Structural Behavior of Bridge Deck Slabs Made with GFRP-Reinforced Lightweight Self-Consolidating Concrete
Publication: Journal of Bridge Engineering
Volume 28, Issue 3
Abstract
The use of lightweight self-consolidating concrete (LWSCC) has significantly increased due to enhanced mix designs and its projected lower overall costs than normal-weight concrete. Accelerated bridge construction (ABC) has become a common alternative to conventional construction techniques. The use of LWSCC in ABC will reduce structural loads and expedite transportation and installation of precast bridge elements. Limited research, however, has investigated LWSCC bridge elements reinforced with glass fiber–reinforced polymer (GFRP) bars. This paper reports on the performance of full-scale edge-restrained bridge deck slabs (simulating slab-on-girder bridges) fabricated with LWSCC reinforced with GFRP bars. The test specimens included three edge-restrained slabs and one unrestrained slab for comparison. The test specimens were 3,000 mm long × 2,500 mm wide × 200 mm thick and were tested up to failure under a concentrated load simulating the footprint of a standard CL-625 truck wheel load (87.5 kN) defined in current design codes. The investigated parameters were (1) reinforcement ratio; (2) top reinforcement; and (3) effect of edge-restraining. The cracking behavior, ultimate capacity, deflection, and concrete and reinforcement strains of the specimens were presented and discussed. In addition, the punching-shear capacity of the tested specimens was assessed with the currently recommended design equations. The test results indicate that the overall performance of LWSCC deck slabs reinforced with GFRP bars is similar to such structures made with normal-weight concrete.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All data, models, and codes generated or used during the study appear in the published article.
Acknowledgments
This research was conducted with funding from the Tier 1 Canada Research Chair in Advanced Composite Materials for Civil Structures, the Natural Sciences and Engineering Research Council of Canada (NSERC), the Fonds de la recherche du Québec en nature et technologies (FQR-NT), and the Canadian Foundation for Innovation (CFI), and for the technical help provided by the staff of the structural lab of the Department of Civil Engineering at the University of Sherbrooke. The authors would like to express their special thanks and gratitude to Northeast Solite Corporation for their generosity. Their donation of Solite aggregate was instrumental to the success of the research project.
Notation
The following symbols are used in this paper:
- bo
- perimeter of the critical section calculated at a distance of d/2 from the concentrated load;
- c
- neutral-axis depth of the cracked transformed section; c = kd;
- d
- distance from the extreme compression fiber to the centroid of tension reinforcement;
- dv
- effective shear depth;
- Ef
- modulus of elasticity of FRP bars;
- compressive strength of the concrete;
- fct
- splitting tensile strength;
- k
- ratio of the depth of the neutral axis to the depth of the flexural reinforcement;
- nf
- ratio of the modulus of elasticity of the FRP bars to the modulus of elasticity of the concrete; nf = Ef /Ec;
- Vc
- nominal shear resistance of the concrete;
- wc
- equilibrium density of concrete;
- αs
- factor to consider the location of columns;
- βc
- long side-to-short side ratio of the loading plate;
- λ
- concrete density modification factor;
- ρf
- fiber-reinforced polymer reinforcement ratio; and
- ϕc
- concrete strength reduction factor.
References
ACI (American Concrete Institute). 2015. Guide for the design and construction of structural concrete reinforced with FRP bars. ACI 440.1R-15). Farmington Hills, MI: ACI.
ACI (American Concrete Institute). 2019. Building code requirements for structural concrete and commentary. ACI 318-19. Farmington Hills, MI: ACI.
AASHTO. 2018. AASHTO LRFD bridge design guide specifications for GFRP-reinforced concrete. 2nd ed. Washington, DC: AASHTO.
AASHTO. 2020. AASHTO LRFD bridge design specifications. 9th ed. Washington, DC: AASHTO.
Arafa, A., A. Farghaly, E. A. Ahmed, and B. Benmokrane. 2016. “Experimental testing of GFRP-RC panels with UHPFRC joints of Nipigon cable stayed bridge in Northwest Ontario.” J. Bridge Eng. 21 (11): 05016006. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000943.
ASTM. 2017. Standard specification for lightweight aggregates for structural concrete (rapport technique). ASTM C330. West Conshohocken, PA: ASTM.
ASTM. 2018. Specification for portland cement. ASTM C150. West Conshohocken, PA: ASTM.
ASTM. 2019. Standard test method for determining density of structural lightweight concrete. ASTM C567. West Conshohocken, PA: ASTM.
ASTM. 2021. Standard test method for tensile properties of fiber-reinforced polymer matrix composite bars. ASTM D7205. Conshohocken, PA: ASTM.
Bouguerra, K., E. Ahmed, S. El-Gamal, and B. Benmokrane. 2011. “Testing of full-scale concrete bridge deck slabs reinforced with fiber-reinforced polymer (FRP) bars.” Constr. Build. Mater. 25 (10): 3956–3965. https://doi.org/10.1016/j.conbuildmat.2011.04.028.
CSA (Canadian Standard Association). 2017. Design and construction of building components with fiber-reinforced polymers. CAN/CSA S806-12. Rexdale, ON, Canada: CSA.
CSA (Canadian Standard Association). 2019. Canadian highway bridge design code. CAN/CSA S6-19. Rexdale, ON, Canada: CSA.
Culmo, M. P. 2011. Accelerated bridge construction—Experience in design, fabrication and erection of prefabricated bridge elements and systems. Rep. No. FHWA-HIF-12-013. McLean, VA: FHWA.
Dulude, C., M. Hassan, E. A. Ahmed, and B. Benmokrane. 2013. “Punching shear behaviour of two-way flat concrete slabs reinforced with GFRP bars.” ACI Struct. J. 110 (5): 723–734.
