Experimental Study of the In-Plane Behavior of Confined Stone Masonry Walls
Publication: Journal of Structural Engineering
Volume 142, Issue 2
Abstract
Stone masonry construction is still a common practice in remote mountainous areas of many developing countries. Field investigations have shown that the traditional construction practices do not usually provide adequate seismic resistance for such buildings. This study was carried out to investigate and improve the construction of single-story stone masonry buildings in terms of safety in extreme events, economy, and ease of construction. The current construction methods were first studied through field investigations, and their deficiencies were identified. Then, improved stone masonry walls were designed that provide some confinement for the masonry by adding steel and reinforced-concrete tie-beams and tie-columns. The in-plane behavior of these walls was then studied experimentally. A total of seven stone masonry walls with different configurations of confining elements and openings were examined. These studies revealed the benefits of using steel and concrete confining elements for the improvement of in-plane strength and ductility of stone masonry walls, concrete elements being considerably more effective. Finally, a simple hysteretic model is calibrated based on the test results that can be used for numerical modeling of the in-plane behavior of confined stone masonry walls.
Get full access to this article
View all available purchase options and get full access to this article.
References
Aref, A. J., and Dolatshahi, K. M. (2013). “A three-dimensional cyclic meso-scale numerical procedure for simulation of unreinforced masonry structures.” Comput. Struct., 120(1), 9–23.
Arya, A. S. (1996a). “Post-earthquake reconstruction in Maharashtra, India.” Proc., 11th World Conf. on Earthquake Engineering, Pergamon, Oxford, U.K.
Arya, A. S. (1996b). “Seismic retrofitting of stone houses in Mararthwara area, India.” Proc., 11th World Conf. on Earthquake Engineering, Pergamon, Oxford, U.K.
Azevedo, J., and Sincarian, G. (2005). “Modeling the seismic behaviour of monumental masonry structures.” Instituto Superior Tecnico, Lisboa, Portugal.
Bayraktar, A., Coşkun, N., and Yalçin, A. (2007). “Performance of masonry stone buildings during the March 25 and 28, 2004 Aşkale (Erzurum) earthquakes in Turkey.” J. Perform. Constr. Facil., 432–440.
Benedetti, D., Carydis, P., and Pezzoli, P. (1998). “Shaking table tests on 24 simple masonry buildings.” Earthquake Eng. Struct. Dyn., 27(1), 67–90.
Benedetti, D., and Castoldi, A. (1982). “Dynamic and static experimental analysis of stone masonry buildings.” Proc., 7th European Conf. on Earthquake Engineering, Technical Chamber of Greece, Athens, Greece.
BHRC (Building and Housing Research Center of Iran). (2014). “Iranian code of practice for seismic resistant design of buildings.”, Tehran, Iran.
Bruneau, M. (1994). “Assessing the seismic performance of existing buildings in Canada.” ACI Struct. J., 147, 171–204.
BSI (British Standards Institute). (2009). “Testing hardened concrete.” BS EN 12390, London.
Cantu, E., and Zanon, P. (1982). “Combined cyclic testing procedures in diagonal compression on hollow clay block reinforced masonry.” Proc., 6th Int. Brick Masonry Conf., Laterconsult SRL, Roma, Italy, 1007–1020.
Dolatshahi, K. M., and Aref, A. J. (2011). “Two-dimensional computational framework of meso-scale rigid and line interface elements for masonry structures.” Eng. Struct., 33(12), 3657–3667.
Elmenshawi, A., Sorour, M., Mufti, A., Jaeger, L. G., and Shrive, N. (2010). “Damping mechanisms and damping ratios in vibrating unreinforced stone masonry.” Eng. Struct., 32(10), 3269–3278.
FEMA (Federal Emergency Management Agency). (2000). “Prestandard and commentary for the seismic rehabilitation of buildings.”, Washington, DC.
German Institute for Standardization. (1993). “DIN 1025: Dimensions, masses and sectional properties of hot rolled I-beams.” Berlin.
Haach, V. G., Vasconcelos, G., and Lourenço, P. B. (2011). “Parametrical study of masonry walls subjected to in-plane loading through numerical modeling.” Eng. Struct., 33(4), 1377–1389.
