Experimental Study on Static Strength of Damaged Concrete Arches Reinforced by Corrugated Steel
Publication: Journal of Structural Engineering
Volume 148, Issue 5
Abstract
Reinforcing old bridges with corrugated steel (CS) is gaining interest due to outstanding reinforcement effects and relative ease of implementation. The approach consists of positioning the CS member under an old bridge and joining the two components by postcast concrete. However, the current design approach ignores the supporting effect of postcast concrete and the old bridges, which is overly conservative. This paper studies experimentally the static performance of the reinforced concrete (RC) arches reinforced with CS, mainly considering the influence of damage degree of the original structure. Two RC arches were prepared and loaded up to 60% and 100% of their ultimate bearing capacity, respectively. After reinforcing and reloading, failure modes, bearing capacity, and ductility of the reinforced specimens were obtained. The results show that when reinforcing the arches with CS, the ultimate bearing capacity increased by 172.8% and 194.0%, respectively. Comparison of the two reinforced specimens shows that the damage degree has only a small effect (8.2%) on the ultimate bearing capacity. Besides, the original structure, postcast concrete and CS were well bonded based on the strain analysis, proving the reinforced structure has the composite effect.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some or all data, models, or codes that support the findings of this study are available from the corresponding author upon request.
Acknowledgments
This research was supported by the National Natural Science Foundation of China (52078167).
References
AASHTO. 2010. AASHTO LRFD. LRED bridge design specification. Washington, DC: AASHTO.
Abdel-Rahman, N., and K. S. Sivakumaran. 1997. “Material properties models for analysis of cold-formed steel members.” J. Struct. Eng. 123 (9): 1135–1143. https://doi.org/10.1061/(ASCE)0733-9445(1997)123:9(1135).
Abdelsayed, G., B. Bakht, and L. G. Jaeger. 1993. Soil-steel bridges: Design and construction. New York: McGraw-Hill.
Ahmad, S. H., and S. A. Hamoush. 1990. “Static strength tests of steel plate strengthened concrete beams.” Mater. Struct. 23 (2): 116–125. https://doi.org/10.1007/BF02472571.
AISI (American Iron and Steel Institute). 1999. Modern sewer design. 4th ed. Washington, DC: AISI.
Brühwiler, E., and E. Denarié. 2013. “Rehabilitation and strengthening of concrete structures using ultra-high performance fibre reinforced concrete.” Struct. Eng. Int. 23 (4): 450–457. https://doi.org/10.2749/101686613X13627347100437.
Cai, S. T., X. S. Fu, and Y. J. Zeng. 2015. “The application of corrugated steel in reinforcement of highway and bridge.”Low Temp. Arch. Technol. 37 (2): 3. https://doi.org/10.13905/j.cnki.dwjz.2015.03.015.
Fang, Y., C. Liu, H. Yang, and L. Yang. 2020. “Axial behaviour of concrete-filled corrugated steel tubular column embedded with structural steel.” J. Constr. Steel Res. 170 (Jul): 106064. https://doi.org/10.1016/j.jcsr.2020.106064.
Fixon. 2008. “Corrugated steel plate-reinforcement concrete rib.” Accessed May 27, 2021. www.fixoninc.com.
Gao, J., J. Z. Su, and B. C. Chen. 2012. “Experiment on a concrete filled steel tubular arch with corrugated steel webs subjected to spatial loading.” Appl. Mech. Mater. 166–169 (Jun): 37–42. https://doi.org/10.4028/www.scientific.net/AMM.166-169.37.
Hamoush, S. A., and S. H. Ahmad. 1990. “Debonding of steel-plate-strengthened concrete beams.” J. Struct. Eng. 116 (2): 356–371. https://doi.org/10.1061/(ASCE)0733-9445(1990)116:2(356).
He, W. T., B. D. Liu, G. Han, and S. W. Sun. 2019. “Research of corrugated steel plate and concrete composite structure in bridge reinforcement and reconstruction.” Earthquake Resistant Eng. Retrofitting 41 (1): 104–111. https://doi.org/10.16226/j.issn.1002-8412.2019.01.015.
Isselin, J., and T. Shoji. 2009. “Yield strength evaluation by small-punch test.” J. Test. Eval. 37 (6): 531–537. https://doi.org/10.1520/JTE101657.
Kang, J. S., and J. S. Davidson. 2013. “Structural effects of concrete lining for concrete-lined corrugated steel pipes.” Struct. Infrastruct. Eng. 9 (2): 130–140. https://doi.org/10.1080/15732479.2010.532809.
Lampropoulos, A. P., S. A. Paschalis, O. T. Tsioulou, and S. E. Dritsos. 2016. “Strengthening of reinforced concrete beams using ultra high performance fibre reinforced concrete (UHPFRC).” Eng. Struct. 106 (Jan): 370–384. https://doi.org/10.1016/j.engstruct.2015.10.042.
