Behavior of Brick Masonry Under Cyclic Compressive Loading
Publication: Journal of Structural Engineering
Volume 115, Issue 6
Abstract
An experimental program was conducted to study the behavior of brick masonry under cyclic compressive loading. The envelope stress‐strain curve, the common point curve, and the stability point curve were established for brick masonry loaded both perpendicular and parallel to the bed joint. A general analytical expression is proposed for these curves which is found to provide reasonable fit with the experimental data. The variation of lateral strain with axial strain is also discussed.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Abrams, D., Noland, J., and Atkinson, R. (1985). “Response of clay unit masonry to repeated compressive forces.” Proc., 7th Int. Brick Masonry Conf., 565–576.
2.
Chen, S‐W. J., et al. (1978). “Cyclic loading tests of masonry single piers, volume 2—Height to width ratio of 1.” EERC Rept. No. 78/28, Univ. of California, Berkeley, Calif.
3.
Dhanasekar, M., Kleeman, P. W., and Page, A. W. (1985a). “Biaxial stress‐strain relations for brick masonry.” J. Struct. Engrg., ASCE, 111(5), 1085–1100.
4.
Dhanasekar, M., Page, A. W., and Kleeman, P. W. (1985b). “The failue of brick masonry under biaxial stresses.” Proc., Inst. of Civ. Engrs., Pt. 2, 79, 295–313.
5.
Gallegos, H., and Casabonne, C. (1983). “Cyclic test of three different types of masonry walls.” Proc., 3rd Can. Masonry Symp., 33.1–33.15.
6.
Grimm, T. (1975). “Strength and related properties of brick masonry.” J. Struct. Engrg., ASCE, 101(1), 217–231.
7.
Hidalgo, P. A., et al. (1978). “Cyclic loading tests of masonry single piers, vol. 1—Height to width ratio of 2.” EERC Rept. No. 78/27, Univ. of California, Berkeley, Calif.
8.
Hidalgo, P. A., et al. (1979). “Cyclic loading tests of masonry single piers, vol. 3—Height to width ratio of 0.5.” EERC Rept. No. 79/12, Univ. of California, Berkeley, Calif.
9.
Hodgkinson, H. R., and Davies, S. (1982). “The stress/strain relationship of brickwork when stressed in directions other than normal to bed face.” Proc., 6th Int. Brick Masonry Conf., Rome, Italy, 290–299.
10.
Hsu, T. C. (1981). “Fatigue of plain concrete.” J. Amer. Concr. Inst., 78(4), 292–305.
11.
Jianguo, F., and Jingqian, X. (1986). “Experimental study of shear strength of reinforced masonry walls under cyclic loading.” Proc., 4th Can. Mas. Symp., 581–598.
12.
Karsan, I. K., and Jirsa, J. O. (1969). “Behavior of concrete under compressive loadings.” J. Struct. Engrg., ASCE, 95(12), 2543–2563.
13.
Lam, Y. (1980). “Behaviour of plain concrete under cyclic compressive loading.” Thesis presented to the Massachusetts Institute of Technology, at Cambridge, Mass., in partial fulfillment of the requirements for the degree of Master of Science.
14.
Macchi, G. (1982). “Behaviour of masonry under cyclic actions and seismic design.” General rept., Theme 3, Proc., 6th Int. Brick Masonry Conf., Rome, Italy.
15.
Mayes, R. L., Clough, R. W. (1975). “State‐of‐the‐art in seismic strength of masonry—An evaluation and review.” EERC Rept. No. 75—21, Univ. of California, Berkeley, Calif.
16.
Mayes, R. L., Omote.Y., and Clough, R. W. (1976a). “Cyclic shear tests of masonry piers, volume 1—Test results.” EERC Rept. No. 76—8, Univ. of California, Berkeley, Calif.
17.
Mayes, R. L., Omote, Y., and Clough, R. W. (1976b). “Cyclic shear tests of masonry piers, Volume 2—Analysis of test results.” EERC Rept. No. 76—16, Univ. of California, Berkeley, Calif.
18.
Page, A. W. (1982). “An experimental investigation of the biaxial strength of brick masonry.” Proc., Sixth Int. Brick Masonry Conf., Rome, Italy, 3–15.
19.
Pedreschi, R. F., and Sinha, B. P. (1982). “The stress/strain relationship of brickwork.” Proc., 6th Int. Brick Masonry, Conf., Rome, Italy, 321–334.
20.
Powell, B., and Hodgkinson, H. R. (1976). “Determination of stress/strain relationship of brickwork.” British Ceramic Res. Assoc, Stoke‐on‐Trent, U.K., Tn 249.
21.
Rilem Committee 36—RDL. (1984). “Long term random dynamic loading of concrete structures.” Matls. and Structs., 17(97), 1–28.
22.
Richardson, J., and Dawe, J. (1986). “Experimental investigation of masonry infilled steel frames subjected to cyclic racking loads.” Proc., 4th Can. Masonry Symp., 922–934.
23.
Shah, S. P., and Chandra, S. (1970). “Fracture of concrete subjected to cyclic and sustained loading.” J. Amer. Concr. Inst., 67(10), 816–825.
24.
Shing, P., et al. (1987). “Inelastic behaviour of masonry wall panels under inplane cyclic loads.” Proc., 4th North Amer. Masonry Conf., 42.1–42.14.
25.
Sinha, B. P., Gerstle, K. H., and Tulin, L. G. (1964). “Stress‐strain relations for concrete under cyclic loadings.” J. Amer. Concr. Inst., 61(2), 195–211.
26.
Sinha, B. P., and Pedreschi, R. (1983). “Compressive strength and some elastic properties of brickwork.” Int. J. Masonry Constr., 3(1), 19–25.
27.
Sveinsson, B. I., et al. (1981). “Evaluation of seismic design provisions for masonry in the United States.” EERC Rept. No. 81/10, Univ. of California, Berkeley, Calif.
28.
Turnsek, V., and Čačović, F. (1971). “Some experimental results on the strength of brick masonry walls.” Proc., Second Int. Brick Masonry Conf., H. W. H. West and K. H. Speed, eds., British Ceramic Res. Assoc., London, U.K. 149–156.
29.
Williams, D., and Scrivener, J. C. (1973). “Response of reinforced masonry shear I walls to static and dynamic cyclic loading.” Proc., 5th World Conf. on Earthquake Engrg., Rome, Italy.
Information & Authors
Information
Published In
Copyright
Copyright © 1989 ASCE.
History
Published online: Jun 1, 1989
Published in print: Jun 1989
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.