Design Model for Piles in Jointless Bridges
Publication: Journal of Structural Engineering
Volume 114, Issue 6
Abstract
Piles in integral abutment bridges (jointless bridges) are subjected to lateral movement due to thermal expansion and contraction of the superstructure. The reduction in vertical load‐carrying capacity of the piles due to lateral movement is an important parameter in designing the piles and in setting length limits for the jointless bridge. A simplified design method for analyzing piles in integral abutment bridges is presented. The model was developed from previous analytical models and observations of pile behavior. Two failure modes for a pile are examined: the slip mechanism, where the pile slips through the soil; and the lateral mechanism where the failure of the soil‐pile system is associated with lateral movement of the pile. Equations for determining the ultimate load for the pile for each mechanism are obtained. Results predicted by the simplified model are compared to results from a nonlinear finite element program and shown to be conservative with respect to the finite element model.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Chajes, A. (1974). Principles of structural stability theory. Prentice‐Hall, Inc., Englewood Cliffs, N.J.
2.
“Commentary of plastic design in steel.” (1961). Manuals of engineering practice, No. 41. ASCE, New York, N.Y.
3.
Davisson, M. T. (1963). “Estimating buckling loads for piles.” Proc. Second Pan American Conference on Soil Mechanics and Foundation Engrg., 1, 351–71.
4.
Davisson, M. T. (1970). “Lateral load capacity of piles.” Transp. Res. Record No. 333, Transp. Res. Board, Nat. Res. Council, Nat. Academy of Sciences, Washington, D.C.
5.
Emerson, M. (1981). “Thermal movements of concrete bridges; Field measurement and methods of prediction.” Joint sealing and bearing systems for concrete structures. Special Publication 70, American Concrete Inst., Detroit, p. 77–102.
6.
Greimann, L. F., Wolde‐Tinsae, A. M., and Yang, P. S. (1983). “Skewed bridges with integral abutments.” Bridges and culverts, Transp. Res. Record, No. 903, Transp. Res. Board, Nat. Res. Council, Nat. Academy of Sciences, Washington, D.C.
7.
Greimann, L. F., Yang, P. S., and Wolde‐Tinsae, A. M. (1986). “Nonlinear analysis of integral abutment bridges.” J. Struct. Engrg., ASCE, 112(10), 2263–2280.
8.
Ha, N. B., and O'Neill, M. W. (1981). Field study of pile group action, Appendix A, Federal Highway Administration, D.C.
9.
Highway structures design handbook, Vol. 1. (1965). United States Steel Corporation, Pittsburgh, Pa.
10.
Integral, no‐joint structures and required provisions for movement. (1980). Federal Highway Administration, D.C.
11.
Jorgenson, J. L. (1981). Behavior of abutment piles in an integral abutment bridge. Engineering Experiment Station, North Dakota State University, Fargo, N.D.
12.
Neal, B. G. (1963). The plastic methods of structural analysis, 2nd Ed., John Wiley and Sons, Inc., N.Y.
13.
Poulos, H. G., and Davies, E. H. (1980). Pile foundation analysis and design. John Wiley and Sons, Inc., N.Y.
14.
Prakash, S. (1962). “Behavior of pile groups subjected to lateral loads,” thesis presented to the University of Illinois, at Urbana, Ill. in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
15.
Reddy, A. S., and Valsangkar, A. J. (1970). “Buckling of fully and partially embedded piles.” J. Soil Mech. and Foundation Div., ASCE, 96(SM6), 1951–1965.
16.
Toakley, A. R. (1965). “Buckling loads for elastically supported struts.” J. Engrg. Mech. Div., ASCE, 91(EM3), 205–231.
17.
Tomlison, M. J. (1957). “The adhesion of piles driven in clay soils.” Proc. 4th Int. Conference on Soil Mechanics and Foundation Engrg., ASCE, 2, 66.
18.
Wolde‐Tinsae, A. M., Greimann, L. F., and Yang, P. S. (1982). “Nonlinear pile behavior in integral abutment bridges.” Report 1501, Engrg. Res. Inst., Iowa State Univ., Ames, IA.
19.
Wolde‐Tinsae, A. M., Greimann, L. F., and Johnson, B. (1983). “Performance of integral abutment bridges.” J. Int. Assoc. for Bridge and Struct. Engrg., 1, (P‐S8‐83), 17–34.
20.
Wolde‐Tinsae, A. M., Greimann, L. F., and Yang, P. S. (1988). “End‐bearing piles in jointless bridges.” J. Struct. Engrg., ASCE (in press).
Information & Authors
Information
Published In
Copyright
Copyright © 1988 ASCE.
History
Published online: Jun 1, 1988
Published in print: Jun 1988
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.