Lestuzzi, P., and H. Bachmann. 2007. “Displacement ductility and energy assessment from shaking table tests on RC structural walls.” Eng. Struct. 29 (8): 1708–1721. https://doi.org/10.1016/j.engstruct.2006.09.009.
Li, B. J., L. S. Zhu, and X. S. Fu. 2020. “Influence of grout strength and residual deformation on performance of rehabilitated RC pipes.” J. Pipeline Syst. Eng. 11 (2): 04020003. https://doi.org/10.1061/(ASCE)PS.1949-1204.0000448.
Li, B. J., L. S. Zhu, Y. Li, and X. S. Fu. 2019. “Experimental investigation of an existing RCP rehabilitated with a grouted corrugated steel pipe.” Math. Probl. Eng. 11 (2): 04020003. https://doi.org/10.1155/2019/7676359.
Liu, B., Z. Zhang, M. Zhang, and X. Wang. 2019. “Experimental study of the mechanical performance of corrugated steel plate-concrete composite structures.” Int. J. Steel Struct. 19 (3): 733–746. https://doi.org/10.1007/s13296-018-0158-z.
Liu, C., Y. Wang, X. Wu, and S. Zhang. 2017. “In-plane stability of fixed concrete-filled steel tubular parabolic arches under combined bending and compression.” J. Bridge Eng. 22 (2): 04016116. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000993.
Miyamoto, A., K. Tei, H. Nakamura, and J. W. Bull. 2000. “Behavior of prestressed beam strengthened with external tendons.” J. Struct. Eng. 126 (9): 1033–1044. https://doi.org/10.1061/(ASCE)0733-9445(2000)126:9(1033).
Morrison, T. D., and P. Eng. 2005. “Innovative low cover bridges utilizing deep-corrugated steel plate with encased concrete composite ribs.” In Proc., Annual Conf. of the Transportation Association of Canada. Ottawa: Transportation Association of Canada.
MOT (Ministry of Transport of the People’s Republic of China). 2005. Code for design of highway masonry bridges and culverts. JTG D61-2005. Beijing: MOT.
Park, Y. H., C. Park, and G. P. Yong. 2005. “The behavior of an in-service plate girder bridge strengthened with external prestressing tendons.” Eng. Struct. 27 (3): 379–386. https://doi.org/10.1016/j.engstruct.2004.10.014.
Pisani, M. A. 1999. “Strengthening by means of external prestressing.” J. Bridge Eng. 4 (2): 131–135. https://doi.org/10.1061/(ASCE)1084-0702(1999)4:2(131).
Rahmaninezhad, S. M., J. Han, M. Al-Naddaf, and R. L. Parsons. 2019. “Behavior of sliplined corrugated steel pipes under parallel-plate loading.” J. Mater. Civil Eng. 31 (10): 04019242. https://doi.org/10.1061/(ASCE)MT.1943-5533.0002889.
Smith, T., N. A. Hoult, and I. D. Moore. 2015. “Role of grout strength and liners on the performance of slip-lined pipes.” J. Pipeline Syst. Eng. 6 (4): 04015007. https://doi.org/10.1061/(ASCE)PS.1949-1204.0000203.
Tian, Y., N. Liu, and X. X. Guo. 2015. “New technology of assembling corrugated steel plate to reinforce existing culvert.” Rail. Eng. 8: 3. https://doi.org/10.3969/j.issn.1003-1995.2015.08.09.
Vaslestad, J., A. Madaj, and L. Janusz. 2002. “Field measurements of long-span corrugated steel culvert replacing corroded concrete bridge.” Transp. Res. Rec. 1814 (1): 164–170. https://doi.org/10.3141/1814-19.
Vaslestad, J., A. Madaj, L. Janusz, and B. Bednarek. 2004. “Field measurements of old brick culvert slip lined with corrugated steel culvert.” Transp. Res. Rec. 1892 (1): 227–234. https://doi.org/10.3141/1892-24.
Wang, Y., L. Yang, H. Yang, and C. Liu. 2019. “Behaviour of concrete-filled corrugated steel tubes under axial compression.” Eng. Struct. 183 (Mar): 475–495. https://doi.org/10.1016/j.engstruct.2018.12.093.
Zhou, T., and J. Li. 2017. “Application and benefit analysis of corrugated steel in strengthening highway bridge culvert.” New Silk Road Horizon 20: 73–74. https://doi.org/10.3969/j.issn.1671-9670.2017.20.066.
Information & Authors
Information
Published In
Copyright
© 2022 American Society of Civil Engineers.
History
Received: Jul 30, 2021
Accepted: Dec 15, 2021
Published online: Mar 9, 2022
Published in print: May 1, 2022
Discussion open until: Aug 9, 2022
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.