Predicting Vertical Acceleration in Vehicles through Road Roughness
Publication: Journal of Transportation Engineering
Volume 118, Issue 1
Abstract
This study investigated the use and suitability of the International Roughness Index (IRI) for predicting vertical acceleration in truck shipments at recommended highway speeds. The investigation resulted in the development of a mathematical procedure for predicting the expected power‐spectral‐density (PSD) vertical acceleration at a specific location on the truck bed as a function of IRI, pavement type and age, dynamic characteristics of the vehicle, and speed of travel. The data for this study were collected from 20 different sections of highway pavements using two devices: a profilometer, which recorded elevation profiles of the pavement sections, and an accelerometer, which measured the vertical acceleration in the rear of a tractor semitrailer truck bed traveling at one of three different speeds. A major result of this study is procedure for estimating the PSD vertical acceleration in the rear of the truck bed for selected pavement categories and truck speeds using only the pavement IRI and the vehicle transmissibility characteristics.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Antle, J. R. (1989). “Measurement of lateral and longitudinal vibration in commercial truck shipments,” thesis, presented to Michigan State University, at East Lansing, Mich., in partial fulfillment of the requirements for the degree of Master of Science.
2.
Bendat, J. S., and Piersol, A. G. (1971). Random data: Analysis and measurement procedures, Wiley Interscience, John Wiley and Sons, New York, N.Y., 9–13.
3.
Crandall, S. H., and Mark, W. D. (1983). Random vibration in mechanical systems. Academic Press, New York, N.Y., 1–53.
4.
Gillespie, T. D. (1985). Heavy truck ride, SP‐607. Society of Automotive Engineers, Warrendale, Pa., 13–36.
5.
Gillespie, T. D. (1986). Developments in road roughness measurement and calibration procedures. University of Michigan Transportation Research Institute, Ann Arbor, Mich.
6.
Gillespie, T. D., Sayers, M. W., and Segel, L. (1980). “Calibration of response‐type road roughness measuring systems.” Report 228, National Cooperative Highway Research Program (NCURP), Transportation Research Board, Washington, D.C.
7.
Marcondes, J., Singh, S. P., and Burgess, G. J. (1988). “Dynamic analysis of a less than truck load shipment.” Paper 88‐WA/EEP‐17, American Society of Mechanical Engineers, New York, N.Y.
8.
Marcondes, J. A. (1990). “Modeling Vertical Acceleration in Truck Shipments using the International Roughness Index for Pavements,” thesis, presented to Michigan State University, at East Lansing, Mich., in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
9.
Newland, D. E. (1984). An introduction to random vibration and spectral analysis, 2nd Ed., Longman, New York, N.Y., 118–120.
10.
Sayers, M. W. (1985). “Characteristic power spectral density functions for vertical and roll components of road roughness,” Proc., Symp. on Simulation Control of Ground Vehicles and Transp. Systems, American Society of Mechanical Engineers, New York, N.Y.
11.
Sayers, M. W. (1989). Profiles of roughness. University of Michigan Transportation Research Institute, Ann Arbor, Mich.
12.
Sayers, M. W., Gillespie, T. D., and Paterson, D. O. (1986a). “Guidelines for Conducting and Calibrating Road Roughness Measurements.” Word Bank Tech. Paper No. 46, World Bank, Washington, D.C., 31–40.
13.
Sayers, M. W., Gillespie, T. D., and Queiroz, C. A. V. (1986b). “The international road roughness experiment—establishing correlation and calibration standard for measurements.” World Bank Tech. Paper No. 45, World Bank, Washington, D.C., 25–96.
14.
Tevelow, F. L. (1983). The military logistical transportation vibration environment: Its characterization and relevance to MIL‐STD fuze vibration testing. U.S. Army Electronics Research and Development Command, Harry Diamond Laboratories, Adelphi, Md., 24–54.
Information & Authors
Information
Published In
Copyright
Copyright © 1992 ASCE.
History
Published online: Jan 1, 1992
Published in print: Jan 1992
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.