Probabilistic Model Based on the Effective Range and Vehicle Speed to Determine Bluetooth MAC Address Matches from Roadside Traffic Monitoring
Publication: Journal of Transportation Engineering
Volume 138, Issue 1
Abstract
The use of Bluetooth technology to determine vehicle travel times offers several benefits over traditional methods—most notably, an increased amount of data points. An understanding of the Bluetooth device discovery procedure provides insight on the impacts of vehicle speed and device effective range on the number of in-range scan intervals, allowing the data collection setup to be modified to improve the probability of device detection. It is determined that the number of in-range scan intervals increases as vehicle speed decreases and that vehicle speed has a greater influence when the device effective range is decreased. Our match probability is defined as the probability that a single vehicle containing a discoverable Bluetooth radio will be detected by two different scanning radios, not a sampling rate produced by the ratio of MAC detections to total number of passing vehicles. The probability of device detection escalates for roadways with lower functional classification, slower posted speed limits, and during periods of congestion. At speeds of 56 ( ) the probability for a match exceeds 30%, whereas at faster speeds [105 ( )], the probability decreases to under 10% because of poor signal strength. Optimizing the data collection setup to increase the effective range between the target radio and roadside scanning radio will result in an improved probability of device detection for faster traffic streams.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The researchers would like to thank the reviewers for their generous comments on improving this work. The research was performed at the University of Akron and the contents reflect the views of the researchers, who are responsible for the facts and the accuracy of the data presented herein. The contents do not necessarily reflect the official views or policies of the USDOT or ODOT.
References
Ahmed, H., El-Darieby, M., Morgan, Y., and Abdulhai, B. (2008). “A wireless mesh network-based platform for ITS.” Proc., Vehicular Technology Conf. Spring 2008, IEEE Vehicular Technology Society, New York, 3047–3051.
Barceló, J., Montero, L., Marqués, L., and Carmona, C. (2009). “Travel time forecasting and dynamic OD estimation in freeways based on bluetooth traffic monitoring.” Proc., Transportation Research Board 89th Annual Meeting (CD-ROM), Transportation Research Board, Washington, DC.
Bluetooth Special Interest Group. (2009a). “Specification of the bluetooth system. Core, Version 4.0.” Specification documents, 〈http://www.bluetooth.com〉 (Jan. 22, 2010).
Bluetooth Special Interest Group. (2009b). “Bluetooth core specification v3.0 + HS.” Specification documents, 〈http://www.bluetooth.com〉 (Jan. 20, 2011).
Brennan, T., Ernst, J., Day, C., Bullock, D., Krogmeier, J., and Martchouk, M. (2010). “Influence of vertical sensor placement on data collection efficiency from bluetooth MAC address collection devices.” J. Transp. Eng., 136(12), 1104.
Haghani, A., Hamedi, M., Sadabadi, K., Young, S., and Tarnoff, P. (2010). “Freeway travel time ground truth data collection using bluetooth sensors.” Proc., Transportation Research Board 89th Annual Meeting (CD-ROM), Transportation Research Board, Washington, DC.
Kotanen, A., Hännikäinen, M., Leppäkoski, H., and Hämäläinen, T. (2003). “Experiments on local positioning with bluetooth.” Proc., Int. Conf. on Information Technology: Computers and Communications, Institute of Electrical and Electronics Engineers, Inc., Piscataway, NJ, 297.
O’Neill, E. et al. (2006). “Instrumenting the city: Developing methods for observing and understanding the digital cityscape.” Proc., 8th Int. Conf. on Ubiquitous Computing, Springer, Heidelberg, Germany, 315–332.
Pasolini, G., and Verdone, R. (2002). “Bluetooth for ITS?” 5th Int. Symp. on Wireless Personal Multimedia Communications, Vol. 1, Institute of Electrical and Electronics Engineers, Inc., Piscataway, NJ, 315–317.
Quayle, S., Koonce, P., DePencier, D., and Bullock, D. (2009). “Arterial performance measures using MAC readers: Portland pilot study.” Proc., Transportation Research Board 89th Annual Meeting (CD-ROM), Transportation Research Board, Washington, DC.
Tarnoff, P., Wasson, J., Young, S., Ganig, N., Bullock, D., and Sturdevant, J. (2009). “The continuing evolution of travel time data information collection and processing.” Proc., Transportation Research Board 88th Annual Meeting (CD-ROM), Transportation Research Board, Washington, DC.
Wasson, J., Haseman, R., and Bullock, D. (2009). “Real time measurement of work zone travel time delay and evaluation metrics using bluetooth probe tracking.” Proc., Transportation Research Board 89th Annual Meeting (DVD-ROM), Transportation Research Board, Washington, DC.
Wasson, J., Sturdevant, J., and Bullock, D. (2008). “Real-time travel time estimate using media access control address matching.” ITE J., 78(6), 20–23.
Welsh, E., Murphy, P., and Frantz, J. (2002). “Improving connection times for bluetooth devices in mobile environments.” Proc., Int. Conf. on Fundamentals of Electronics Communications and Computer Sciences, Institute of Electrical and Electronics Engineers, Inc., Piscataway, NJ.
Zhou, S., and Pollard, J (2006). “Position measurement using bluetooth.” IEEE Transactions on Consumer Electronics, 52(2), 555–558.
Zürbes, S., Stahl, W., Matheus, K., and Haartson, J. (2000). “Radio network performance of bluetooth.” Proc. IEEE Int. Conf. on Communication (ICC), New Orleans, Institute of Electrical and Electronics Engineers, Inc., Piscataway, NJ.
Information & Authors
Information
Published In
Copyright
© 2012 American Society of Civil Engineers.
History
Received: Feb 1, 2010
Accepted: Apr 7, 2011
Published online: Dec 15, 2011
Published in print: Jan 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.