Calibration and Optimal Leakage Management for a Real Water Distribution Network
Publication: Journal of Water Resources Planning and Management
Volume 137, Issue 1
Abstract
The aim of the paper is to present two optimization methodologies applied to a real water distribution system. The first one involves model calibration, while the second addresses the problem of optimal leakage management. Model calibration is based on a single objective, real-coded genetic algorithm, which provides optimal values of pipe friction factors and a leakage-dependent coefficient. Leakage management is accomplished through the introduction and regulation of pressure reducing valves. To this end, the writers adopted an approach based on multiobjective genetic algorithms, searching for the optimal placement and regulation of such valves. In particular, the first criterion is represented by the minimization of the number of valves, while the second is the minimization of the total leakage in the system. The algorithm provided several trade-off alternatives between leakage reduction and installation costs: the water utility managing the system chose to place and regulate the first four valves identified by the algorithm, resulting in a water loss reduction (as evidenced by the continuous monitoring of the system after valve installation) and in a decrease in pumping costs.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers would like to thank the water utility managing the system, CAFC S.p.A., for providing the instrumentation, support and the staff necessary for the measurements campaigns. A special note of thank goes to Massimo Battiston, managing director of the integrated water cycle at CAFC S.p.A, who believed in the methodology and made possible the implementation of the whole project.
References
Alegre, H., et al. (2006). Performance indicators for water supply services, 2nd Ed., IWA Publishing, London.
Alonso, J. M., et al. (2000). “Parallel computing in water network analysis and leakage minimization.” J. Water Resour. Plann. Manage., 126(4), 251–260.
Bascià, A., and Tucciarelli, T. (2003). “Simultaneous zonation and calibration of pipe network parameters.” J. Hydraul. Eng., 129(5), 394–403.
Deb, K. (2001). Multi-objective optimization using evolutionary algorithms, Wiley, New York.
Deb, K., Agrawal, S., Pratap, A., and Meyarivan, T. (2002). “A fast and elitist multi-objective genetic algorithm: NSGA-II.” IEEE Trans. Evol. Comput., 6(2), 182–197.
Deb, K., Mohan, M., and Mishra, S. (2003) “A fast multi-objective evolutionary algorithm for finding well-spread Pareto-optimal solutions.” KanGAL Rep. No. 2003002, Indian Institute of Technology, Kanpur, India.
Germanopoulos, G., and Jowitt, P. W. (1989). “Leakage reduction by excess pressure minimisation in a water supply network.” Proc. Inst. Civ. Eng., Part 2. Res. Theory, 87, 195–214.
Girard, M., and Stewart, R. A. (2007). “Implementation of pressure and leakage management strategies on the Gold Coast, Australia: Case study.” J. Water Resour. Plann. Manage., 133(3), 210–217.
Greco, M., and Del Giudice, D. (1999). “New approach to water distribution network calibration.” J. Hydraul. Eng., 125(8), 849–855.
Hindi, K. S., and Hamam, Y. M. (1991). “Locating pressure control elements for leakage minimisation in water supply networks: An optimization model.” Eng. Optimiz., 17, 281–291.
Jowitt, P. W., and Xu, C. (1990). “Optimal valve control in water distribution networks.” J. Water Resour. Plann. Manage., 116(4), 455–472.
Kapelan, Z. S., Savic, D. A., and Walters, G. A. (2005). “Optimal sampling design methodologies for water distribution model calibration.” J. Hydraul. Eng., 131(3), 190–200.
May, J. (1994). “Leakage, pressure and control.” BICS Int. Conf. on Leakage Control Investigation in Underground Assets.
Meier, R. W., and Barkdoll, B. D. (2000). “Sampling design for network model calibration using genetic algorithms.” J. Water Resour. Plann. Manage., 126(4), 245–250.
Nicolini, M., and Zovatto, L. (2009). “Optimal location and control of pressure reducing valves in water networks.” J. Water Resour. Plann. Manage., 135(3), 178–187.
Reis, L. F. R., Porto, R. M., and Chaudry, F. H. (1997). “Optimal location of control valves in pipe networks by genetic algorithms.” J. Water Resour. Plann. Manage., 123(6), 317–326.
Rossman, L. A. (2000). Epanet 2 users manual, USEPA, Cincinnati.
Savic, D. A., and Walters, G. A. (1995). “An evolution program for optimal pressure regulation in water distribution networks.” Eng. Optimiz., 24, 197–219.
Sterling, M. J. H., and Bargiela, A. (1984). “Leakage reduction by optimised control of valves in water networks.” Trans. Inst. Meas. Control (London), 6(6), 293–298.
Thornton, J., Sturm, R., and Kunkel, G. (2008). Water loss control, 2nd Ed., McGraw-Hill, New York.
Vairavamoorthy, K., and Lumbers, J. (1998). “Leakage reduction in water distribution systems: Optimal valve control.” J. Hydraul. Eng., 124(11), 1146–1154.
Van Zyl, J. E., and Clayton, C. R. I. (2007). “The effect of pressure on leakage in water distribution systems.” Water Manage., 160(WM2), 109–114.
Vítkovský, J. P., Simpson, A. R., and Lambert, M. F. (2000). “Leak detection and calibration using transients and genetic algorithms.” J. Water Resour. Plann. Manage., 126(4), 262–265.
Wu, Z. Y., and Sage, P. (2006). “Water loss detection via genetic algorithm optimization-based model calibration.” ASCE 8th Annual Int. Symp. on Water Distribution Systems Analysis, ASCE, Reston, Va.
Information & Authors
Information
Published In
Copyright
© 2011 ASCE.
History
Received: Jul 2, 2009
Accepted: Apr 1, 2010
Published online: Dec 15, 2010
Published in print: Jan 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.