Corrosion of Reinforcing Steel in Fly Ash Blended Cement Concrete
Publication: Journal of Materials in Civil Engineering
Volume 5, Issue 3
Abstract
Using a technique for accelerated corrosion monitoring, corrosion‐resisting characteristics of reinforcement of four plain and 36 fly ash blended cement concretes have been evaluated. Three fly ashes of bituminous, sub‐bituminous and lignite origins have been used, in conjunction with four plain cements having contents of 2%, 9%, 11%, and 14%. The 36 blended cements were formulated such that each of the four cements had 10%, 20%, and 30% cement replacements by each of the three fly ashes. Results of corrosion monitoring tests show that fly ash blending of plain cements by 30% partial replacement improved the corrosion‐resistance performance twofold to threefold over plain type I and type V cement concretes, respectively, in terms of corrosion‐initiation time. Fly ash of lignite origin exhibited better impermeability and corrosion‐resisting characteristics than bituminous and sub‐bituminous fly ashes. Level of replacement is a significant performance parameter, with the best performance observed for 30% replacement. The time to initiation of corrosion and weight loss were significantly influenced by the content of the cement; 9%, 11%, and 14% cements performed 1.75, 1.93, and 2.45 times better than the 2% cement in terms of corrosion‐initiation time. The beneficial effect was also operative in fly ash blended cement concretes, although on a reduced level.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Abdul Hadi, S. S. (1982). “Electrical resistivity of concrete in relation to corrosion of reinforcement,” MS thesis, Dept. of Civ. Engrg., King Fand Univ. of Petroleum and Minerals, Dhahran, Saudi Arabia.
2.
Bakker, R. F. M. (1983). “Permeability of blended cement concretes.” Proc., CANMET/ACI 1st Int. Conf. on the Use of Fly Ash, Silica Fume, Slag and Other Mineral By‐Products in Concrete: ACI Spec. Publ. SP‐79, American Concrete Inst., Detroit, Mich., 589–605.
3.
Baumel, A. (1960). Effect of calcium chloride on the corrosion behavior of steel in concrete. Vol. 10, Beton Herstellung‐Verwendung, Dusselfdorf, Germany (in German).
4.
Beaton, J. L., Spellman, D. L., and Stratfull, R. F. (1967). “Corrosion of steel in continuously submerged reinforced concrete piling.” Highway Res. Rec. No. 204, Highway Research Board, Washington, D.C., 11–21.
5.
Browne, R. D. (1983). “Design for durability.” Proc., 7th Eur. Ready Mixed Concrete Cong., Institute of Concrete Technology, London, England.
6.
Davis, R. E. (1954). “Pozzolanic materials—with special reference to their use in concrete pipe.” Tech. Memorandum, American Pipe Assoc., Arlington, Va.
7.
Diamond, S. (1986). “Chloride concentrations in concrete pore solutions resulting from calcium and sodium chloride admixture.” Cem. Concr. Aggregates, 8(2).
8.
Elfert, R. J. (1973). “Bureau of reclamation experiences with fly ash and other pozzolans in concrete.” Proc., 3rd Int. Ash Utilization Symp., Information Circular IC8640. U.S. Bureau of Mines, Washington, D.C., 80–93.
9.
Gebler, S. H., and Klieger, P. (1983). “Effect of fly ash on the air void stability of concrete.” R0085.01T. Portland Cement Assoc., Skokie, Ill.
10.
Gouda, V. K. (1970). “Corrosion and corrosion inhibition of reinforcing steel. I: Immersion in alkaline solution.” British Corrosion Journal, London, England, 5(Sept.), 198–203.
11.
Hausmann, D. A. (1968). “Steel corrosion in concrete.” Materials Protection, 6(19), 19–23.
12.
Holden, W. R., Page, C. L., and Short, N. R. (1983). “The influence of chlorides and sulfates on durability.” Corrosion of Reinforcement in Concrete Construction, Ellis Horwood Ltd., Chichester, England, 144–150.
13.
Kawamura, M., Kayyati, O. A., and Haque, M. N. (1988). “Effect of a fly ash on pore solution composition in calcium and sodium chloride‐bearing mortars.” Cem. and Concr. Res., 18(5), 763–773.
14.
