Dual-Hazard Blast and Seismic Behavior of Concrete-Filled Double-Skin Steel Tubes Bridge Pier
Publication: Journal of Structural Engineering
Volume 143, Issue 12
Abstract
The dual-hazard inelastic behavior of concrete-filled double-skin steel tubes (CFDSTs) is experimentally investigated as a substitute to reinforced concrete columns for bridge piers in multihazard applications. Results demonstrate that CFDSTs exhibit substantial toughness and ductility that can help achieve satisfactory performance when exposed to seismic and blast hazards. Under cyclic loading, for all specimens designed as part of this testing program, yielding of the section preceded buckling of the outside tube. The onset of local buckling of the outside tube was not observed until well beyond 4% drift, and failure of all the sections happened generally beyond 7% drift, even when compactness of the outside tube met only the AISC seismic provisions requirements for moderately ductile behavior. In the cyclic tests, although pinching of the hysteresis curve happened during the test, the curves remained stable. For the blast tests, all sections behaved in a ductile manner when subjected to near-contact charges; but for extreme conditions, sections having large voids in their cross section experienced significant denting. Overall, these tests validated the viability of CFDSTs in compliance with AISC compactness requirements for bridge columns in the dual-hazard application considered here.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was partly supported by the Federal Highway Administration under an award to MCEER and by the Infrastructure Protection and Disaster Management Division, Science and Technology Directorate, U.S. Department of Homeland Security under a cooperative agreement with the U.S. Army Engineer Research Development Center (Contract W912HZ-11-2-0001). Any opinions, findings, conclusions, and recommendations presented in this paper are those of the authors and do not necessarily reflect the views of the sponsors. Permission to publish was granted by the Director, Geotechnical and Structures Laboratory.
References
AASHTO. (2012). AASHTO guide specifications for LRFD seismic bridge design, 2nd Ed., Washington, DC.
ACI (American Concrete Institute). (1992). Standard practice for selecting proportions for normal, heavyweight, and mass concrete, Farmington Hills, MI.
AISC. (2010). “Seismic provisions for structural steel buildings.” ANSI/AISC 341-10, Chicago.
API (American Petroleum Institute). (1989). Draft recommended practice for planning, designing and constructing fixed offshore platforms. Load and resistance factor design, Washington, DC.
ASTM. (2015). “Standard specification for electric-resistance-welded carbon and alloy steel mechanical tubing.” ASTM A513/A513M-15, West Conshohocken, PA.
Baylot, J., and Rickman, D. (2007). “Uncertainties in blast loads on structures.” Structures Congress 2007, ASCE, Reston, VA.
Bruhl, J., and Varma, A. (2015). “Summary of blast tests on steel-plate reinforced concrete walls.” Structures Congress 2015, ASCE, Reston, VA, 151–159.
Bruneau, M., and Marson, J. (2004). “Seismic design of concrete-filled circular steel bridge piers.” J. Bridge Eng., 24–34.
Burrell, R., Aoude, H., and Saatcioglu, M. (2015). “Response of SFRC columns under blast loads.” J. Struct. Eng., 04014209.
DoD (Department of Defense). (2008). “Structures to resist the effects of accidental explosions.” UFC 3-340-02, Washington, DC.
FEMA. (2000). “Prestandard and commentary for the seismic rehabilitation of buildings.” FEMA 356, Washington, DC.
FEMA. (2004). “Design guide for improving school safety in earthquakes, floods, and high winds.” FEMA 424, Washington, DC.
FEMA. (2009). “Quantification of building seismic performance factors.” FEMA 695, Washington, DC.
Fouché, P., and Bruneau, M. (2014). “Blast and seismic resistant concrete-filled double skin tubes and modified steel jacketed bridge columns.”, Univ. at Buffalo, Buffalo, NY.
Fouché, P., Bruneau, M., and Chiarito, V. P. (2016). “Modified steel jacketed columns for combined blast and seismic retrofit of existing bridge columns.” J. Bridge Eng., 04016035.
Fujikura, S., and Bruneau, M. (2011). “Experimental investigation of seismically resistant bridge piers under blast loading.” J. Bridge Eng., 63–71.
Fujikura, S., Bruneau, M., and Lopez-Garcia, D. (2008). “Experimental investigation of multihazard resistant bridge piers having concrete-filled steel tube under blast loading.” J. Bridge Eng., 586–594.
Han, L.-H., Huang, H., and Zhao, X.-L. (2009). “Analytical behaviour of concrete-filled double skin steel tubular (CFDST) beam-columns under cyclic loading.” Thin-Walled Struct., 47(6), 668–680.
Han, L.-H., Tao, Z., and Zhao, X. (2006). “Concrete-filled double skin steel tubular (CFDST) beam-columns subjected to cyclic bending.” Eng. Struct., 28(12), 1698–1714.
Hsiao, P., Kazuhiro Hayashi, K., Nishi, R., Lin, X., and Nakashima, M. (2015). “Investigation of concrete-filled double-skin steel tubular columns with ultrahigh-strength steel.” J. Struct. Eng., 04014166.
Huang, H., Han, L.-H., and Zhao, X.-L. (2013). “Investigation on concrete filled double skin steel tubes (CFDSTs) under pure torsion.” J. Constr. Steel Res., 90(3), 221–234.
