Drift Capacity of Rectangular Reinforced Concrete Columns with Low Lateral Confinement and High-Axial Load
Publication: Journal of Structural Engineering
Volume 129, Issue 6
Abstract
This paper presents the experimental results obtained from the testing of nine 1:3 scale square-shaped column specimens. Characteristics of the specimens are low-lateral confinement, low-to-moderate shear span, and high-axial load. Detailing of the transverse reinforcement includes both 90° and 135° hooks. Specimens with low-shear span failed under shear in a brittle manner. Flexural failures were observed in specimens with moderate shear span and having a lateral confinement ratio of 0.003. Lateral confinement has significant influence on the ultimate drift, of which an increase from 0.001 to 0.003 could increase the ultimate drift capacity by up to 100%. Seismic performance of columns with low-to-moderate shear span may not be accurately reflected by the ductility factor. Better representation is provided by the ultimate drift ratio, and can be estimated by an empirical equation. The use of 90° hooks in detailing the transverse reinforcement leads to a 40% reduction on the ultimate drift capacity. Guidelines are also given to estimate the corresponding reduction on the ductility factor.
Get full access to this article
View all available purchase options and get full access to this article.
References
Arakawa, T., Arai, Y., Mizoguchi, M., and Yoshida, M.(1989). “Shear resisting behavior of short reinforced concrete columns under biaxial bending-shear.” Trans. Jpn. Concrete Inst., 11, 317–324.
Aycardi, L. E., Mander, J. B., and Reinhorn, A. M.(1994). “Seismic resistance of reinforced concrete frame structures designed only for gravity loads, experimental performance of subassemblages.” ACI Struct. J., 91(5), 552–563.
Azizinamini, A., Johal, L. S., Hanson, N. W., Musser, D. W., and Corley, W. G. (1988). “Effects of transverse reinforcement on seismic performance of columns—A partial parametric investigation.” Project No CR-9617, Construction Technology Laboratories, Skokie, Ill.
Beres, A., Pesiki, S. P., White, R. N., and Gergely, P.(1996). “Implications of experiments on the seismic behavior of gravity load designed RC beam-to-column connections.” Earthquake Spectra, 12(2), 185–198.
Inoue, N., Inai, E., Wada, A., Kuramoto, H., Fujimoto, I., and Ilba, M. (2000). “A shaking table test of reinforced concrete frames designed under old seismic regulations in Japan.” Proc., 12th World Conf. on Earthquake Engineering, New Zealand Society for Earthquake Engineering, Auckland, New Zealand.
King, J. W. H.(1946). “The effect of lateral reinforcement in reinforced concrete columns.” Struct. Eng., 24(7), 355–388.
Kunnath, S. K., Hoffmann, G., Reinhorn, A. N., and Mander, J. B.(1995a). “Gravity-load-designed reinforced concrete buildings. I: Seismic evaluation of existing construction.” ACI Struct. J., 92(3), 343–355.
Kunnath, S. K., Hoffmann, G., Reinhorn, A. N., and Mander, J. B.(1995b). “Gravity-load-designed reinforced concrete buildings. II: Evaluation of detailing enhancements.” ACI Struct. J., 92(4), 470–478.
Lam, S. S. E., Wu, B., Wong, Y. L., and Chau, K. T. (2000). “Ultimate drift ratio of rectangular reinforced concrete column in Hong Kong.” Proc., Int. Conf. on Advances in Structural Dynamics, J. M. Ko and Y. L. Xu, eds., December 13–15, Elsevier, Hong Kong, 891–898.
Lam, S. S. E., Wu, B., Wong, Y. L., and Chau, K. T. (2001). “Behavior of rectangular columns with low lateral confinement ratio.” Proc., Int. Conf. on Structural Engineering, Mechanics and Computation, A. Zingoni, ed., Elsevier, Cape Town, South Africa, 977–984.
Mo, Y. L., and Hwang, M. L.(1999). “New configuration of lateral steel for RC columns.” Pract. Period. Struct. Des. Constr., 4(3), 111–118.
Nakata, S., Sproul, T., and Penzien, J. (1978). Mathematical modelling of hysteresis loops for reinforced concrete columns, UCB/EERC-78/11.
Park, R., and Paulay, T. (1975). Reinforced concrete structures, Wiley, New York.
Paulay, T., and Priestley, M. J. N. (1992). Seismic design of reinforced concrete and masonry buildings, Wiley, New York.
Pincheira, J. A., Dotiwala, F. S., and D’Souza, J. T.(1999). “Seismic analysis of older reinforced concrete columns.” Earthquake Spectra, 15(2), 245–272.
Saatcioglu, M. (1991). “Deformability of reinforced concrete columns.” Earthquake resistant concrete structures—Inelastic response and design, ACI SP-127-10, 421–452.
Sakai, K., and Sheikh, S. A.(1989). “What do we know about confinement in reinforced concrete columns? (A critical review of previous work and code provisions).” ACI Struct. J., 86(2), 192–207.
Scott, B. D., Park, R., and Priestley, M. J. N.(1982). “Stress-strain behavior of concrete confined by overlapping hoops at low and high strain rates.” ACI Struct. J., 87, 13–27.
Soesianawati, M. T., Park, R., and Priestley, M. J. N. (1986). “Limited ductility design of reinforced concrete columns.” Rep. 86-10, Dept. of Civil Engineering, Univ. of Canterbury, Christchurch, New Zealand.
Tassios, T. P., Moretti, M., and Bezas, A.(1996). “On the behavior and ductility of reinforced concrete coupling beams of shear walls.” ACI Struct. J., 93(6), 711–720.
Taylor, A. W., Kuo, C., Wellenius, K., and Chung, D. (1997). “A summary of cyclic lateral load tests on rectangular reinforced concrete columns.” NISTIR 5984, Building and Fire Research Laboratory, National Institute of Standards and Technology, Gaithersburg, Md. 20899.
Watson, S., and Park, R. (1989). “Design of reinforced concrete frames of limited ductility.” Rep. 89-4, Dept. of Civil Engineering, Univ. of Canterbury, Christchurch, New Zealand.
Wehbe, N., Saiidi, M., and Sanders, D.(1999). “Seismic performance of rectangular columns with moderate confinement.” ACI Struct. J., 96(2), 248–258.
Xiao, Y., Tomli, M., and Sakino, K.(1986). “Experimental study on design method to prevent shear failure of reinforced concrete short circular columns by confining in steel tube.” Trans. Jpn. Concr. Inst., 8, 535–542.
Yin, H., Irawan, P., Pan, T. C., and Lim, C. H. (2001). “Behaviour of full scale lightly reinforced concrete interior beam-column joints under reversed cyclic loading.” Proc., Int. Conf. on Structural Engineering, Mechanics and Computation, A. Zingoni, ed., Cape Town, South Africa, Elsevier, 985–992.
Zhou, X., Satoh, T., Jiang, W., Ono, A., and Shimizo, Y.(1987). “Behavior of reinforced concrete short column under high axial load.” Trans. Jpn. Concr. Inst., 9, 541–548.
Information & Authors
Information
Published In
Copyright
Copyright © 2003 American Society of Civil Engineers.
History
Received: Sep 25, 2001
Accepted: Aug 16, 2002
Published online: May 15, 2003
Published in print: Jun 2003
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.