Kumar, A., and Roy, D. M. (1986). “Pore structure and ionic diffusion in admixture blended portland cement systems.” Proc., 8th Int. Cong. on the Chemistry of Cem., Vol. V, 73–79.
15.
Kumar, A., Komarneni, S., and Roy, D. M. (1987). “Diffusion of and Cl− through sealing materials.” Cem. and Concr. Res., 17(1), 153–160.
16.
Manmohan, D., and Mehta, P. K. (1981). “Influence of pozzolanic, slag and chemical admixtures on pore size distribution and permeability of hardened cement pastes.” Cem. Concr. and Aggregates, 3(1), 63–67.
17.
Massazza, F. (1974). “Chemistry of pozzolanic additions and mixed cements.” 6th Int. Cong. on the Chemistry of Cem.
18.
Monfore, G. M., and Verbeck, G. J. (1960). “Corrosion of prestressed wire in concrete.” ACI J., 57(5), 491–516.
19.
Rasheeduzzafar, and Dakhil, F. H. (1980). “Field studies on the durability of concrete construction in a high chloride‐sulphate environment.” Int. J. Housing Sci., 4(3), 203–232.
20.
Rasheeduzzafar, Dakhil, F. H., and Al‐Gahtani, A. S. (1984). “The deterioration of concrete structures in the environment of the Middle East.” ACI J., 81(1), 13–20.
21.
Rasheeduzzafar, Dakhil, F. H., and Al‐Gahtani, A. S. (1985). “Corrosion off reinforcement in concrete structures in the Middle East.” Concrete International, American Concrete Institute, 7(9), 48–55.
22.
Rasheeduzzafar, Dakhil, F. H., Al‐Gahtani, A. S., and Al‐Saadoun, S. S. (1989). “Exposure site studies on the effect of cement composition of corrosion of reinforcing steel in concrete.” Arabian Journal for Science and Engineering, AJSE, 4(2), 235–248.
23.
Rasheeduzzafar, Al‐Saadoun, S. S., Al‐Gahtani, A. S., and Dakhil, F. H. (1990a). “Effect of tricalcium aluminate content of cement on corrosion of reinforcing steel in concrete.” Cem. and Concr. Res., 20(5), 723–738.
24.
Rasheeduzzafar, Dakhil, F. H., Al‐Saadoun, S. S., and Al‐Gahtani, A. S. (1990b). “Effect of cement composition on corrosion of reinforcing steel in concrete.” Corrosion of reinforcement in concrete, C. L. Page, ed., Elsevier Applied Science, Amsterdam, The Netherlands.
25.
Rasheeduzzafar, Ehtisham, H. S., and Al‐Saadoun, S. S. (1991). “Effect of cement composition on chloride binding and corrosion of reinforcing steel in concrete.” Cem. and Concr. Res., 21(5), 777–794.
26.
Roberts, M. H. (1962). “Effect of calcium chloride on the durability of pretensioned wire in prestressed concrete.” Magazine of Concrete Research, London, England, 14(42), 143–154.
27.
Sersale, R. (1980). “Structure and characterization of pozzolans and of fly ashes.” Proc., 7th Int. Cong. on the Chemistry of Cem., Vol. 1, Paris, IV‐1/3–18.
28.
Short, N. R., and Page, C. L. (1982). “The diffusion of chloride ions through portland and blended cement pastes.” Silicates Industries, 10, 237–240.
29.
Tuutti, K. (1980). “Service life of structures with regard to corrosion of embedded steel.” Performance of concrete in marine environment: SP‐65, American Concrete Institute, Detroit, Mich., 223–236.
30.
Tyler, I. L., and Erlin, B. (1961). “A proposed simple test method for determining the permeability of concrete.” J. PCA Res. and Development Lab., 3(3), 2–7.
31.
Verbeck, G. J. (1969). “Field laboratory studies of the sulphate resistance of concrete.” Performance of Concrete, University of Toronto Press, Toronto, Canada, 113–124.
32.
Virmani, Y. P. (1982). “Cost effective rigid concrete construction in adverse environments.” FCP Ann. Prog. Rep., Federal Highway Administration, Washington, D.C.
Information & Authors
Information
Published In
Copyright
Copyright © 1993 American Society of Civil Engineers.
History
Received: Mar 19, 1991
Published online: Aug 1, 1993
Published in print: Aug 1993
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.