Optimum Compaction Temperature for Modified Binders
Publication: Journal of Transportation Engineering
Volume 129, Issue 5
Abstract
With increasing use of modified asphalt binders, the correct compaction temperature range for asphalt mixtures containing these binders needs to be determined. The current procedure uses asphalt binder viscosities to determine the compaction temperature range. However, the current procedure often provides unacceptably high temperatures for modified binders. Past work showed that lower temperatures can be used and that the volumetric properties of Superpave gyratory-compacted specimens can be the same over a very wide range in compaction temperatures, even when the mixtures are short-term oven aged at the compaction temperature. However, that study did not examine the effect of temperature on the internal characteristics and mechanical properties of the mixtures. The present study addressed these issues for one of the mixtures used in the previous study. The shear properties of the mixture compacted at four temperatures were evaluated. These properties improved to some extent with an increase in temperature, except for strain-controlled fatigue damage, which did not change significantly with temperature. The effect of temperature on aggregate orientation and the effect of aggregate orientation on shear properties were also investigated. Based on these analyses, a narrower range of optimum compaction temperatures was found compared to the range based on volumetric properties alone. The changes in the shear stiffness of the asphalt binder, in the vertical air void distribution, and in the preferred orientation of the aggregates with compaction temperature were the responsible factors for the changes in mixture shear properties.
Get full access to this article
View all available purchase options and get full access to this article.
References
American Association of State Highway and Transportation Officials (AASHTO). (1998a). “Practice for short and long term aging of hot mix asphalt.” AASHTO Provisional Standard Designation PP2-96, Washington, D.C.
American Association of State Highway and Transportation Officials (AASHTO). (1998b). “Method for preparing and determining the density of hot mix asphalt (HMA) specimens by means of the sharp gyratory compactor.” AASHTO Provisional Standards TP4-00, Washington, D.C.
American Association of State Highway and Transportation Officials (AASHTO). (1998c). “Method for determining the permanent deformation and fatigue cracking characteristics of hot mix asphalt (HMA) using the simple shear test (SST) device.” AASHTO Provisional Standards TP7-94, Washington, D.C.
American Association of State Highway and Transportation Officials (AASHTO). (2000). “Method for determining the rheological properties of asphalt binder using a dynamic shear rheometer (DSR)” AASHTO Provisional Standards TP5-98, Washington, D.C.
Bahia, H. U. (2000). “Recommendations for mixing and compaction temperatures of modified binders.” Draft Topical Rep. for NCHRP Study No. 9-10, National Cooperative Highway Research Program, Washington, D.C.
Curray, J. R.(1956). “Analysis of two dimensional orientation data.” J. Geol., 64, 117–131.
Masad, E., Muhunthan, B., Shashihar, N., and Harman, T. (1998). “Aggregate orientation and segregation in asphalt concrete.” Geotechnical Special Publication No. 85, ASCE, Reston, Va., 69–80.
Shenoy, A. V.(2001). “Determination of the temperature for mixing aggregates with polymer-modified asphalt.” Int. J. Pavement Eng., 2, 1–15.
Stuart, K. D. (2000a). “Methodology for determining compaction temperatures for modified asphalt binders” Draft FHWA Rep., Federal Highway Administration, McLean, Va.
Stuart, K. D. (2000b). “On the Superpave asphalt binder specification for fatigue cracking performance.” In-house FHWA Technical Memorandum, Federal Highway Administration, McLean, Va.
Tashman, L., Masad, E., Peterson, B., and Saleh, H.(2001). “Internal structure analysis of asphalt mixes to improve the simulation of superpave gyratory compaction to field conditions.” J. Assoc. Asphalt Paving Technol., 70, 605–645.
Information & Authors
Information
Published In
Copyright
Copyright © 2003 American Society of Civil Engineers.
History
Received: Dec 4, 2001
Accepted: Jul 10, 2002
Published online: Aug 15, 2003
Published in print: Sep 2003
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.