Effectiveness of Some Strengthening Options for Masonry-Infilled RC Frames with Open First Story
Publication: Journal of Structural Engineering
Volume 135, Issue 8
Abstract
Strengthening of masonry-infilled reinforced concrete (RC) frame buildings with an open first story is needed because of the inherent irregularity in such buildings resulting in their poor performance as observed during several past earthquakes. In the present study, several strengthening schemes were evaluated for their effectiveness in improving the performance of such buildings, based on nonlinear analyses of typical RC frames. Instead of using predetermined multiplying factors for designing the first-story members for higher forces as recommended in some national codes, a rational method was developed for the calculation of the required increase in strength of open first-story columns. Other strengthening schemes studied were providing additional columns, diagonal bracings, and lateral buttresses in the open first story. Code methods were found to increase only lateral strength (and not the ductility) of such frames; whereas, some of the alternate schemes studied were found to improve both lateral strength and ductility for improved seismic performance.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers acknowledge the financial assistance provided by the Ministry of Human Resource Development (MHRD), Government of India, in the research work.
References
Architectural Institute of Japan (AIJ). (1995). “Preliminary reconnaissance report of the 1995 Hyogoken-Nanbu earthquake.” Tokyo.
Asteris, P. G. (2003). “Lateral stiffness of brick masonry infilled plane frames.” J. Struct. Eng., 129(8), 1071–1079.
Bulgarian Seismic Code. (1987). “Code for design of buildings and structures in seismic regions.” Bulgarian Academy of Science Committee of Territorial and Town System at the Council of Ministers, Sofia, Bulgaria.
Bureau of Indian Standards (BIS). (2002). “Indian standard criteria for earthquake resistant design of structures. Part 1: General provisions and buildings.” IS 1893, Fifth Revision, New Delhi, India.
Crisafulli, F. J., Carr, A. J., and Park, R. (2000a). “Analytical modeling of infilled frame structures—A general review.” New Zealand Nat. Soc. Earthquake Eng. Bull, 33(1), 30–47.
Crisafulli, F. J., Carr, A. J., and Park, R. (2000b). “Capacity design of infilled frame structures.” Proc., 12th World Conf. on Earthquake Engineering (CD-ROM), Auckland, New Zealand, Paper 0221.
Das, D., and Murty, C. V. R. (2004). “Brick masonry infills in seismic design of RC framed buildings. Part 2: Behavior.” Indian Concr. J., 78(8), 31–38.
Das, S., and Nau, J. M. (2003). “Seismic design aspects of vertically irregular reinforced concrete buildings.” Earthquake Spectra, 19(3), 455–477.
Dasgupta, P. (2000). “Effect of confinement on strength and ductility of large RC hollow sections.” MTech thesis, Dept. of Civil Engineering, Indian Institute of Technology Kanpur, Kanpur, India.
Dolšek, M., and Fajfar, P. (2001). “Soft storey effects in uniformly infilled reinforced concrete frames.” J. Earthquake Eng., 5(1), 1–12.
El-Dakhakhni, W. W., Elgaaly, M., and Hamid, A. A. (2003). “Three-strut model for concrete masonry-infilled steel frames.” J. Struct. Eng., 129(2), 177–185.
European Committee of Standardization (CEN). (2003). “Design of structures for earthquake resistance. Part 1: General rules, seismic actions and rules for buildings.” prEN1998-1, Eurocode 8, Brussels, Belgium.
Fardis, M. N., Negro, P., Bousias, S. N., and Colombo, A. (1999). “Seismic design of open-storey infilled RC buildings.” J. Earthquake Eng., 3(2), 173–197.
Fardis, M. N., and Panagiotakos, T. B. (1997). “Seismic design and response of bare and masonry-infilled reinforced concrete buildings. Part II: Infilled structures.” J. Earthquake Eng., 1(3), 475–503.
FEMA. (2000). “Prestandard and commentary for the seismic rehabilitation of buildings.” FEMA 356, Washington, D.C.
Gergely, P., White, R., and Mosalam, K. (1994). “Evaluation and modeling of infilled frames.” Proc., NCEER Workshop on Seismic Response of Masonry Infills, National Center for Earthquake Engineering Research, Buffalo, N.Y., 1.51–1.56.
Jain, S. K., Lettis, W. R., Murty, C. V. R., and Bardet, J. P., ed. (2002). “Bhuj, India earthquake of January 26, 2001 reconnaissance report.” Earthquake Spectra, 18(S1), 149–185.
Kaushik, H. B., and Jain, S. K. (2007). “Impact of great December 26, 2004 Sumatra earthquake and tsunami on structures in Port Blair.” J. Perform. Constr. Facil., 21(2), 128–142.
Kaushik, H. B., Rai, D. C., and Jain, S. K. (2006). “Code approaches to seismic design of masonry infilled reinforced concrete frames: A state-of-the-art review.” Earthquake Spectra, 22(4), 961–983.
Kaushik, H. B., Rai, D. C., and Jain, S. K. (2007). “Stress-strain characteristics of clay brick masonry under uniaxial compression.” J. Mater. Civ. Eng., 19(9), 728–739.
Madan, A., Reinhorn, A. M., Mander, J. B., and Valles, R. E. (1997). “Modeling of masonry infill panels for structural analysis.” J. Struct. Eng., 123(10), 1295–1302.
Mehrabi, A. B., Shing, P. B., Schuller, M. P., and Noland, J. L. (1996). “Experimental evaluation of masonry infilled RC frames.” J. Struct. Eng. 122(3), 228–237.
Michailidis, C. N., Kappos, A. J., and Stylianidis, K. C. (1996). “Irregularities in the seismic response of R/C buildings due to the presence of masonry infills.” Proc., 1st Int. Symp. Earthquake Resistant Engineering Structures 96, Computational Mechanics Publications, U.K.
Negro, P., and Colombo, A. (1997). “Irregularities induced by nonstructural masonry panels in framed buildings.” Eng. Struct., 19(7), 576–585.
Park, R., and Paulay, T. (1975). Reinforced concrete structures, Wiley, New York.
Paulay, T., and Priestley, M. J. N. (1992). Seismic design of reinforced concrete and masonry buildings, Wiley, New York.
Razvi, S., and Saatcioglu, M. (1999). “Confinement model for high strength concrete.” J. Struct. Eng., 125(3), 281–289.
Selvakoodalingam, B., Perumal Pillai, E. B., and Govindan, P. (1999). “Strengthening of RC infilled frame with opening.” Concr. Int., 21(11), 37–42.
Stafford-Smith, B. (1962). “Lateral stiffness of infilled frames.” J. Struct. Div. 88(ST6), 183–199.
Stafford-Smith, B., and Carter, C. (1969). “A method of analysis of infilled frames.” Proc. Inst. of Civ. Eng. (UK) 44, 31–48.
Standards Institution of Israel (SII). (1995). “Design provisions for earthquake resistance of structures.” SI 413, Tel-Aviv, Israel.
Structural analysis program (SAP2000)—Advanced, static and dynamic finite element analysis of structures. (2004). Computers and Structures, Inc., Berkeley, Calif.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Mar 21, 2007
Accepted: Mar 17, 2009
Published online: Jul 15, 2009
Published in print: Aug 2009
Notes
Note. Associate Editor: Panos Tsopelas
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.