Builders as Sources of Construction Innovation
Publication: Journal of Construction Engineering and Management
Volume 119, Issue 3
Abstract
Innovation in the construction industry occurs to a much greater extent than is usually recognized, and the sources of these innovations are more likely to be people working on‐site rather than manufacturers or research laboratories. Thirty‐four innovations to a single technology, the stressed‐skin panel, are examined; and it is found that the vast majority of these innovations were developed by builders rather than manufacturers. In addition, these builder innovations were significantly different from those produced by the manufacturers. The builders' innovations explicitly integrate the panel into the total building system; the manufacturers' innovations are confined to the panels themselves. A third finding is that manufacturers commercialized few of the builders' innovations—particularly avoiding those that involved connection of the panels to other systems—despite their potential for substantial improvement in the performance of the panel overall. The implications of these results is that users of technologies can be important sources of technological innovations and improvements, and the design of products can explicitly accommodate the need for changes and innovations on‐site.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Affordable residential land development: challenge and response, Vol. I a guide for local government and developers. (1988). Office of Policy Development and Research, U.S. Department of Housing and Urban Development, Washington, D.C.
2.
Andrews, S. (1989). Foam‐core panels and building systems. Cutter Information, Arlington, Mass.
3.
“Annual top 100 home builders.” (1992). Builder, (5), 190.
4.
Ayyub, B. M., and Haldar, A. (1985). “Decisions in construction operations.” J. Constr. Engrg. and Mgmt., ASCE, 111(4), 343–357.
5.
Barnes, B., and Ulin, D. R. (1984). “Liability for new products.” AWWA J., (Feb.), 44–47.
6.
Bobenhausen, B. (1989). “Energy codes in the Northeast: where are they now?” J. Light Constr., 7(4), 9.
7.
Building construction cost data 1989. (1989). R. S. Means, Kingston, Mass.
8.
Cainarca, G. C., Colombo, M. G., and Mariotti, S. (1989). “An evolutionary pattern of innovation diffusion: the case of flexible automation.” Res. Policy, 18, 59–86.
9.
Carlson, S. (1989). “Model code primer.” J. Light Constr., 7(4), 41–43.
10.
Census of construction industries. (1987). Bureau of the Census, U.S. Department of Commerce, Washington, D.C.
11.
Census of manufacturers: concentration ratios in manufacturing. (1982). Bureau of the Census, U.S. Department of Commerce, Washington, D.C.
12.
Chang, L., Hancher, D. E., Napier, T. R., and Kapolnek, R. G. (1988). “Methods to identify and assess new building technology.” J. Constr. Engrg. and Mgmt., ASCE, 114(3), 408–425.
13.
Construction review. (1990). U.S. Department of Commerce, (Mar.–Apr.).
14.
“Construction technology needs and priorities.” (1982). Rep. No. B‐3, Business Roundtable, New York, N.Y.
15.
Duke, R. (1988). Local building codes and the use of cost‐saving methods. U.S. Federal Trade Commission, Bureau of Economics, Washington, D.C.
16.
Feld, B. A. (1990). “The changing role of the user in the development of application software.” Working Paper, Sloan School of Management, Massachusetts Institute of Technology, Cambridge, Mass.
17.
Habermeier, K. F. (1990). “Product use and product improvement.” Res. Policy, 19, 271–283.
18.
“An historical evaluation of industrialized housing and building systems in the U.S.” (1968). The report of the President's committee on urban housing. Government Printing Office, Washington, D.C, 177–189.
19.
“Integrating construction resources and technology into engineering.” (1982). Rep. No. B‐1. Business Roundtable, New York, N.Y.
20.
International competition in services: banking, building, software, know‐how. (1987). U.S. Congress Office of Technology Assessment, Washington, D.C.
21.
Johnson, N., and Brown, W. B. (1986). “The dissemination and use of innovative knowledge.” J. Product Innovation Mgmt., 3, 127–135.
22.
Johnson, R. J. (1968). “Housing technology and housing costs.” The report of the President's committee on urban housing. Government Printing Office, Washington, D.C., 53–64.
23.
Kamien, M. I., and Schwartz, N. L. (1975). “Market structure and innovation: a survey.” J. of Economic Literature, 8, 1–37.
