Pore Structure Changes of Blended Cement Pastes Containing Fly Ash, Rice Husk Ash, and Palm Oil Fuel Ash Caused by Carbonation
Publication: Journal of Materials in Civil Engineering
Volume 21, Issue 11
Abstract
In this paper, the effects of carbonation on pore structure of blended pozzolan cement pastes were investigated. Ordinary Portland cement (OPC) was partially replaced with ground palm oil fuel ash (POA), ground rice husk ash (RHA) and classified fine fly ash (FA). The strength, total porosity, specific surface area, and pore size distribution were tested. In general, incorporation of pozzolans increased the total porosity of blended cement pastes in comparison to that of OPC paste. Carbonation of pastes under 5% and 50% relative humidity (RH) for 28 days resulted in filling of the pore voids and possible attack on calcium silicate hydrate (CSH) depending on the type of pozzolan used. After carbonation, total porosity decreased and specific surface areas of the blended pozzolan cement pastes reduced indicating the infilling of voids. Pore size distributions of POA and RHA pastes were different to those of FA pastes. Large pores of the POA and RHA pastes were increased indicating coarsening of pores owing to possible attack on CSH. It is possible that POA and RHA were highly reactive and hence their uses resulting in severe carbonation compared to use of FA.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers acknowledge the financial support of Sustainable Infrastructure Research and Development Center, Khon Kaen University.
References
ASTM C109. (2001). “Standard test method for compressive strength of hydraulic cement mortars [using 2-in or (50 mm) cube specimens].” ASTM C109M-99, 04.01, 83–88
Chindaprasirt, P., Jaturapitakkul, C., and Sinsiri, T. (2005). “Effect of fly ash fineness on compressive strength and pore size of blended cement paste.” Cem. Concr. Compos., 27(4), 425–428.
Chindaprasirt, P., Jaturapitakkul, C., and Sinsiri, T. (2007). “Efffect of fly ash fineness on microstructure of blended cement paste.” Constr. Build. Mater., 21, 1534–1541.
Chindaprasirt, P., and Rukzon, S. (2007). “Strength, porosity and corrosion resistance of ternary blend Portland cement, rice husk ash and fly ash mortar.” Constr. Build. Mater., 22(8), 1601–1606.
Chindaprasirt, P., Rukzon, S., and Sirivivatnanon, V. (2008). “Resistance to chloride penetration of blended Portland cement mortar containing palm oil fuel ash, rice husk ash and fly ash.” Constr. Build. Mater., 22, 932–938.
Cook, D. J., and Suwanvitaya, P. (1983). “Properties and behavior of lime-rice husk ash cements.” American Concrete Institute, 2, 831–845.
Della, V. P., Kuhn, L., and Hotza, D. (2002). “Rice husk ash as an alternative source for active silica production.” Mater. Lett., 57, 818–821.
Galle, C. (2001). “Effect of drying on cement–based materials pore structure as identified by mercury intrusion porosimetry: A comparative study between oven, vacuum, and freeze–drying.” Cem. Concr. Res., 31, 1467–1477.
Isaia, G. C., Gastaldini, A. L. G., and Moraes, R. (2003). “Physical and pozzolanic action of mineral additions on the mechanical strength of high-performance concrete.” Cem. Concr. Compos., 25, 69–76.
Johannesson, B., and Utgenannt, P. (2001). “Microstructural changes caused by carbonation of cement mortar.” Cem. Concr. Res., 31, 925–931.
Konecny, L., and Naqui, S. J. (1993). “The effect of different drying techniques on the pore size distribution of blended cement mortars.” Cem. Concr. Res., 23, 1223–1228.
Kumar, R., and Bhattacharjee, B. (2003). “Porosity, pore size distribution and in situ strength of concrete.” Cem. Concr. Res., 33, 155–164.
Neville, A. M. (1995). Properties of concrete, 4th and final Ed.,Longman's, London.
Ngala, V. N., and Page, C. L. (1997). “Effects of carbonation on pore structure and diffusional properties of hydrated cement paste.” Cem. Concr. Res., 27(7), 995–1007.
Payá, J., Monzó, J., Borrachero, M. V., Peris-Mora, E., and González-López, E. (1996). “Mechanical treatment of fly ashes. Part II: Particle morphologies in ground fly ashes (GFA) and workability of GFA-cement mortars.” Cem. Concr. Res., 26(2), 225–235.
Poon, C. S., Wong, Y. L., and Lam, L. (1997). “The influence of different curing conditions on the pore structure and related properties of fly ash cement pastes and mortars.” Constr. Build. Mater., 11, 383–393.
Rukzon, S., and Chindaprasirt, P. (2008a). “Development of classified fly ash as a pozzolanic material.” J. Appl. Sci., 8(6), 1097–1102.
Rukzon, S., and Chindaprasirt, P. (2008b). “Mathematical model of strength and porosity of ternary Portland rice husk ash and fly ash cement mortar.” Comput. Concr., 5(1), 75–88.
Sulapha, P., Wong, S. F., Wee, T. H., and Swaddiwudhipong, S. (2003). “Carbonation of concrete containing mineral admixtures.” J. Mater. Civ. Eng., 15, 134.
Tay, J. H. (1990). “Ash from oil–palm waste as a concrete material.” J. Mater. Civ. Eng., 2(2), 94–105.
Washburn, E. W. (1921). “Note on method of determining the distribution of pore size in porous materials.” Proc. Natl. Acad. Sci. U.S.A., 7, 115–116.
Xu, A., and Sarkar, S. L. (1994). “Microstructural Development in High-Volume Fly-Ash Cement System.” J. Mater. Civ. Eng., 6(1), 117–136.
Zhang, X., Wu, K., and Yan, A. (2004). “Carbonation property of hardened binder pastes containing super-pulverized blast–furnace slag.” Cem. Concr. Compos., 26, 371–374.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: May 6, 2008
Accepted: Apr 30, 2009
Published online: Oct 15, 2009
Published in print: Nov 2009
Notes
Note. Associate Editor: Maria C. G. Juenger
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.