Hydraulic Experiments on Impact Forces from Tsunami-Driven Debris
Publication: Journal of Waterway, Port, Coastal, and Ocean Engineering
Volume 141, Issue 3
Abstract
Impact on a column by an idealized 1:5-scale shipping container propelled by tsunami flow was modeled in a large-scale wave flume. Results from hydraulic experiments were compared with corresponding data from in-air impact experiments using the same experimental configuration to assess the hydrodynamic effects on impact force and duration. Experiments were conducted by varying flow conditions, velocity, and nonstructural mass. An aluminum specimen was tested empty and with the addition of nonstructural mass to simulate partially loaded shipping containers. The measured peak impact forces from the longitudinal test in water were observed to have an increase no greater than 17% of the corresponding measured peak impact forces from the longitudinal test in air. The impact duration measured from the in-air test provided a lower bound for the impact duration measured for the in-water tests. Hydraulic effects were shown to increase the impact duration by an average of 20%. The additional nonstructural mass was shown to have no significant impact on the measured peak impact force, but was shown to increase the overall impulse on the column, as expected.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Funding for this research was provided by the National Science Foundation (NSF) through the NSF George E. Brown, Jr. NEES (Grant CMMI-1041666), which gratefully is acknowledged. The authors thank the NEES and HWRL staff, including Timothy Maddux, Jason Killian, Melora Park, Alicia Lyman-Holt, and Adam Ryan. Special thanks to the Research Experiences for Undergraduates (REU) students, Amy Kordosky and Patrick Bassal, in conducting experiments. Additional thanks to Manfred Dittrich from the Oregon State University machine shop for fabricating many of the materials used for experimentation.
References
ASCE. (2010). “Minimum design loads for buildings and other structures.” ASCE/SEI 7-10, Reston, VA.
Dibble, T. L., and Sollitt, C. K. (1989). “New designs for acoustic and resistive wave profilers.” Laboratory Archive Document, O. H. Hinsdale Wave Research Laboratory, Oregon State Univ., Corvallis, OR.
FEMA. (2008). “Guidelines for design of structures for vertical evacuation from tsunamis.” FEMA P-646, Washington, DC.
FEMA. (2011). “Coastal construction manual: Principles and practices of planning, siting, designing, constructing, and maintaining residential buildings in coastal areas.” FEMA P-55, 4th Ed., Washington, DC.
FEMA. (2012). “Guidelines for design of structures for vertical evacuation from tsunamis.” FEMA P646, 2nd Ed., Washington, DC.
Fieguth, P., and Terzopoulos, D. (1997). “Color-based tracking of heads and other mobile objects at video frame rates.” Proc., 1997 IEEE Computer Society Conf. on Computer Vision and Pattern Recognition, IEEE, New York, 21–27.
Haehnel, R. B., and Daly, S. F. (2002). “Maximum impact force of woody debris on floodplain structures.” Technical Rep. ERDC/CRREL TR-02-2, Engineer Research and Development Center, U.S. Army COE, Vicksburg, MS.
Haehnel, R. B., and Daly, S. F. (2004). “Maximum impact force of woody debris on floodplain structures.” J. Hydraul. Eng., 112–120.
Kobayashi, M. H., Genest, R., Riggs, H. R., and Paczkowski, K. (2012). “Simple hydroelastic impact models for water-borne debris.” J. Eng. Marit. Environ., 226(2), 170–179.
Kumagai, K., Oda, K., and Fujii, N. (2006). “Applicability of simulation model for drift behavior of containers due to tsunami.” Proc., Techno-Ocean 2006/19th Japan Society of Naval Architects and Ocean Engineers (JASNAOE) Ocean Engineering Symp., Techno-Ocean Network, Kobe, Japan.
Madurapperuma, M. A. K. M., and Wijeyewickrema, A. C. (2012). “Inelastic dynamic analysis of an RC building impacted by a tsunami water-borne shipping container.” J. Earthquake Tsunami, 6(1), 1250001.
Matsutomi, H. (2009). “Method for estimating collision force of driftwood accompanying tsunami inundation flow.” J. Disaster Res., 4(6), 435–440.
Matsutomi, H., and Okamoto, K. (2010). “Inundation flow velocity of tsunami on land.” Isl. Arc, 19(3), 443–457.
Mizutani, N., Takagi, Y., Shiraishi, K., Miyajima, S., and Tomita, T. (2005). “Study on wave force on a container on apron due to tsunamis and collision force of drifted container.” Annu. J. Coastal Eng., 52, 741–745 (in Japanese).
Mizutani, N., Takagi, Y., Shiraishi, K., Miyajima, S., and Tomita, T. (2006). “Forces on a container due to tsunami and collision force by drifted container.” Proc., 2nd Int. Workshop on Coastal Disaster Prevention, Port and Airport Research Institute (PARI), Kanagawa, Japan, 63–71.
Nouri, Y., Nistor, I., Palermo, D., and Cornett, A. (2010). “Experimental investigation of tsunami impact on free standing structures.” Coastal Eng. J., 52(1), 43–70.
Nuclear Regulatory Commission (NRC). (2004). Preventing earthquake disasters: The grand challenge in earthquake engineering. A research agenda for the network for earthquake engineering simulation (NEES), National Research Council, National Academies Press, Washington, DC.
Piran Aghl, P., Naito, C. J., and Riggs, H. R. (2014a). “Effect of non-structural mass on debris impact demands: Experimental and simulations studies.” Eng. Struct., in press.
Piran Aghl, P., Naito, C. J., and Riggs, H. R. (2014b). “Full-scale experimental study of impact demands resulting from high mass, low velocity debris.” J. Struct. Eng., 04014006.
Riggs, H. R., et al. (2013). “Water-driven debris impact forces on structures: Experimental and theoretical program.” Proc., ASME 2013 32nd Int. Conf. on Ocean, Offshore and Arctic Engineering, ASME, New York.
Robertson, I., et al. (2010a). “Reconnaissance following the September 29, 2009 tsunami in Samoa.” Research Rep. UHM/CEE/10-01, Dept. of Civil and Environmental Engineering, Univ. of Hawaii at Manoa, Honolulu.
Robertson, I., Chock, G., and Morla, J. (2010b). “Tsunami effects of the February 27, 2010 Chile earthquake.” EERI Preliminary Rep., Earthquake Engineering Research Institute, Oakland, CA.
Rossetto, T., et al. (2007). “The Indian Ocean tsunami of December 26, 2004: Observations in Sri Lanka and Thailand.” Nat. Hazards, 42(1), 105–124.
Thomas, S., and Cox, D. (2012). “Influence of finite-length seawalls for tsunami loading on coastal structures.” J. Waterway, Port, Coastal, Ocean Eng., 203–214.
Yeom, G.-S., Nakamura, T., and Mizutani, N. (2009). “Collision analysis of container drifted by runup tsunami using drift collision coupled model.” J. Disaster Res., 4(6), 441–449.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Mar 15, 2014
Accepted: Sep 17, 2014
Published online: Oct 15, 2014
Published in print: May 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.