Perimeter Load Transfer in Model Drilled Shafts Formed under Slurry
Publication: Journal of Geotechnical Engineering
Volume 120, Issue 12
Abstract
Experimental laboratory‐scale studies were conducted on the effect of the use of various mineral and polymer drilling slurries on the perimeter load transfer in drilled shafts in saturated sand. Parallel measurements were also made of the rheological properties of the slurries studied in order to develop ranges of slurry control properties consistent with predictable load transfer. Polymer slurries, mixed in medium to high doses, were found to be as effective as the more familiar mineral slurries in the development of load transfer. No slurry, however, produced the magnitude of perimeter load transfer that was developed on model drilled shafts constructed by inserting casing ahead of the drill in medium‐dense, saturated sand and withdrawing the casing as the simulated concrete was placed.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
ABAQUS—finite element program, version 5.2. (1993). Hibbitt, Karlsson and So‐rensen, Inc., Providence, R.I.
2.
Cernak, B. (1973). “The time effect of suspension on the behavior of piers.” Proc., Sixth Eur. Conf. on Soil Mech. and Found. Engrg., Vienna, Austria, 1.1, 111–114.
3.
Cernak, B., Dvorak, A., Hlavacek, J., Klein, K., and Petrasek, J. (1973). “New approaches to problems of bearing capacity and settlement of piles.” Proc., Eighth Int. Conf. on Soil Mech. and Found. Engrg., USSR Society for Soil Mechanics, Moscow, USSR, 2.1, 67.
4.
Chambers, J., Cleveland, W. S., Kleiner, B., and Tukey, P. A. (1983). Graphical methods for data analysis, Duxbury Press, Boston, Mass.
5.
Cooke, R. W. (1979). “Load transfer from bored, cast‐in‐situ piles in London clay.” ASTM STP 670, behavior of deep foundations, Raymond Lundgren, ed., ASTM, Philadelphia, Pa., 250–263.
6.
Farmer, I. W., and Goldberger, M. (1969). Effect of bentonite on the skin friction of bored piles. Cementation Research, Ltd., London, U.K.
7.
Fleming, W. G. K., and Sliwinski, Z. J. (1977). “The use and influence of bentonite in bored pile construction.” CIRIA Rep. PG3, Construction Industry Research and Information Association, London, U.K.
9.
Holden, J. C. (1984). “Construction of bored piles in weathered rocks, part 4: bentonite construction procedures.” Tech. Rep. No. 69, Road Construction Authority of Victoria, Kew, Victoria, Australia.
10.
Kheng, H. W. (1989). Rheological and physico‐chemical properties of palygorskite and anionic polyacrylamide polymer slurries used in drilled shaft construction, PhD thesis, University of Florida, Gainsville, Fla.
11.
Majano, R. E. (1992). Effect of mineral and polymer slurries on perimeter load transfer in drilled shafts, PhD thesis, University of Houston, Houston, Tex.
12.
Majano, R. E., and O'Neill, M. W. (1993). “Effect of dosage and exposure time of slurries on perimeter load transfer in bored piles.” Proc., Second Int. Geotech. Seminar on Deep Found. on Bored and Auger Piles, A. A. Balkema, Rotterdam, The Netherlands, 207–212.
13.
O'Neill, M. W., and Reese, L. C. (1970). “Behavior of axially loaded drilled shafts in Beaumont clay.” Rep. No. 89‐8, Center for Highway Research, University of Texas, Austin, Tex.
14.
Pells, P. J. N., Douglas, D. J., Rodway, B., Thorne, C, and McMahon, B. K. (1978). “Design loadings for foundations in shale and sandstone in the Sydney Region.” Australian Geomech. J., 2, 31–38.
15.
Reese, L. C, and O'Neill, M. W. (1988). “Drilled shafts: construction procedures and design methods.” Rep. No. FHWA‐HI‐88‐042, Federal Highway Administration, Washington, D.C.
16.
Stas, C. V., and Kulhawy, F. H. (1984). “Critical evaluation of design methods for foundations under axial uplift and compression loading.” EPRI Rep. EL‐3771, Cornell University Research Project 1493‐1, Electric Power Research Institute, Palo Alto, Calif.
17.
Touma, F. T., and Reese, L. C. (1972). “Load tests of instrumented drilled shafts constructed by the slurry displacement method.” Interagency Contract Rep. No. 108, Center for Highway Research, University of Texas, Austin, Tex.
18.
Tucker, K. L., and Reese, L. C. (1984). “The effect of bentonitic slurry on drilled shafts.” Res. Rep. 351‐1F, Center for Transportation Research, University of Texas, Austin, Tex.
19.
Wates, J. A. (1974). The effect of bentonite on the skin friction of piles and diaphragm walls, MSc thesis, University of Natal, Durban, South Africa.
20.
Wates, J. A., and Knight, K. (1975). “The effect of bentonite on the skin friction in cast‐in‐place piles and diaphragm walls. Proc., Sixth Reg. Conf. for Africa on Soil Mech. and Found. Engrg., African Regional Society on Soil Mechanics and Foundation Engineering, Cape Town, South Africa, 1, 183–188.
Information & Authors
Information
Published In
Copyright
Copyright © 1994 American Society of Civil Engineers.
History
Received: Sep 15, 1993
Published online: Dec 1, 1994
Published in print: Dec 1994
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.