Drag Coefficients of Latticed Towers
Publication: Journal of Structural Engineering
Volume 112, Issue 2
Abstract
Recent building codes require that wind loads be determined by multiplying a calculated velocity pressure by the drag coefficient of the structure. It is suggested that the drag coefficients given in the codes for latticed towers are conservative. To determine appropriate drag coefficients for square self‐supported latticed towers two models were constructed and tested in a wind tunnel. Drag forces of the two models with and without heel angles as well as half of one model and tilting to different angles of the other model were determined. Results are analyzed and drag coefficients are calculated and compared to other published test results and to the ANSI A58.1 Code. Recommended equations are given for determining the drag coefficient of latticed towers with solidity ratios in a given range. For the wind direction on the diagonal axis of the tower the drag was found to be independent of the solidity ratio and, therefore, a multiplier is recommended. A multiplier is also recommended for towers with legs that have a heel angle.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
“Minimum Design Loads for Buildings and Other Structures,” American National Standards Institute, ANSI Standard A58.1‐1982, New York, NY, 1982.
2.
Bayar, D. C., “Design of Radio Relay Towers to Satisfy Building Code Requirements,” Proceedings, 3rd US National Conference Wind Engineering Research, Univ. of Florida, Gainesville, FL, Feb. 26–Mar. 1, 1978, pp. 465–473.
3.
Cermak, J. E., Peterka, J. A., Bienkiewicz, B., and Hosoya, N., “Wind Forces on Microwave Antennas, Equipment and Towers,” Colorado State Univ., Report CER82‐83JEC‐JAP‐BB‐NH43, Project 2‐95380, Fort Collins, CO, 1983.
4.
Cohen, E., Vellozzi, J., and Suh, S., “Calculations of Wind Forces and Pressures on Antennas,” Annals of the New York Academy of Sciences, Vol. 116, Art. 1, June, 1964, pp. 161–221.
5.
Cowdrey, C. E., “Aerodynamic Forces and Moments on Models of Two Sections of a Forth Crossing Tower,” NPL/Aero Special Report 027, June, 1965.
6.
Flaschbart, O., and Winter, H., “Model Research on the Wind Loading of Lattice Structures,” translated from German by B. L. Tucker, Sandia Corp. AFSWP‐464, Albuquerque, NM, 1934–35.
7.
Flint, A. R., and Smith, B. W., “The Development of the British Draft Code of Practice for the Loading of Lattice Towers,” (July 1779), Wind Engineering, Proceedings of the 5th International Conference, held at Fort Collins, CO, in July, 1979,
published by Pergamon Press, 1980, pp. 1293–1304.
8.
Fujimoto, M., et al., “On Wind‐Proof Performance of Latticed Steel Towers,” Wind Engineering, Proceedings of the Fifth International Conference, held at Fort Collins, CO, in July, 1979,
published by Pergamon Press, 1980, pp. 1203–1216.
9.
Georgiou, P. N., and Vickery, B. J., “Wind Loads on Building Frames,” Wind Engineering, Proceedings of the Fifth International Conference, held at Fort Collins, CO, in July 1979,
published by Pergamon Press, 1980, pp. 421–433.
10.
Pagon, W. Watters, “Wind Forces on Structures: Plate Girders and Trusses,” Journal of the Structural Engineering Division, Vol. 84, No. ST4, 1958.
11.
Tests at Daniel Guggenheim Airship Institute, Akron, OH.
12.
“Wind Loading on Lattice Towers,” N.M.I., Report on Project P/352003, to be published.
13.
Whitbread, R. F., “The Influence of Shielding on the Wind Forces Experienced by Arrays of Lattice Frames,” Wind Engineering, Proceedings of the 5th International Conference, held at Fort Collins, CO, in July, 1979,
published by Pergamon Press, 1980, pp. 405–420.
14.
Woodhouse, W. B., “Wind Pressure on Latticed Towers,” Journal of the Institute of Electrical Engineering, Vol. 77, 1935, pp. 189–196.
Information & Authors
Information
Published In
Copyright
Copyright © 1986 ASCE.
History
Published online: Feb 1, 1986
Published in print: Feb 1986
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.