Subsidence Monitoring Using Lidar and Morton Code Indexing
Publication: Journal of Surveying Engineering
Volume 142, Issue 1
Abstract
Point-based data-acquisition technology in traditional survey engineering does not provide complete data about mining-induced subsidence basins. To overcome these shortcomings, this research applied light detection and ranging (LIDAR) data, obtained with a terrestrial laser scanner (TLS) for monitoring the surface deformation of mining areas, to acquire full data about mining-induced subsidence basins. First, to improve the organization efficiency of LIDAR data, the decimal Morton code–based indexing method was proposed for discrete-grid indexing to organize LIDAR data according to original point coordinates, to avoid the generation of grids without data, and to build a topological relationship among scattered points. Thus, this approach enabled highly efficient access of LIDAR data and restoration of coordinates for each point. In the end, the processed data were applied in engineering practice. The subsidence curves of two sections of the subsidence basin, in both strike and dip directions measured with a high-grade control survey, were compared with the subsidence curves extracted from the LIDAR data. The good coincidence effect suggests that using LIDAR data to build the subsidence basin model can result not only in richer surface-deformation information than the traditional methods but also in higher monitoring precision.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research has been supported by the National Natural Science Foundation of China (Grant 41361078) and the Ph.D. research startup foundation of Jiangxi University of Science and Technology (Grant jxxjbs15005).
References
Aijazi, A., Checchin, P., and Trassoudaine, L. (2013). “Segmentation based classification of 3D urban point clouds: A super-voxel based approach with evaluation.” Remote Sens., 5(4), 1624–1650.
Armesto-González, J., Riveiro-Rodríguez, B., González-Aguilera, D., and Rivas-Brea, M. T. (2010). “Terrestrial laser scanning intensity data applied to damage detection for historical buildings.” J. Archaeol. Sci., 37(12), 3037–3047.
Gigli, G., Frodella, W., Garfagnoli, F., Morelli, S., Mugnai, F., Menna, F., and Casagli, N. (2014a). “3-D geomechanical rock mass characterization for the evaluation of rockslide susceptibility scenarios.” Landslides, 11(1), 131–140.
Gigli, G., Morelli, S., Fornera, S., and Casagli, N. (2014b). “Terrestrial laser scanner and geomechanical surveys for the rapid evaluation of rock fall susceptibility scenarios.” Landslides, 11(1), 1–14.
Gong, J., Ke, S., Zhu, Q., and Zhong, R. (2012). “An efficient management method for point cloud data based on octree and 3D R-tree.” Acta Geod. Cartogr. Sin., 41(4), 597–604 (in Chinese).
Gong, J., Zhu, Q., Zhang, H., Li, X., and Zhou, D. (2011a). “An adaptive control method of LODs for 3D scene based on R-tree index.” Acta Geod. Cartogr. Sin., 40(4), 531–534 (in Chinese).
Gong, J., Zhu, Q., Zhang, Y., Li, X., and Zhou, D. (2011b). “An efficient 3D R-tree extension method concerned with levels of detail.” Acta Geod. Cartogr. Sin., 40(2), 249–255 (in Chinese).
Hovi, A., and Korpela, I. (2014). “Real and simulated waveform-recording LiDAR data in juvenile boreal forest vegetation.” Remote Sens. Environ., 140, 665–678.
Jalonen, J., Järvelä, J., Koiusalo, H., and Hyyppä, H. (2014). “Deriving floodplain topography and vegetation characteristics for hydraulic engineering applications by means of terrestrial laser scanning.” J. Hydraul. Eng., 04014056.
Jazayeri, I., Rajabifard, A., and Kalantari, M. (2014). “A geometric and semantic evaluation of 3D data sourcing methods for land and property information.” Land Use Policy, 36, 219–230.
Kwak, E., Detchev, I., Habib, A., EI- Badry, M., and Hughes, C. (2013). “Precise photogrammetric reconstruction using model-based image fitting for 3D beam deformation monitoring.” J. Surv. Eng., 143–155.
Li, Z., and Zhu, Q. (2001). Digital elevation model, 2nd Ed., Wuhan University Press, Hubei, China (in Chinese).
Nú Ez, M. A., Buill, F., Regot, J., and de Mesa, A. (2013). “Use of robust methods to determine quadratic surfaces: application to heritage.” J. Archaeol. Sci., 40(2), 1289–1294.
Qiang, F., Zhang, Y., and Li, H. (2009). “The study on earthwork calculation of open-pit mine based on three-dimensional laser scanning technology.” Proc., 2nd Int. Congress on Image and Signal Processing, IEEE, New York, 1–4.
Shapira, A. (1993). “Octree subdivision of building elements.” J. Comput. Civ. Eng., 439–457.
Silvia, E. P., and Olsen, M. J. (2012). “To level or not to level: Laser scanner inclination sensor stability and application.” J. Surv. Eng., 117–125.
Travelletti, J., Malet, J.-P., Samyn, K., Grandjean, G., and Jaboyedoff, M. (2013). “Control of landslide retrogression by discontinuities: Evidence by the integration of airborne- and ground-based geophysical information.” Landslides, 10(1), 37–54.
Wang, G., Joyce, J., Phillips, D., Shrestha, R., and Carter, W. (2013). “Delineating and defining the boundaries of an active landslide in the rainforest of Puerto Rico using a combination of airborne and terrestrial LIDAR data.” Landslides, 10(4), 503–513.
Yang, J. (2014). “A method of combining the model of the global quadtree index with local KD-tree for massive airborne LiDAR point cloud data organization.” Geomat. Inf. Sci. Wuhan Univ., 39(8), 918–922 (in Chinese).
Yang, X., et al. (2013). “Three-dimensional forest reconstruction and structural parameter retrievals using a terrestrial full-waveform lidar instrument (Echidna).” Remote Sens. Environ., 135, 36–51.
Yu, Q., Wu, K., and Zheng, R. (2010). “Mining subsidence prediction parameters acquiring with 3D laser scanning data.” Survey. Mapp. Geol. Miner. Res. 26(2), 1–3 (in Chinese).
Zeybek, M., and Şanlıoğlu, İ. (2014). “Accurate determination of the Taşkent (Konya, Turkey) landslide using a long-range terrestrial laser scanner.” Bull. Eng. Geol. Environ., 74(1), 61–76.
Zhang, S., Wu, K., Wang, X., and Li, G. (2008). “Discussion on application of 3D laser scanning technology to ground subsidence monitoring.” Coal Sci. Technol., 36(11), 92–95 (in Chinese).
Zhao, G., Yue, J., Yu, X., Zhao, B., and Zhang, H. (2009). “Research on laser scanner applied for landslide monitoring in west mining areas.” Mine Surv., (3), 29–31, 72, 95 (in Chinese).
Zhi, X., Lin, Z., Su, G., and Zhong, L. (2010). “Research on organization of airborne LiDAR points cloud based on improved quadtree algorithm. Computer engineering and applications.” Comp. Eng. Appl., 46(9), 71–74 (in Chinese).
Zhou, D., Wu, K., Chen, R., and Li, L. (2014). “GPS/terrestrial 3D laser scanner combined monitoring technology for coal mining subsidence: A case study of a coal mining area in Hebei, China.” Nat. Hazards, 70(2), 1197–1208.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Oct 29, 2013
Accepted: Oct 24, 2015
Published online: Dec 16, 2015
Published in print: Feb 1, 2016
Discussion open until: May 16, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.