Lane-Distribution Models and Related Effects on the Capacity for a Three-Lane Freeway Section: Case Study in Italy
Publication: Journal of Transportation Engineering, Part A: Systems
Volume 143, Issue 10
Abstract
Traffic flow, its characteristics, and road quality service are usually estimated by using aggregated and averaged data from multiple lanes; however, in real experiences, there is significant variability in traffic-flow parameters across the different freeway lanes. Among the numerous factors that affect traffic distribution are vehicular composition, driver behavior, regulations about passing and overtaking, lane discipline, and designated lanes. Because these factors are very specific, the models and values for traffic distribution in a multilane freeway segment are highly sensitive to their national context. This study starts from an analysis of the capacity of a three-lane test segment within the Italian freeway system, and then examines the manner in which the flow and density vary across the freeway lanes. The analysis is restricted to up-to-capacity conditions and nonlinear regression models of the distribution relationships are calibrated for each lane, for both flow and density ratios, as a function of the total flow. The nonhomogeneous use of freeway lanes in Italy can be qualified and quantified through the trends found in these ratios, and then compared with similar internationally focused studies. This provides a useful interpretation of driver behavior, and is also a reference for calibrating traffic models, supporting design and operational processes and the implementation of intelligent transportation systems (ITSs) that are consistent with the national context.
Get full access to this article
View all available purchase options and get full access to this article.
References
Allen, B. L., Hall, F. L., and Gunter, M. A. (1985). “Another look at identifying speed-flow relationships on freeways.” Transp. Res. Rec., 1005, 54–64.
Amin, M. R., and Banks, J. H. (2005). “Variation in freeway lane use patterns with volume, time of day, and location.” Transp. Res. Rec., 1934, 132–139.
Beentjes, R. M. (2012). “Performance of rush-hour lanes and plus lanes: A study to behavioral factors and design factors.” M.S. thesis, Delft Univ. of Technology, Delft, Netherlands.
Brackstone, M., McDonald, M., and Wu, J. (1998). “Lane changing on the motorway: Factors affecting its occurrence, and their implications.” Proc., IET Conf., Institution of Engineering and Technology, Stevenage, U.K., 160–164.
Carter, M., Rakha, H., and Van Aerde, M. (1999). “Variability of traffic-flow measures across freeway lanes.” Can. J. Civil Eng., 26(3), 270–281.
Chow, A., Dadok, V., Dervisoglu, G., and Varaiya, P. (2008). “TOPL: Tools for operational planning of transportation networks.” Proc., ASME 2008 Dynamic Systems and Control Conf., American Society of Mechanical Engineers, New York, 1035–1042.
Cleveland, W. S. (1979). “Robust locally weighted regression and smoothing scatterplots.” J. Am. Stat. Assoc., 74(368), 829–836.
Cleveland, W. S., and Devlin, S. J. (1988). “Locally weighted regression: An approach to regression analysis by local fitting.” J. Am. Stat. Assoc., 83(403), 596–610.
Demarchi, S. H., and Setti, J. R. (2003). “Limitations of PCE derivation for traffic streams with more than one truck type.” Transportation Research Board 2003 Annual Meeting, Transportation Research Board, Washington, DC.
Dervisoglu, G., Gomes, G., Kwon, J., Muralidharan, A., Varaiya, P., and Horowitz, R. (2009). “Automatic calibration of the fundamental diagram and empirical observations on capacity.” Proc., 88th Transportation Research Board Annual Meeting, Vol. 15, Transportation Research Board, Washington, DC.
Duret, A., Ahn, S., and Buisson, C. (2012). “Lane flow distribution on a three-lane freeway: General features and the effects of traffic controls.” Transp. Res. Part C: Emerg. Technol., 24, 157–167.
Elefteriadou, L., Torbic, D. T., and Webster, N. (1997). “Development of passenger car equivalents for freeways, two-lane highways and arterials.” Transp. Res. Rec., 1572, 51–58.
Gastaldi, M., Gecchele, G., and Rossi, R. (2014). “Estimation of annual average daily traffic from one-week traffic counts. A combined ANN-Fuzzy approach.” Transp. Res. Part C: Emerg. Technol., 47, 86–99.
Gecchele, G., Rossi, R., Gastaldi, M., and Caprini, A. (2011). “Data mining methods for traffic monitoring data analysis: A case study.” Procedia Soc. Behav. Sci., 20, 455–464.
Golias, J., and Tsamboulas, D. (1995). “Macrolevel estimation of highway lane usage.” J. Transp. Eng., 40–49.
Gunay, B. (2004). “An investigation of lane utilization on Turkish highways.” Proc. ICE Transp., 157(1), 43–49.
Hall, F. L., and Gunter, M. A. (1986). “Further analysis of the flow-concentration relationship.” Transp. Res. Rec., 1091, 1–9.
Heidemann, D. (1994). “Distribution of traffic to the individual lanes on multilane unidirectional roadways.” Proc., 2nd Int. Symp. on Highway Capacity, Vol. 1, Transportation Research Board, Washington, DC.
Hoogendoorn, S. P., and Bovy, P. H. L. (2001). “Platoon-based multiclass modeling of multilane traffic flow.” Networks Spatial Econ., 1(1/2), 137–166.