24.
Leonard‐Barton, D., and Rogers, E. M. (1981). “Horizontal diffusion of innovations: an alternative paradigm to the classical diffusion model.” Working Paper No. 1214. Sloan School of Management, Massachusetts Institute of Technology, Cambridge, Mass.
25.
Mansfield, E. (1968). Industrial research and technological change. Norton, New York, N.Y.
26.
Manski, C. F. (1973). “The implication of demand instability for the behavior of firms: the case of residential construction.” Working Paper No. 17, Joint Center for Urban Studies of MIT and Harvard University, Cambridge, Mass.
27.
Mitroff, I. I. (1968). “Simulating engineering design: a case study on the interface between the technology and social psychology of design.” IEEE Trans. on Engrg. Mgmt., 15(4), 178–187.
28.
Myers, S., and Marquis, D. G. (1969). Successful industrial innovations: a study of factors underlying innovation in selected firms. National Science Foundation, Washington, D.C.
29.
Nasbeth, L., and Ray, G. F. (1974). The diffusion of new industrial processes: an international study. Cambridge University Press, New York, N.Y.
30.
Nelkin, D. (1971). The politics of housing innovation. Cornell University Press, Ithaca, N.Y.
31.
Nisson, J. D. (1988). Residential building design & construction workbook, 2nd Ed., Cutter Information, Arlington, Mass.
32.
Polanyi, M. (1958). Personal knowledge: toward a post‐critical philosophy. University of Chicago Press, Chicago, Ill.
33.
“Practice points.” (1991). Progressive Arch., (12), 53.
34.
Quigley, J. M. (1982). “Residential construction.” Government and technical progress: a cross‐industry analysis, R. R. Nelson, ed., Pergamon Press, New York, N.Y., 361–410.
35.
Scherer, F. M. (1980). Industrial market structure and economic performance. Houghton Mifflin Co., Boston, Mass.
36.
Sims, C. A. (1968). “Efficiency in the construction industry.” The report of the President's committee on urban housing. Government Printing Office, Washington, D.C., 146–176.
37.
Slaughter, E. S. (1991). “‘Rapid’ innovation and the integration of components: comparison of user and manufacturer innovations through a study of residential construction,” PhD thesis, Massachusetts Institute of Technology, Cambridge, Mass.
38.
Strassman, W. P. (1978). Housing and building technology in developing countries. Michigan State University, East Lansing, Mich.
39.
A study of existing processes for the introduction of new products and technology into the building industry. (1979). Ehrenkrantz Group, U.S. Institute of Building Sciences, Washington, D.C.
40.
Tatum, C. B. (1986). “Potential mechanisms for construction innovation.” J. Constr. Engrg. and Mgmt., ASCE, 112(2), 178–191.
41.
Technology and the future of the U.S. construction industry. (1986a). AIA Press, Washington, D.C.
42.
Technology, trade and the U.S. residential construction industry. (1986b). U.S. Congress Office of Technology Assessment, Washington, D.C.
43.
Ventre, F. T. (1979). “Innovation in residential construction.” Technol. Rev., (Nov.), 51–59.
44.
Ventre, F. T. (1973). “Social control of technological innovation: the regulation of building technology,” PhD thesis, Massachusetts Institute of Technology, Cambridge, Mass.
45.
Vernon, R. (1971). Sovereignty at bay: the multinational spread of U.S. enterprises. Basic Books, New York, N.Y.
46.
von Hippel, E. (1988). The sources of innovation. Oxford University Press, New York, N.Y.
47.
von Hippel, E., and Finkelstein, S. N. (1979). “Analysis of innovation in automated clinical analyzers.” Sci. & Public Policy, 6(1), 24–37.
48.
Voss, C. A. (1985). “The role of users in the development of applications software.” J. Product Innovation Mgmt., 2, 113–121.
Information & Authors
Information
Published In
Journal of Construction Engineering and Management
Volume 119 • Issue 3 • September 1993
Pages: 532 - 549
Copyright
Copyright © 1993 American Society of Civil Engineers.
History
Received: Jun 10, 1992
Published online: Sep 1, 1993
Published in print: Sep 1993
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.