Adaptive Force-Based Multimode Pushover Analysis for Seismic Evaluation of Midrise Buildings
Publication: Journal of Structural Engineering
Volume 144, Issue 8
Abstract
To consider the effect of higher modes in predicting the seismic responses of midrise buildings, as well as the progressive changes in the dynamic characteristics during the nonlinear analysis, an adaptive force-based multimode pushover (AFMP) procedure is presented. This procedure is an adaptive version of the single-run multimode pushover (SMP) procedure that it is envisaged to be an enhancement of the previously proposed procedure. The procedure encompasses some adaptive pushover analyses. First, an adaptive single-mode pushover analysis using the first mode shape is performed. Moreover, one or two adaptive multimode pushover analyses are implemented by means of the enhanced lateral load distributions calculated by algebraically adding the instantaneous modal story forces. Therefore, the sign reversals of load vectors in the higher modes are considered. The results obtained through the adaptive single-mode and multimode pushover analyses are enveloped to compute the final seismic responses. It is demonstrated that the AFMP procedure can estimate with acceptable accuracy the seismic responses of midrise building frames.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research investigation was funded by the Iran National Science Foundation (INSF). This financial support is gratefully acknowledged.
References
Abbasnia, R., A. T. Davoudi, and M. M. Maddah. 2013. “An adaptive pushover procedure based on effective modal mass combination rule.” Eng. Struct. 52: 654–666. https://doi.org/10.1016/j.engstruct.2013.03.029.
Amini, M. A., and M. Poursha. 2016. “A non-adaptive displacement-based pushover procedure for the nonlinear static analysis of tall building frames.” Eng. Struct. 126: 586–597. https://doi.org/10.1016/j.engstruct.2016.08.009.
Antoniou, S., and R. Pinho. 2004a. “Advantages and limitations of adaptive and non-adaptive force-based pushover procedures.” J. Earthquake Eng. 8 (4): 497–522. https://doi.org/10.1080/13632460409350498.
Antoniou, S., and R. Pinho. 2004b. “Development and verification of a displacement-based adaptive pushover procedure.” J. Earthquake Eng. 8 (5): 643–661. https://doi.org/10.1080/13632460409350504.
ASCE. 2006. Seismic rehabilitation of existing buildings. ASCE/SEI 41-06. Reston, VA: ASCE.
ATC (Applied Technology Council). 1996. Seismic evaluation and retrofit of concrete buildings. Redwood City, CA: ATC.
Bracci, J. M., S. K. Kunnath, and A. M. Reinhorn. 1997. “Seismic performance and retrofit evaluation of reinforced concrete structures.” J. Struct. Eng. 123 (1): 3–10. https://doi.org/10.1061/(ASCE)0733-9445(1997)123:1(3).
CEN (European Committee for Standardization). 2003. Eurocode 8: Design of structures for earthquake resistance. Part 1: Final draft. Pr-EN 1998-1. Brussels, Belgium: CEN.
Chopra, A. K. 2001. Dynamics of structures. Theory and applications to earthquake engineering. 2nd ed. Englewood Cliffs, NJ: Prentice Hall.
Chopra, A. K., and R. K. Goel. 2002. “A modal pushover analysis procedure for estimating seismic demands for buildings.” Earthquake Eng. Struct. Dyn. 31 (3): 561–582. https://doi.org/10.1002/eqe.144.
Chopra, A. K., and R. K. Goel. 2004. “A modal pushover analysis procedure to estimate seismic demands for unsymmetrical-plan buildings.” Earthquake Eng. Struct. Dyn. 33 (8): 903–927. https://doi.org/10.1002/eqe.380.
Chopra, A. K., R. K. Goel, and C. Chintanapakdee. 2004. “Evaluation of a modified MPA procedure assuming higher modes as elastic to estimate seismic demands.” Earthquake Spectra 20 (3): 757–778. https://doi.org/10.1193/1.1775237.
Elnashai, A. S. 2001. “Advanced inelastic static (pushover) analysis for earthquake applications.” Struct. Eng. Mech. 12 (1): 51–70. https://doi.org/10.12989/sem.2001.12.1.051.
Fajfar, P. 2000. “A nonlinear analysis method for performance based seismic design.” Earthquake Spectra 16 (3): 573–592. https://doi.org/10.1193/1.1586128.
FEMA. 2000. Prestandard and commentary for the seismic rehabilitation of buildings. FEMA 356. Washington, DC: FEMA.
Fragiadakis, M., D. Vamvatsikos, and M. Aschheim. 2014. “Application of nonlinear static procedures for the seismic assessment of regular RC moment frame buildings.” Earthquake Spectra 30 (2): 767–794. https://doi.org/10.1193/111511EQS281M.
Gupta, B., and S. K. Kunnath. 2000. “Adaptive spectra-based pushover procedure for seismic evaluation of structures.” Earthquake Spectra 16 (2): 367–392. https://doi.org/10.1193/1.1586117.