Hurdle, V. F., Merlo, M. I., and Robertson, D. (1997). “Study of speed-flow relationships on individual freeway lanes.” Transp. Res. Rec., 1591(1), 7–13.
Klunder, G. A., Jonkers, E., and Woldeab, Z. T. (2013). “The potential of connected cruise control in the Netherlands.” Proc., 16th Int. IEEE Conf. on Intelligent Transportation Systems, IEEE, New York, 833–838.
Knoop, V. L., Duret, A., Buisson, C., and van Arem, B. (2010). “Lane distribution of traffic near merging zones influence of variable speed limits.” Proc., 13th Int. IEEE Conf. on Intelligent Transportation Systems, IEEE, New York, 485–490.
Lee, J., and Park, B. B. (2010). “Lane flow distributions on basic segments of freeways under different traffic conditions.” Proc., Transportation Research Board 89th Annual Meeting, Transportation Research Board, Washington, DC.
Lynch, R. L., and Hamby, G. N. (1969). “Lateral distribution of traffic on a four-lane and six-lane section of I 75 south of Covington.”, Highways Kentucky Dept., Frankfort, KY.
MATLAB version 7.11 [Computer software]. MathWorks, Natick, MA.
McDonald, M., Brackstone, M., and Jeffery, D. (1994). “Simulation of lane usage characteristics on 3 lane motorways.” Proc., 27th Int. Symp. on Automotive Technology and Automation, Automotive Automation Ltd., Croydon, U.K., 365–372.
Motulsky, H., and Christopoulos, A. (2004). Fitting models to biological data using linear and nonlinear regression: A practical guide to curve fitting, Oxford University Press, Oxford, U.K.
Ni, D., Leonard, J. D., Jia, C., and Wang, J. (2016). “Vehicle longitudinal control and traffic stream modeling.” Transp. Sci., 50(3), 1016–1031.
Normann, O. K. (1942). “Results of highway capacity studies.” Pub. Roads, 23(4), 57–81.
Okura, I., and Somasundaraswaran, K. (1996). “Analysis of traffic distribution in three lane unidirectional freeway.” J. Infrastruct. Plann. Rev., 13, 885–892.
Pignataro, L. J. (1973). Traffic engineering: Theory and practice, Prentice Hall, Englewood Cliffs, NJ.
Pompigna, A., and Rupi, F. (2015). “Differences between HCM procedures and fundamental diagram calibration for operational LOS assessment on Italian freeways.” Transp. Res. Procedia, 5, 103–118.
Samoili, S., Efthymiou, D., Antoniou, C., and Dumont, A. G. (2013). “Lane flow distribution investigation of hard shoulder running freeways.” Proc., Transportation Research Board 92nd Annual Meeting, Transportation Research Board, Washington, DC.
Schakel, W. J., and van Arem, B. (2014). “Improving traffic flow efficiency by in-car advice on lane, speed, and headway.” IEEE Transact. Intell. Transp. Syst., 15(4), 1597–1606.
Sumner, R., Hill, D., and Shapiro, S. (1984). “Segment passenger car equivalent values for cost allocation on urban arterial roads.” Transp. Res. Part A, 18(5/6), 399–406.
Taragin, A. (1958). “Lateral placements of trucks on two-lane highways and four-lane divided highways.” Pub. Roads, 30(3), 71–75.
Transportation Research Board. (2010). Highway capacity manual, National Research Council, Washington, DC.
Tukey, J. W. (1977). Exploratory data analysis, Addison-Wesley, Reading, MA.
Wang, X.-Y., and Liu, J.-S. (2005). “Research of the lane utilization with microsimulation.” Proc., 2005 Int. Conf. on Machine Learning and Cybernetics, Vol. 5, IEEE, New York, 2681–2687.
Wu, N. (2005a). “Equilibrium of lane flow distribution on motorways.” Transp. Res. Rec., 1965(1), 48–59.
Wu, N. (2005b). “Impact of traffic regulation on lane flow—Distribution and capacity of motorways.” Proc., Fifth Int. Conf. of Transportation Professionals, China Communications Press, Beijing.
Wu, N. (2009). “Further development of the German Highway Capacity Manual (HBS2011).” Proc., Ninth Int. Conf. of Chinese Transportation Professionals, ASCE, Reston, VA, 1–6.
Xiao, C., Shao, C., Meng, M., Wang, P., and Wang, B. (2014). “Lane flow distribution of a long continuous highway.” Eur. Transp., 56(6), 1–16.
Yousif, S., Al-Obaedi, J., and Henson, R. (2012). “Drivers’ lane utilization for United Kingdom motorways.” J. Transp. Eng., 441–447.
Yousif, S., and Hunt, J. (1995). “Modelling lane utilisation on British dual-carriageway roads: Effects on lane-changing.” Traffic Eng. Control, 36(12), 680–687.
Information & Authors
Information
Published In
Journal of Transportation Engineering, Part A: Systems
Volume 143 • Issue 10 • October 2017
Copyright
©2017 American Society of Civil Engineers.
History
Received: Feb 2, 2016
Accepted: May 3, 2017
Published online: Aug 3, 2017
Published in print: Oct 1, 2017
Discussion open until: Jan 3, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.