Tensile Behavior of Weathered Thermally Bonded Polypropylene Geotextiles: Analysis Using Constitutive Models
Publication: Journal of Materials in Civil Engineering
Volume 35, Issue 12
Abstract
Weathering agents can significantly affect the mechanical response of geotextiles, particularly when long exposure periods are involved. Usually, in design, changes in the mechanical behavior of geotextiles are represented by reduction factors for their tensile strength. However, their full tensile force versus elongation response can be affected. The main aim of this work was to contribute to defining simple procedures to estimate tensile force versus elongation curves for weathered samples of geotextiles. The tensile response of two thermally bonded polypropylene geotextiles, before and after natural and artificial weathering, was assessed experimentally and analyzed using different constitutive models: polynomial (Orders 4 and 6) and hyperbolic. The influence of weathering on the mechanical response of the geotextiles was analyzed, polynomial and hyperbolic models for representing the tensile force versus elongation response were adopted and their parameters derived, and simple relations were implemented to estimate model parameters for weathered samples. Results revealed the occurrence of changes in the tensile behavior of the geotextiles, both under natural and artificial weathering conditions. Both groups of models fitted the experimental data properly. The Order 4 and 6 polynomial models are shown to have limited application, as the model parameters had no link to the tensile properties of the geotextiles. By contrast, the parameters of the hyperbolic model were linked to the tensile properties, particularly if affected by correction factors. The hyperbolic model parameters of the weathered samples were estimated using the model parameters of the reference samples and the reduction factors to allow for weathering (initial stiffness and tensile strength). These estimates proved to be adequate for representing the tensile response of weathered samples, particularly for low ranges of elongation. Finally, a simple procedure to represent the tensile response of weathered geotextiles was proposed. This procedure has shown promise in generating realistic tensile versus elongation curves.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some or all data, models, or code that support the findings of this study are available from the corresponding author upon reasonable request.
Acknowledgments
This work was financially supported by (1) Base Funding, UIDB/04708/2020 of the CONSTRUCT, Instituto de I&D em Estruturas e Construções, funded by national funds through the FCT/MCTES (PIDDAC); and (2) Foundation for Science and Technology (FCT), Aveiro Research Centre for Risks and Sustainability in Construction (RISCO), Universidade de Aveiro, Portugal [FCT/UIDB/ECI/04450/2020].
References
Aparicio-Ardila, M. A., G. O. M. Pedroso, M. Kobelnik, C. A. Valentin, M. P. Luz, and J. F. Silva. 2021. “Evaluating the degradation of a nonwoven polypropylene geotextile exposed to natural weathering for 3 years.” Int. J. Geosynth. Ground Eng. 7 (21): 69. https://doi.org/10.1007/s40891-021-00314-6.
ASTM. 2021. Standard test method for deterioration of geotextiles by exposure to light, moisture, and heat in a xenon-arc-type apparatus. ASTM D4355. West Conshohocken, PA: ASTM.
Bathurst, R. J., and V. N. Kaliakin. 2005. “Review of numerical models for geosynthetics in reinforcement applications.” In Proc., 11th Int. Conf. Int. Association Computational Methods Advance Geomechanics, 407–416. Torino, Italy: International Association for Computer Methods and Advances in Geomechanics.
BSI (British Standards Institution). 2010. Code of practice for strengthened/reinforced soils and other fills. BS 8006-1. London: BSI.
Buljak, V., and G. Ranzi. 2021. Constitutive modeling of engineering materials: Theory, computer implementation, and parameter identification. London: Academic Press.
Carneiro, J. R., P. J. Almeida, and M. L. Lopes. 2011. “Accelerated weathering of polypropylene geotextiles.” Sci. Eng. Compos. Mater. 18 (4): 241–245. https://doi.org/10.1515/SECM.2011.047.
Carneiro, J. R., P. J. Almeida, and M. L. Lopes. 2019. “Evaluation of the resistance of a polypropylene geotextile against ultraviolet radiation.” Microsc. Microanal. 25 (1): 196–202. https://doi.org/10.1017/S1431927618000430.
Carneiro, J. R., and M. L. Lopes. 2017. “Natural weathering of polypropylene geotextiles treated with different chemical stabilisers.” Geosynth. Int. 24 (6): 544–553. https://doi.org/10.1680/jgein.17.00020.
CEN (European Committee for Standardization). 1992. Textiles—Test methods for nonwovens—Part 3: Determination of tensile strength and elongation. EN 29073-3. Brussels, Belgium: CEN.
CEN (European Committee for Standardization). 2000. Geotextiles and geotextile-related products—Determination of the resistance to weathering. EN 12224. Brussels, Belgium: CEN.
CEN (European Committee for Standardization). 2005a. Geosynthetics—Sampling and preparation of test-specimens. EN ISO 9862. Brussels, Belgium: CEN.
CEN (European Committee for Standardization). 2005b. Geosynthetics—Test method for the determination of mass per unit area of geotextiles and geotextile-related products. EN ISO 9864. Brussels, Belgium: CEN.
CEN (European Committee for Standardization). 2013. Geosynthetic barriers—Characteristics required for use in the construction of canals. EN 13362. Brussels, Belgium: CEN.