Elgabbas, F., E. A. Ahmed, and B. Benmokrane. 2016. “Experimental testing of concrete bridge-deck slabs reinforced with basalt-FRP reinforcing bars under concentrated loads.” J. Bridge Eng. 21 (7): 04016029. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000892.
El-Gamal, S., E. El-Salakawy, and B. Benmokrane. 2007. “Influence of reinforcement on the behavior of concrete bridge deck slabs reinforced with FRP bars.” J. Compos. Constr. 11 (5): 449–458. https://doi.org/10.1061/(ASCE)1090-0268(2007)11:5(449).
El-Gamal, S., E. F. El-Salakawy, and B. Benmokrane. 2005. “Behavior of concrete bridge deck slabs reinforced with FRP bars under concentrated loads.” ACI Struct. J. 102 (5): 727–735.
El-Ragaby, A., E. El-Salakawy, and B. Benmokrane. 2007. “Fatigue life evaluation of concrete bridge deck slabs reinforced with glass FRP composite bars.” Compos. Constr. 3 (258): 258–268. https://doi.org/10.1061/(ASCE)1090-0268(2007)11:3(258).
El-Salakawy, E., B. Benmokrane, and G. Desgagné. 2003. “Fiber-reinforced polymer composite bars for the concrete deck slab of Wotton Bridge.” Can. J. Civ. Eng. 30 (5): 861–870. https://doi.org/10.1139/l03-055.
FHWA (Federal Highway Administration). 2019. Accelerated bridge construction. Washington, DC: FHWA.
Hassan, M., E. A. Ahmed, and B. Benmokrane. 2013. “Punching-shear strength of normal- and high-strength concrete flat slabs reinforced with GFRP bars.” J. Compos. Constr. 17 (6): 04013003. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000424.
Hassan, T. K., and S. H. Rizkalla. 2004. “Punching shear strength of GFRP reinforced deck slab-girder bridges.” In Proc., 4th Int. Conf. on Advanced Composite Materials in Bridges and Structure. Reston, VA: ASCE.
Huang, Z., Y. Zhao, J. Zhang, and Y. Wu. 2020. “Punching shear behaviour of concrete slabs reinforced with CFRP grids.” Structures 26: 617–625. https://doi.org/10.1016/j.istruc.2020.04.047.
Hwang, C. L., and M. F. Hung. 2005. “Durability design and performance of self-consolidating lightweight concrete.” Constr. Build. Mater. 19 (8): 619–626. https://doi.org/10.1016/j.conbuildmat.2005.01.003.
Mufti, A. A., and J. P. Newhook. 1998. “Punching shear strength of restrained concrete bridge deck slabs.” ACI Struct. J. 95 (4): 375–381.
Sanni, B. A., H. M. Mohamed, A. Yahya, and B. Benmokrane. 2021. “Axial load–moment interaction diagram of full-scale circular LWSCC columns reinforced with BFRP and GFRP bars and spirals: Experimental and theoretical investigations.” Eng. Struct. 242: 112538. https://doi.org/10.1016/j.engstruct.2021.112538.
Siwowski, T., and M. Rajchel. 2019. “Structural performance of a hybrid FRP composite—Lightweight concrete bridge girder.” Composites, Part B 174: 107055. https://doi.org/10.1016/j.compositesb.2019.107055.
Wiater, A., and T. Siwowski. 2020. “Serviceability and ultimate behaviour of GFRP reinforced lightweight concrete slabs: Experimental test versus code prediction.” Compos. Struct. 239: 112020. https://doi.org/10.1016/j.compstruct.2020.112020.
Youssef, M., E. A. Ahmed, and B. Benmokrane. 2019. “Structural behavior of GFRP-RC bridge deck slabs connected with UHPFRC joints under flexure and shear.” J. Bridge Eng. 24 (9): 04019092. https://doi.org/10.1061/(ASCE)BE.1943-5592.0001475.
Zheng, Y., C. Li, and G. Yu. 2012a. “Investigation of structural behaviours of laterally restrained GFRP reinforced concrete slabs.” Composites, Part B 43 (3): 1586–1597. https://doi.org/10.1016/j.compositesb.2011.11.012.
Zheng, Y., G. Yu, and Y. Pan. 2012b. “Investigation of ultimate strengths of concrete bridge deck slabs reinforced with GFRP bars.” Constr. Build. Mater. 28 (1): 482–492. https://doi.org/10.1016/j.conbuildmat.2011.09.002.
Zheng, Y., L. Zhou, L. Xia, Y. Luo, and S. E. Taylor. 2018. ‘“Investigation of the behaviour of SCC bridge deck slabs reinforced with BFRP bars under concentrated loads.” Eng. Struct. 171: 500–515. https://doi.org/10.1016/j.engstruct.2018.05.105.
Information & Authors
Information
Published In
Copyright
© 2023 American Society of Civil Engineers.
History
Received: Mar 2, 2022
Accepted: Nov 12, 2022
Published online: Jan 4, 2023
Published in print: Mar 1, 2023
Discussion open until: Jun 4, 2023
ASCE Technical Topics:
- Bars (structure)
- Bridge decks
- Bridge design
- Bridge engineering
- Bridges
- Bridges (by material)
- Concrete
- Concrete bridges
- Concrete slabs
- Construction engineering
- Construction industry
- Construction management
- Decks
- Design (by type)
- Engineering fundamentals
- Engineering materials (by type)
- Infrastructure construction
- Materials engineering
- Reinforced concrete
- Slabs
- Structural engineering
- Structural members
- Structural systems
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.