Evaluation of Errors in Automated Pavement‐Distress Data Acquisition
Publication: Journal of Transportation Engineering
Volume 117, Issue 2
Abstract
The extent of degradation and decay of transportation infrastructure has created new demands on maintenance management systems. This, in turn, has emphasized the need for accurate condition assessment data for use in infrastructure management. At the same time, technological advances in automated inspection systems provide the opportunity to automate the collection of surface condition data. The effect of the technology on accuracy has not been previously evaluated. This paper evaluates the data‐acquisition component of two automated optical technologies and identifies the main sources of error. Simulated longitudinal and transverse cracks are used to illustrate the results. The simulations indicate that correction factors are important to compensate for errors due to resolution and coverage limitations. Therefore, on a crack‐by‐crack basis, most technologies will perform poorly. When cracks are uniformly distributed, equipment with high resolution but poor coverage provides more accurate estimates of cracking extent but has more variability than equipment with good coverage. Finally, the results indicate that the inherent variability in the location, width, and length of cracks may lead to significant error.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
“The AASHTO road test: Report 5 pavement research.” (1962). Special Report 61E, Highway Research Board, Nat. Res. Council, Washington, D.C.
2.
Bomar, L. C., Home, W. F., Brown, D. R., Smart, P. E., and Smart, J. L. (1988). “A method to determine deteriorated areas in portland cement concrete pavements.” Final Report NCHRP Report 304, Gulf Research, Nat. Cooperative Highway Res. Prog., Nat. Res. Council, Washington, D.C.
3.
Butler, B. C., Jr. (1989). “Pavement surface distress segmentation using real time imaging.” Proc. 1st Int. Conf. on Applications of Advanced Tech. to Transp., C. T. Hendrickson and K. Sinha, eds., ASCE, 39–45.
4.
“Collection and use of pavement condition data.” (1981). Synthesis of Highway Practice 76, Nat. Cooperative Highway Res. Program, Nat. Res. Council, Washington, D.C.
5.
Cox, G., Curphey, D., Fronek, D., and Wilson, J. (1986). “Remote video sensing of highway pavements at road speeds: Using the Motorola 68020 microprocessor.” Microcomputers in Civ. Engrg., 1(1), 1–12.
6.
Fukuhara, T., Terada, K., Nagao, M., Kasahara, S., and Ichihashi, S. (1989). “Automatic pavement distress survey system.” Proc., 1st Int. Conf. on Applications of Advanced Tech. to Transp., C. T. Hendrickson and K. Sinha, eds., ASCE, 33–38.
7.
Haas, C., Shen, H., and Haas, R. (1985). “ADDA System 1 (Automated Distress Data Acquisition and Evaluation System.” Final Report OJTCRP Project #21156, Ontario Ministry of Transport, Ottawa, Ontario, Canada, Aug.
8.
Hudson, W. R., and Haas, R. (1978). Pavement management systems. McGraw‐Hill, New York, N.Y.
9.
Humplick, F. (1989). “Theory and methods of analyzing infrastructure inspection output: Application to highway surface condition evaluation,” dissertation presented to the Massachusetts Institute of Technology, at Cambridge, Mass., in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
10.
Humplick, F., and McNeil, S. (1988). Evaluation of automated inspection systems for pavement surface distress. Massachusetts Inst. of Tech., Cambridge, Mass., Jan.
11.
Mahler, D. (1985). “Final design of automated pavement crack measurement instrumentation from a survey vehicle.” Final Report DTFH 61‐86‐C‐001, Federal Highway Admin., Washington, D.C., May.
12.
Maser, K. R., and Schott, J. (1981). Automated visual imaging for high speed inspection of large structures. Nat. Sci. Found., Washington, D.C., Jul.
13.
McNeil, S., and Humplick, F. (1990). “Errors in automated pavement surface distress data collection.” Proc. Int. Conf. on Surface Characteristics, ASTM 343–354.
14.
Mendelsohn, D. H. (1984). “Automated pavement crack detection: An assessment of leading technologies.” Development Paper for FHWA DTFH61‐84‐C‐00077, EKTRON Applied Imaging, Bedford, Mass.
15.
Shahin, M., O., and Kohn, S. (1981). “Pavement maintenance for roads and parking lots.” Technical Report M‐294, Constr. Engrg. Res. Lab., U.S. Army Corps of Engrs., Champaign, Ill., Dec.
16.
“Standard nomenclature and definition of pavement components and deficiencies.” (1970). Special Report 113, Nat. Academy of Sci., Washington, D.C.
17.
Tang, W. H. (1973). “Probabilistic updating of flaw information.” J. Testing and Eval., 1(6), 459–467.
Information & Authors
Information
Published In
Copyright
Copyright © 1991 ASCE.
History
Published online: Mar 1, 1991
Published in print: Mar 1991
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.