforced cemented soil: Preliminary study.” Proc., 12th Brazilian Congr. on Soil Mechanics and Geotechnical Engineering, Brazilian Society of Soil Mechanics and Foundation Engineering, São Paulo, 1163–1167 (in Portuguese).
Montgomery, D. C. (1991). Design and analysis of experiments, Wiley, New York.
Morel, J. C., and Gourc, J. P.(1997). “Mechanical behavior of sand reinforced with mesh elements.” Geosynthet. Int., 4(5), 481–508.
Myers, R. H., and Montgomery, D. C. (1995). Response surface methodology: Process and product optimization using designed experiments, Wiley, New York.
Omine, K., Ochiai, H., Yasufuku, N., and Kato, T. (1996). “Effect of plastic wastes in improving cement-treated soils.” Proc., 2nd Int. Congr. on Environmental Geotechnics, Balkema, Rotterdam, The Netherlands, 875–880.
Rad, N. S., and Clough, G. W. (1985). “Static behavior of variably cemented beach sands.” Proc., Strength Testing of Marine Soils: Laboratory and In-situ Measurements, American Society for Testing and Materials, West Conshohocken, Pa., 306–317.
Ranjan, G., Vasan, R. M., and Charan, H. D.(1994). “Behaviour of plastic-fibre-reinforced sand.” Geotext. Geomembr., 13, 555–565.
Saxena, S. K., and Lastrico, R. M.(1978). “Static properties of lightly cemented sand.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng., 104(12), 1449–1464.
Shewbridge, E., and Sitar, N.(1990). “Deformation-based model for reinforced sand.” J. Geotech. Eng., 116(7), 1153–1170.
Soares, J. M. D., Bica, A. V. D., Bressani, L. A., and Martins, F. B.(1994). “Local measurement of strains using Hall effect sensors.” Solos e Rochas,São Paulo, 17, 183–188 (in Portuguese).
Information & Authors
Information
Published In
Copyright
Copyright © 2002 American Society of Civil Engineers.
History
Received: Mar 9, 2000
Accepted: Aug 17, 2001
Published online: May 15, 2002
Published in print: Jun 2002
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.