Jan, T. S., M. W. Liu, and Y. C. Kao. 2004. “An upper-bound pushover analysis procedure for estimating the seismic demands of high-rise buildings.” Eng. Struct. 26 (1): 117–128. https://doi.org/10.1016/j.engstruct.2003.09.003.
Kalkan, E., and S. K. Kunnath. 2006. “Adaptive modal combination procedure for nonlinear static analysis of building structures.” J. Struct. Eng. 132 (11): 1721–1731. https://doi.org/10.1061/(ASCE)0733-9445(2006)132:11(1721).
Kim, S. P., and Y. C. Kurama. 2008. “An alternative pushover analysis procedure to estimate seismic displacement demands.” Eng. Struct. 30 (12): 3793–3807. https://doi.org/10.1016/j.engstruct.2008.07.008.
Krawinkler, H., and G. D. P. K. Seneviratna. 1998. “Pros and cons of a pushover analysis of seismic performance evaluation.” Eng. Struct. 20 (4–6): 452–464. https://doi.org/10.1016/S0141-0296(97)00092-8.
Kreslin, M., and P. Fajfar. 2011. “The extended N2 method taking into account higher mode effects in elevation.” Earthquake Eng. Struct. Dyn. 40 (14): 1571–1589. https://doi.org/10.1002/eqe.1104.
Mazzoni, S., F. McKenna, M. H. Scott, and G. L. Fenves. 2014. “OpenSees (Open System for Earthquake Engineering Simulation).” http://opensees.berkeley.edu/.
Mwafy, A. M., and A. S. Elnashai. 2001. “Static pushover versus dynamic collapse analysis of RC buildings.” Eng. Struct. 23 (5): 407–424. https://doi.org/10.1016/S0141-0296(00)00068-7.
Peer.berkeley.edu. 2014. “PEER strong ground motion database.” https://peer.berkeley.edu/products/strong_ground_motion_db.html.
Poursha, M., and M. A. Amini. 2015. “A single-run multi-mode pushover analysis to account for the effect of higher modes in estimating the seismic demands of tall buildings.” Bull. Earthquake Eng. 13 (8): 2347–2365. https://doi.org/10.1007/s10518-014-9721-y.
Poursha, M., F. Khoshnoudian, and A. S. Moghadam. 2009. “A consecutive modal pushover procedure for estimating the seismic demands of tall buildings.” Eng. Struct. 31 (2): 591–599. https://doi.org/10.1016/j.engstruct.2008.10.009.
Poursha, M., F. Khoshnoudian, and A. S. Moghadam. 2010. “Assessment of modal pushover analysis and conventional nonlinear static procedure with load distributions of Federal Emergency Management Agency for high rise buildings.” J. Struct. Des. Tall. Spec. Build. 19 (3): 291–308. https://doi.org/10.1002/tal.487.
Poursha, M., F. Khoshnoudian, and A. S. Moghadam. 2011. “A consecutive modal pushover procedure for nonlinear static analysis of one-way unsymmetric-plan tall building structures.” Eng. Struct. 33 (9): 2417–2434. https://doi.org/10.1016/j.engstruct.2011.04.013.
Poursha, M., F. Khoshnoudian, and A. S. Moghadam. 2014. “The extended consecutive modal pushover procedure for estimating the seismic demands of two-way unsymmetric-plan tall building structures under influence of two horizontal components of ground motions.” J. Soil Dyn. Earthquake Eng. 63: 162–173. https://doi.org/10.1016/j.soildyn.2014.02.001.
Reinhorn, A. M. 1997. “Inelastic analysis techniques in seismic evaluations.” Seismic design methodologies for the next generation of performance based seismic engineering of codes, 277–287. Rotterdam, Netherlands: A.A. Balkema.
Sasaki, K. K., S. A. Freeman, and T. F. Paret. 1998. “Multimode pushover procedure (MMP)—A method to identify the effects of higher modes in a pushover analysis.” In Proc., 6th US National Conf. on Earthquake Engineering. Seattle, WA.
Scott, M. H., and G. L. Fenves. 2006. “Plastic hinge integration methods for force-based beam-column elements.” J. Struct. Eng. 132 (2): 244–252. https://doi.org/10.1061/(ASCE)0733-9445(2006)132:2(244).
Shakeri, K., M. A. Shayanfar, and T. Kabeyasawa. 2010. “A story shear-based adaptive pushover procedure for estimating seismic demands of buildings.” Eng. Struct. 32 (1): 174–183. https://doi.org/10.1016/j.engstruct.2009.09.004.
Tso, W. K., and A. S. Moghadam. 1998. “Pushover procedure for seismic analysis of buildings.” Prog. Struct. Mater. Eng. 1 (3): 337–344.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Sep 8, 2016
Accepted: Jan 3, 2018
Published online: May 18, 2018
Published in print: Aug 1, 2018
Discussion open until: Oct 18, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.