Liberatore, D., and Bernardini, A. (1999). “Seismic behaviour, vulnerability and probability of collapse of masonry buildings.” The Catania project: Earthquake damage scenarios for a high risk area in the Mediterranean, F. Faccioli, and V. Pessina, eds., CNR-Gruppo Nazionale per la Difesa dai Terremoti, Milan, Italy, 127–159.
Lourenço, P., Oliveira, D., Roca, P., and Orduña, A. (2005). “Dry joint stone masonry walls subjected to in-plane combined loading.” J. Struct. Eng., 1665–1673.
Mann, W., Konig, G., and Otes, A. (1988). “Tests of masonry walls subjected to seismic forces.” Brick and Block Masonry (8th IBMAC) London, Vol. 2, Elsevier Applied Science, London, 764–773.
Marzahn, G. (1997). “Improving the shear bond behavior of masonry.” Proc., LACER, Institut für Massivbau und Baustofftechnologie, Leipzig, Germany, 245–268.
McNary, W. S., and Abrams, D. P. (1985). “Mechanics of masonry in compression.” J. Struct. Eng., 857–870.
Miranda, E., and Bertero, V. V. (1994). “Evaluation of strength reduction factors for earthquake-resistant design.” Earthquake Spectra, 10(2), 357–379.
Payne, D. C., Brooks, D. S., and Sved, G. (1990). “The analysis and design of slender brick walls.” Masonry Int. (Br. Masonry Soc.), 4(2), 55–65.
Penazzi, J., Valluzzi, M. R., Saisi, A., Binda, L., and Modena, C. (2001). “Repair and strengthening of historic masonry buildings in seismic areas.” Proc., Int. Millennium Congress, United Nations Educational, Scientific and Cultural Organisation (UNESCO), Paris.
Romano, F., Ganduscio, S., and Zingone, G. (1993). “Cracked nonlinear masonry stability under vertical and lateral loads.” J Struct Eng, 69–87.
Schultz, A. E. (1994). “Performance of masonry structures during extreme lateral loading events.” ACI Struct. J., 147(1), 85–126.
Senthivel, R., and Lourenço, P. B. (2009). “Finite element modelling of deformation characteristics of historical stone masonry shear walls.” Eng. Struct., 31(9), 1930–1943.
Shing, P. B., Manivannan, T., and Carter, E. (1990). “Evaluation of reinforced masonry shear wall components by pseudo-dynamic testing.” Proc., 4th National Conf. on Earthquake Engineering, Earthquake Engineering Research Institute (EERI), Oakland, CA, 829–838.
Shing, P. B., Noland, J. L., Klamerus, E., and Spaeh, H. (1988). “Inelastic behavior of concrete masonry walls.” J. Struct. Eng., 2204–2225.
Sivaselvan, M., and Reinhorn, A. M. (2000). “Hysteretic models for deteriorating inelastic structures.” J. Eng. Mech., 633–640.
Smoljanović, H., Živaljić, N., and Nikolić, Ž. (2013). “A combined finite-discrete element analysis of dry stone masonry structures.” Eng. Struct., 52(0), 89–100.
Tomazevic, M., Lutman, M., and Petkovic, L. (1996). “Seismic behavior of masonry walls: Experimental simulation.” J. Struct. Eng., 1040–1047.
Vasconcelos, G., and Lourenço, P. (2009). “In-plane experimental behavior of stone masonry walls under cyclic loading.” J. Struct. Eng., 1269–1277.
Wakabayashi, M., and Nakamura, T. (1984). “Reinforcing principle and seismic resistance of brick masonry walls.” Proc., 8th World Conf. on Earthquake Engineering, Prentice-Hall, Englewood Cliffs, NJ, 661–668.
Woodward, K., and Rankin, F. (1983). “Behavior of concrete block masonry walls subjected to repeated cyclic displacements.”, National Bureau of Standards, Gaithersburg, MD.
Xia, J., Ding, S., and Zhou, S. (1986). “Tests of aseismic behavior of brick masonry wall.” Proc., US-PRC Joint Workshop on Seismic Resistance of Masonry Structures, State Seismological Bureau, PRC and National Science Foundation.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Nov 9, 2014
Accepted: Aug 17, 2015
Published online: Oct 9, 2015
Published in print: Feb 1, 2016
Discussion open until: Mar 9, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.