CEN (European Committee for Standardization). 2016. Geosynthetics—Determination of thickness at specified pressures—Part 1: Single layers. EN ISO 9863-1. Brussels, Belgium: CEN.
Feldman, D. 2002. “Polymer weathering: Photo-oxidation.” J. Polym. Environ. 10 (4): 163–173. https://doi.org/10.1023/A:1021148205366.
Filho, J. L. E. D., P. C. A. Maia, and G. C. Xavier. 2019. “Spectrophotometry as a tool for characterizing durability of woven geotextiles.” Geotext. Geomembr. 47 (4): 577–585. https://doi.org/10.1016/j.geotexmem.2019.02.002.
Franco, Y. B., C. A. Valentin, M. Kobelnik, J. L. Silva, C. A. Ribeiro, and M. P. Luz. 2022. “Accelerated aging ultraviolet of a PET nonwoven geotextile and thermoanalytical evaluation.” Materials (Basel) 15 (12): 4157. https://doi.org/10.3390/ma15124157.
Giroud, J. P., J. Han, E. Tutumluer, and M. J. D. Dobie. 2022. “The use of geosynthetics in roads.” Geosynth. Int. 30 (1): 47–80. https://doi.org/10.1680/jgein.21.00046.
Greenwood, J. H., H. F. Schroeder, and W. Voskamp. 2016. Durability of geosynthetics. Boca Raton, FL: CRC Press.
Han, J. 2015. Principles and practices of ground improvement. Hoboken, NJ: Wiley.
Hsieh, C., J.-B. Wang, and Y.-F. Chiu. 2006. “Weathering properties of geotextiles in ocean environments.” Geosynth. Int. 13 (5): 210–217. https://doi.org/10.1680/gein.2006.13.5.210.
ISO (International Organization for Standardization). 2007. Guidelines for the determination of the long-term strength of geosynthetics for soil reinforcement. ISO/TR 20432. Geneva: ISO.
Koerner, R. M. 2012. Designing with geosynthetics. Milton Keynes, UK: Xlibris Corporation.
Koerner, R. M., Y. G. Hsuan, and G. R. Koerner. 2017. “Lifetime predictions of exposed geotextiles and geomembranes.” Geosynth. Int. 24 (2): 198–212. https://doi.org/10.1680/jgein.16.00026.
Liu, H., and H. I. Ling. 2006. “Modeling cyclic behavior of geosynthetics using mathematical functions combined with Masing rule and bounding surface plasticity.” Geosynth. Int. 13 (6): 234–245. https://doi.org/10.1680/gein.2006.13.6.234.
Lombardi, G., A. M. Paula, and M. Pinho-Lopes. 2022. “Constitutive modelling and statistical analysis of the short-term tensile response of geosynthetics after damage.” Constr. Build Mater. 317 (Jun): 125972. https://doi.org/10.1016/j.conbuildmat.2021.125972.
Maier, C., and T. Calafut. 1998. Polypropylene. The definitive user’s guide and databook. New York: Plastics Design Library.
Paula, A. M., and M. Pinho-Lopes. 2021. “Constitutive modelling of short-term tensile response of geotextile subjected to mechanical and abrasion damages.” Int. J. Geosynth. Ground Eng. 7 (Jun): 67. https://doi.org/10.1007/s40891-021-00313-7.
Perkins, S. W. 2000. “Constitutive modeling of geosynthetics.” Geotext. Geomembr. 18 (5): 273–292. https://doi.org/10.1016/S0266-1144(99)00021-7.
Pinkus, A. 2000. “Weierstrass and approximation theory.” J. Approximation Theory 107 (1): 1–66. https://doi.org/10.1006/jath.2000.3508.
Rowe, R. J. 2020. “Protecting the environment with geosynthetics: 53rd Karl Terzaghi Lecture.” J. Geotech. Geoenviron. Eng. 146 (9): 04020081. https://doi.org/10.1061/(ASCE)GT.1943-5606.0002239.
Shukla, S. K. 2016. An introduction to geosynthetic engineering. Leiden, Netherlands: CRC Press.
Sprague, C. J., and J. E. Sprague. 2016. “Geosynthetics in erosion and sediment control.” In Geotextiles: From design to applications. Sawston, UK: Woodhead Publishing.
Touze-Foltz, N., H. Bannour, C. Barral, and G. Stoltz. 2016. “A review of the performance of geosynthetics for environmental protection.” Geotext. Geomembr. 44 (5): 656–672. https://doi.org/10.1016/j.geotexmem.2016.05.008.
Valente, I. M., J. R. Carneiro, P. J. Almeida, and M. L. Lopes. 2011. “Determination of Chimassorb 944 in polypropylene geotextiles by HPLC-UV.” Anal. Lett. 44 (4): 617–625. https://doi.org/10.1080/00032711003783093.
Information & Authors
Information
Published In
Copyright
© 2023 American Society of Civil Engineers.
History
Received: Oct 4, 2022
Accepted: May 3, 2023
Published online: Sep 25, 2023
Published in print: Dec 1, 2023
Discussion open until: Feb 25, 2024
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.