Stiffness Modifiers to Support the Seismic Design of Reinforced Concrete Rectangular Columns
Publication: Journal of Structural Engineering
Volume 147, Issue 10
Abstract
Stiffness modifiers are used in linear structural analysis programs to recognize the low-strain amplitude nonlinear material stress–strain response and support the design of reinforced concrete structures. For example, stiffness modifiers are used to account for the reduction in stiffness that results mainly from crack development and propagation, bar bond slip between cracks, and bar bond slip of the longitudinal reinforcement developed beyond the column ends. This paper presents a primarily mechanistic model to compute the stiffness modifiers for reinforced concrete rectangular columns to support the seismic design of reinforced concrete structures. The model accounts for five modes of deformation found in columns and is calibrated against a database of test results reported in the literature on 38 large-section columns that exhibited ductile response. The paper also describes a simplified equation for use in seismic design. The simplified equation was calibrated through an extensive parametric analysis of the model. The mean, median and coefficient of variation of the ratios of the stiffness modifiers computed from the recorded response of test columns and the model output were 1.02, 1.00, and 0.18, respectively, and those calculated by the simplified equation for the same ratios were 0.95, 0.98, and 0.18, respectively.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All data, models, and code generated or used during the study appear in the published article.
References
AASHTO. 2011. AASHTO guide specifications for LRFD seismic bridge design. 2nd ed. Washington, DC: AASHTO.
ACI (American Concrete Institute). 2019. Building code requirements for structural concrete and commentary. ACI 318-19. Farmington Hills, MI: ACI.
Aktan, A. E., and V. V. Bertero. 1984. “Seismic response of R/C frame-wall structures.” J. Struct. Eng. 110 (8): 1803–1821. https://doi.org/10.1061/(ASCE)0733-9445(1984)110:8(1803).
Ang, B. G., M. J. N. Priestley, and R. Park. 1981. Ductility of reinforced concrete bridge piers under seismic loading. Christchurch, New Zealand: Univ. of Canterbury.
ASCE. 2017. Seismic evaluation and retrofit of existing buildings. ASCE/SEI 41-17. Reston, VA: ASCE.
Avsar, O., B. Bayhan, and A. Yakut. 2014. “Effective flexural rigidities for ordinary reinforced concrete columns and beams.” Struct. Des. Tall Spec. Build. 23 (6): 463–482. https://doi.org/10.1002/tal.1056.
Bae, S., and O. Bayrak. 2008. “Seismic performance of full-scale reinforced concrete columns.” ACI Struct. J. 102 (2): 123–133.
Berry, M. P., M. Parrish, and M. O. Eberhard. 2004. PEER structural performance database user’s manual. Berkeley, CA: Pacific Earthquake Engineering Research Center, Univ. of California-Berkeley.
Cowper, G. R. 1966. “The shear coefficient in timoshenko’s beam theory.” J. Appl. Mech. 33 (2): 335–340. https://doi.org/10.1115/1.3625046.
Elwood, K., and M. Eberhard. 2009. “Effective stiffness of reinforced concrete columns.” ACI Struct. J. 106 (4): 476–484.
Gill, W. D., R. Park, and M. J. N. Priestley. 1979. Ductility of rectangular reinforced concrete columns with axial load. Christchurch, New Zealand: Univ. of Canterbury.
Hines, E., J. Restrepo, and F. Seible. 2004. “Force-displacement characterization of well-confined bridge-piers.” ACI Struct. J. 101 (4): 537–548.
Khuntia, M., and S. K. Ghosh. 2004. “Flexural stiffness of reinforced concrete columns and beams: Experimental verification.” Struct. J. 101 (3): 364–374.
Kumar, R., and Y. Singh. 2010. “Stiffness of reinforced concrete frame members for seismic analysis.” ACI Struct. J. 107 (5): 607–615.
Legeron, F., and P. Paultre. 2000. “Behavior of high-strength concrete columns under cyclic flexure and constant axial load.” ACI Struct. J. 97 (4): 591–601.
Li, X. 1994. “Reinforced concrete columns under seismic lateral force and varying axial load.” Ph.D. thesis, Dept. of Civil Engineering, Univ. of Canterbury.
Lynn, A. C. 2001. “Seismic evaluation of existing reinforced concrete building columns.” Ph.D. thesis, Graduate Division of the Univ. of California at Berkeley.
Mehanny, S. S. F., H. Kuramoto, and G. G. Deierlein. 2001. “Stiffness modeling of RC beam-columns for frame analysis.” ACI Struct. J. 98 (2): 215–225.
Mirza, S. A. 1990. “Flexural stiffness of rectangular reinforced concrete columns.” ACI Struct. J. 87 (4): 425–435.
NIST. 2014. Use of high-strength reinforcement in earthquake-resistant concrete structures. Gaithersburg, MD: NIST.
Park, R. 1988. “Ductility evaluation from laboratory and analytical testing.” In Vol. 8 of Proc., 9th World Conf. on Earthquake Engineering, 605–616. Tokyo: International Association for Earthquake Engineering.
Paulay, T., and M. J. N. Priestley. 1992. Seismic design of reinforced concrete and masonry buildings. New York: Wiley.
Presland, R., J. Restrepo, and R. Park. 2001. Seismic performance of retrofitted reinforced concrete bridge piers. Christchurch, New Zealand: Univ. of Canterbury.
Restrepo, J. 2000. “Issues related to the seismic design of reinforced concrete structural systems.” SESOC J. 13 (1): 50–58.
Restrepo, J. I., and M. Rodriguez. 2013. “On the probable moment strength of reinforced concrete columns.” ACI Struct. J. 110 (4): 681–690.
Restrepo, J. I., and M. Rodriguez. 2020. Evaluacion de la Rigidez Lateral de columnas de concreto reforzado. Segunda Edicion [Effective lateral stiffness in reinforced concrete columns]. [In Spanish.]. Mexico City: Instituto de Ingenieria, Universidad Nacional Autónoma de México.
Sato, Y., H. Tanaka, and R. Park. 1993. Reinforced concrete columns with mixed grade longitudinal reinforcement. Christchurch, New Zealand: Univ. of Canterbury.
Satyarno, I. 1993. Concrete columns incorporating mixed ultra high and normal strength longitudinal reinforcement. Christchurch, New Zealand: Univ. of Canterbury.
Tran, C. T. N., and B. Li. 2012. “Initial stiffness of reinforced concrete columns with moderate aspect ratios.” Adv. Struct. Eng. 15 (2): 265–276. https://doi.org/10.1260/1369-4332.15.2.265.
Tsuno, K. 1999. “Effect of seismic loading patterns on reinforced concrete bridge piers.” Master’s thesis, Dept. of Civil Engineering, Univ. of Canterbury.
Information & Authors
Information
Published In
Copyright
© 2021 American Society of Civil Engineers.
History
Received: Jul 3, 2020
Accepted: May 3, 2021
Published online: Aug 6, 2021
Published in print: Oct 1, 2021
Discussion open until: Jan 6, 2022
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.
Cited by
- Xiong Wang, Yue Pan, Mingguang Li, Jinjian Chen, Determining and Estimating the Fracture Risk of Diaphragm Wall from Observed Lateral Deflection, Proceedings of the 2022 International Conference on Green Building, Civil Engineering and Smart City, 10.1007/978-981-19-5217-3_89, (884-892), (2022).