Huang, H., Han, L.-H., Tao, Z., and Zhao, X.-L. (2010). “Analytical behaviour of concrete-filled double skin steel tubular (CFDST) stub columns.” J. Constr. Steel Res., 66(4), 542–555.
Imani, R., Mosqueda, G., and Bruneau, M. (2015a). “Experimental study on post-earthquake fire resistance of ductile concrete filled double-skin tube columns.” J. Struct. Eng., 04014192.
Imani, R., Mosqueda, G., and Bruneau, M. (2015b). “Finite element simulation of concrete filled double-skin tube columns subjected to post-earthquake fires.” J. Struct. Eng., 04014192.
Lin, M. L., and Tsai, K. C. (2001). “Behavior of double-skinned composite steel tubular columns subjected to combined axial and flexural loads.” 1st Int. Conf. on Steel and Composite Structures, Techno-Press, Daejeon, Korea.
Li, W., Han, L.-H., and Chan, T.-M. (2014a). “Tensile behaviour of concrete-filled double-skin steel tubular members.” J. Constr., Steel Res., 99(8), 35–46.
Li, W., Han, L.-H., and Chan, T.-M. (2014b). “Numerical investigation on the performance of concrete-filled double-skin steel tubular members under tension.” Thin-Walled Struct., 79, 108–118.
Li, W., Han, L.-H., Ren, Q.-X., and Zhao, X.-L. (2013). “Behavior and calculation of tapered CFDST columns under eccentric compression.” J. Constr. Steel Res., 83, 127–136.
Li, W., Ren, Q.-X., Han, L.-H., and Zhao, X.-L. (2012). “Behaviour of tapered concrete-filled double skin steel tubular (CFDST) stub columns.” Thin-Walled Struct., 57, 37–48.
Lu, H., Zhao, X.-L., and Han, L.-H. (2010). “Testing of self-consolidating concrete-filled double skin tubular stub columns exposed to fire.” J. Constr. Steel Res., 66(8), 1069–1080.
Mathcad [Computer software]. PTC, Needham, MA.
Montague, P. (1975). “Simple composite construction for cylindrical shells subjected to external pressure.” J. Mech. Eng. Sci., 17(2), 105–113.
Orton, S., Chiarito, V., Minor, J., and Coleman, T. (2014). “Experimental testing of CFRP-strengthened reinforced concrete slab elements loaded by close-in blast.” J. Struct. Eng., 04013060.
Pagoulatou, M., Sheehan, T., Dai, X., and Lam, D. (2014). “Finite element analysis on the capacity of circular concrete-filled double-skin steel tubular (CFDST) stub columns.” Eng. Struct., 72(9), 102–112.
Shakir-Khalil, H. (1991). “Composite columns of double-skinned shells.” J. Constr. Steel Res., 19(2), 133–152.
Tao, Z., and Han, L.-H. (2006). “Behavior of concrete-filled double skin rectangular steel tubular beam-columns.” J. Constr. Steel Res., 62(7), 631–646.
Tao, Z., Han, L.-H., and Zhao, X.-L. (2004). “Behaviour of concrete-filled double skin (CHS inner and CHS outer) steel tubular stub columns and beam-columns.” J. Constr. Steel Res., 60(8), 1129–1158.
Uenaka, K., Kitoh, H., and Sonoda, K. (2010). “Concrete filled double skin circular stub columns under compression.” Thin-Walled Struct., 48(1), 19–24.
Wei, S., Mau, S. T., Vipulanandan, C., and Mantrala, S. K. (1995). “Performance of new sandwich tube under axial loading: Experiment.” J. Struct. Eng., 1806–1814.
Williams, D., Holland, C., Williamson, E., Bayrak, O., Marchand, K., and Ray, J. (2008). “Blast-resistant highway bridges: Design and detailing guidelines.” Proc., 10th Int. Conf. on Structures under Shock and Impact (SUSI), WIT Press, Southampton, U.K.
Williamson, E. B., and Winget, D. G. (2005). “Risk management and design of critical bridges for terrorist attacks.” J. Bridge Eng., 96–106.
Woodson, S. C., and Baylot, J. T. (1999). “Structural collapse: Quarter-scale model experiments.”, U.S. Army Engineer Research and Development Center, Vicksburg, MS.
Yuan, W., and Yang, J. (2013). “Experimental and numerical studies of short concrete-filled double skin composite tube columns under axially compressive loads.” J. Constr. Steel Res., 80(10), 23–31.
Zhang, F., et al. (2016). “Experimental study of CFDST columns infilled with UHPC under close-range blast loading.” Int. J. Impact Eng., 93, 184–195.
Zhao, X.-L., Tong, L.-W., and Wang, X.-Y. (2010). “CFDST stub columns subjected to large deformation axial loading.” Eng. Struct., 32(3), 692–703.
Zhong, T., Han, L.-H., and Zhao, X.-L. (2004). “Behaviour of concrete-filled double skin (CHS inner and CHS outer) steel tubular stub columns and beam-columns.” J. Constr. Steel Res., 60(8), 1129–1158.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Jun 28, 2016
Accepted: May 9, 2017
Published online: Sep 18, 2017
Published in print: Dec 1, 2017
Discussion open until: Feb 18, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.