Temperature-Based Structural Identification of Long-Span Bridges
Publication: Journal of Structural Engineering
Volume 141, Issue 11
Abstract
Temperature-based structural identification (TBSI) is a quantitative structural evaluation approach that relies on responses resulting from temperature fluctuations. Through this approach, the transfer function that defines how thermal induced strains give rise to global displacements and restrained member forces can be captured. This input-output relationship is highly sensitive to mechanisms that pose modeling challenges, such as boundary and continuity conditions, and thus is quite valuable within the model updating process. The method follows the traditional structural identification (St-Id) framework with a priori modeling, experimentation, and model calibration steps appropriately modified to allow for the measurement and simulation of temperature-induced responses. TBSI was evaluated through the use of simulations and laboratory experiments and then implemented to identify an arch bridge. In addition, a comparative study was performed with an independent evaluation of the same bridge using ambient vibration structural identification (AVSI). The results indicate that TBSI and AVSI are synergistic providing complementary information related to a diverse range of structural performances. In addition, the results illustrate several TBSI strong points, including (1) the ability to identify both linear and nonlinear behaviors, (2) the ability to efficiently capture response patterns with long periods, and (3) a strong correlation between the captured transfer function and the behavior of boundary and continuity conditions.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research reported in this paper was supported by the National Science Foundation under grant number CMMI-0846591 and the Burlington County Bridge Commission. In addition, the authors would like to acknowledge Jeffrey Weidner, Nathan Dubbs, John Prader, and Ehsan Minaie of Intelligent Infrastructure Systems LLC and John DeVitis, David Masceri, and Aliya Turner of Drexel University for their support throughout this research.
References
Abdel-Ghaffar, A., and Scanlan, R. (1985). “Ambient vibration studies of golden gate bridge: I. Suspended structure.” J. Eng. Mech., 463–482.
Aktan, A. E., et al. (1997). “Structural identification for condition assessment: Experimental arts.” J. Struct. Eng., 1674–1684.
ASCE and SEI (Structural Engineering Institute). (2013). “Structural identification of constructed systems.” Approaches, methods, and technologies for effective practice of St-Id, N. Catbas, T. Kijewski-Correa, and A. E. Aktan, eds.
Beck, J. L., and Jennings, P. C. (1980). “Structural identification using linear models and earthquake records.” Earthquake Eng. Struct. Dyn., 8(2), 145–160.
Brownjohn, J., Moyo, P., Omenzetter, P., and Lu, Y. (2003). “Assessment of highway bridge upgrading by dynamic testing and finite-element model updating.” J. Bridge Eng., 162–172.
Brownjohn, J. M. W., Magalhaes, F., Caetano, E., and Cunha, A. (2010). “Ambient vibration re-testing and operational modal analysis of the Humber bridge.” Eng. Struct., 32(8), 2003–2018.
Brownjohn, J. W., Stefano, A., Xu, Y.-L., Wenzel, H., and Aktan, A. E. (2011). “Vibration-based monitoring of civil infrastructure: Challenges and successes.” J. Civ. Struct. Health Monit., 1(3–4), 79–95.
Catbas, F. N., and Aktan, A. E. (2002). “Condition and damage assessment: Issues and some promising indices.” J. Struct. Eng., 1026–1036.
Catbas, F. N., Ciloglu, S. K., Hasancebi, O., Grimmelsman, K., and Aktan, A. E. (2007). “Limitations in structural identification of large constructed structures.” J. Struct. Eng., 1051–1066.
Catbas, F. N., Grimmelsman, K. A., and Aktan, A. E. (2000). “Structural identification of the Commodore Barry bridge.” Nondestructive Evaluation of Highways, Utilities, and Pipelines IV, Society of Photo-optical Instrumentation Engineers.
Conte, J., et al. (2008). “Dynamic testing of Alfred Zampa memorial bridge.” J. Struct. Eng., 1006–1015.
Fujino, Y., et al. (2000). “Forced and ambient vibration tests and vibration monitoring of Hakucho suspension bridge.” Transportation Research Record 1696, Transportation Research Board, Washington, DC, 7–63.
Geokon. (2012). Instruction manual vibrating wire strain gage, Lebanon, NH.
Laory, I., Westgate, R. J., Brownjohn, J. M. W., and Smith, I. F. C. (2013). “Temperature variations as load cases for structural identification.” 6th Int. Conf. on Structural Health Monitoring of Intelligent Infrastructure, Dept. of Civil and Environmental Engineering, Hong Kong Polytechnic Univ.
Liu, S.-C., and Yao, J. T. P. (1978). “Structural identification concept.” J. Struct. Div., 104(12), 1845–1858.
Matlab [Computer software]. Natick, MA, Mathworks.
Modjeski, Master, and Chase. (1931). “Tacony-Palmyra Bridge over the Delaware river between Philadelphia, PA and Palmyra, NJ.”, Mechanicsburg, PA.
Peeters, B., and De Roeck, G. (2001). “One-year monitoring of the Z24-Bridge: Environmental effects versus damage events.” Earthquake Eng. Struct. Dyn., 30(2), 149–171.
Ren, W.-X., Peng, X.-L., and Lin, Y.-Q. (2005). “Experimental and analytical studies on dynamic characteristics of a large span cable-stayed bridge.” Eng. Struct., 27(4), 535–548.
Strand7 [Computer software]. Sydney, Australia, Finite Element Analysis System.
Yarnold, M. T. (2013). “Temperature-based structural identification and health monitoring for long-span bridges.” Ph.D. thesis, Drexel Univ., Philadelphia.
Yarnold, M. T., Moon, F. L., Dubbs, N. C., and Aktan, A. E. (2012). “Evaluation of a long-span steel tied arch bridge using temperature-based structural identification.” International Association for Bridge Management and Safety, Stresa, Italy.
Zhang, H. (2007). “Dynamic detection and model analysis of long-span cable-stayed bridge.” Ph.D. thesis, Wuhan Univ. of Technology, P.R. China.
Zhang, J., Prader, J., Grimmelsman, K., Moon, F., Aktan, A., and Shama, A. (2013). “Experimental vibration analysis for structural identification of a long span suspension bridge.” J. Eng. Mech., 748–759.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Jun 13, 2013
Accepted: Jan 7, 2015
Published online: Feb 19, 2015
Discussion open until: Jul 19, 2015
Published in print: Nov 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.