Lost Gas and Desorption Kinetics of Coal at Different Pressures, Exposure Times, and Sampling Intervals
Publication: Journal of Energy Engineering
Volume 149, Issue 4
Abstract
The content of coalbed methane (CBM) is an important parameter that affects the performance of coal extraction and the safety of coal mines. The importance of this parameter is especially more pronounced when using the direct method to determine CBM content, in which the measuring accuracy of the lost gas affects the results. The loss is affected by the gas pressure and exposure time. In this article, the influence of gas pressure and exposure time on the estimation results and loss rate was investigated. Moreover, the influence of the sampling interval and observation time on the accuracy of the kinetic model in simulating the desorption process was analyzed. The obtained results demonstrated that the lost gas is positively associated with pressure and exposure time, and the lost gas rate is proportional to the exposure time. It was found that although the Barrer method outperforms the power function method, in terms of calculation accuracy, both methods have large errors. In terms of physical sense and model accuracy, the pore diffusion (IDM) model best fits the desorption kinetics of this coal. In the stable desorption stage, the desorption process is more consistent with Henry’s law. When the desorption changes violently, the desorption process is more consistent with Fick’s diffusion law. In order to ensure the consistency between the model and the experiment (95% confidence interval), the sampling interval of IDM model at 1 MPa should be more than 30 s.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All data, models, or code that support the findings of this study are available from the corresponding author upon reasonable request.
Acknowledgments
This work was financially supported by Guizhou Provincial Science and Technology Projects [2021] General Projects 514. The support greatly acknowledged and appreciated.
References
AS (Australian Standard). 1991. Guide to the determination of desorbable gas content of coal seams—Direct method. AS 3980-1991. Sydney, Australia: Standards Association of Australia.
Bangham, D. H., and W. Sever. 1925. “XCIII. An experimental investigation of the dynamical equation of the process of gas-sorption.” Philos. Mag. J. Sci. 49 (293): 935–944. https://doi.org/10.1080/14786442508634671.
Bertard, C., B. Bruyet, and J. Gunther. 1970. “Determination of desorbable gas concentration of coal (direct method).” Int. J. Rock Mech. Min. Sci. Geomech. Abstr. 7 (1): 43–65. https://doi.org/10.1016/0148-9062(70)90027-6.
Blanchard, G., M. Maunaye, and G. Martin. 1984. “Removal of heavy metals from waters by means of natural zeolites.” Water Res. 18 (12): 1501–1507. https://doi.org/10.1016/0043-1354(84)90124-6.
China, S. A. 2009. “The direct method of determining coalbed gas content in the mine.” Accessed June 6, 2022. http://openstd.samr.gov.cn/bzgk/gb/newGbInfo?hcno=1E00FA62BFC7F266A3C4E3FD50E3AB33.
Coal Mine Safety Supervision Bureau. 2018. “Appraisal method for coal mine gas grade.” Accessed June 6, 2022. http://www.gov.cn/gongbao/content/2018/content_5323112.htm.
Diamond, W. P., and S. J. Schatzel. 1998. “Measuring the gas content of coal: A review.” Int. J. Coal Geol. 35 (1): 311–331. https://doi.org/10.1016/S0166-5162(97)00040-2.
Li, Z., Q. Qi, Y. Yang, Y. Zhou, and B. Wang. 2016. “Factors impacting gas content measurements using gas desorption by drilling underground boreholes.” Adsorpt. Sci. Technol. 34 (7–8): 488–505. https://doi.org/10.1177/0263617416664534.
Li Chengwu, W. Y., W. Qijiang, and G. Xin. 2020. “Experimental study on the accuracy of gas content determination results by direct method.” J. China Coal Soc. 45 (1): 189–196. https://doi.org/10.13225/j.cnki.jccs.YG19.1673.
Liu, P., Y. Qin, S. Liu, and Y. Hao. 2018. “Non-linear gas desorption and transport behavior in coal matrix: Experiments and numerical modeling.” Fuel 214 (Jun): 1–13. https://doi.org/10.1016/j.fuel.2017.10.120.
Plazinski, W., W. Rudzinski, and A. Plazinska. 2009. “Theoretical models of sorption kinetics including a surface reaction mechanism: A review.” Adv. Colloid Interface Sci. 152 (1–2): 2–13. https://doi.org/10.1016/j.cis.2009.07.009.
Raghavan, N. S., M. M. Hassan, and D. M. Ruthven. 1987. “Numerical simulation of a pressure swing air separation systemndasha comparative study of finite difference and collocation methods.” Can. J. Chem. Eng. 65 (3): 512–516. https://doi.org/10.1002/cjce.5450650324.
Saghafi, A. 2017. “Discussion on determination of gas content of coal and uncertainties of measurement.” Int. J. Min. Sci. Technol. 27 (5): 741–748. https://doi.org/10.1016/j.ijmst.2017.07.024.
Schatzel, S. J., D. M. Hyman, A. Sainto, and J. C. LaScola. 1987. Methane contents of oil shale from the Piceance Basin, CO. Pittsburgh: US Dept. of the Interior.
Shin, H.-S., and K. S. Knaebel. 1987. “Pressure swing adsorption: A theoretical study of diffusion-induced separations.” AIChE J. 33 (4): 654–662. https://doi.org/10.1002/aic.690330413.
Szlazak, N., D. Obracaj, and M. Korzec. 2021. “Estimation of gas loss in methodology for determining methane content of coal seams.” Energies 14 (4): 982. https://doi.org/10.3390/en14040982.
Wang, F., X. Zhao, Y. Liang, X. Li, and Y. Chen. 2018. “Calculation model and rapid estimation method for coal seam gas content.” Processes 6 (11): 223. https://doi.org/10.3390/pr6110223.
Yan, J., X. Feng, Y. Guo, W. Wang, L. Wu, and Z. Tan. 2021. “Desorption effects and laws of multiscale gas-bearing coal with different degrees of metamorphism.” ACS Omega 6 (34): 22114–22125. https://doi.org/10.1021/acsomega.1c02706.
Yang, Z. 2010. “Desorption-diffusion model and lost gas quantity estimation of coalbed methane from coal core under drilling fluid medium.” Sci. China Earth Sci. 53 (4): 626–632. https://doi.org/10.1007/s11430-010-0027-x.
Zhu, J., Y. Luo, Y. Liang, X. Lv, and Z. Zhao. 2022. “Gas loss characteristics of coalbed methane-containing coal sampled using a freezing method.” In Nature resources research. Berlin: Springer.
Information & Authors
Information
Published In
Copyright
© 2023 American Society of Civil Engineers.
History
Received: Jul 2, 2022
Accepted: Feb 20, 2023
Published online: Apr 27, 2023
Published in print: Aug 1, 2023
Discussion open until: Sep 27, 2023
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.
Cited by
- Shiyao Yu, Xianbo Su, Jinxing Song, Qian Wang, Zhenjiang You, Insight into Gas Threshold Pressure Gradient and Permeability of Coal Seam: Principle and Method for Field Test, Journal of Energy Engineering, 10.1061/JLEED9.EYENG-4946, 149, 6, (2023).