Estimation of Shear Strength of Structural Shear Walls
Publication: Journal of Structural Engineering
Volume 136, Issue 10
Abstract
An analysis method for predicting the shear strength and behavior of structural shear walls under both monotonic and cyclic loading is presented in this paper. The proposed analysis method is based on the softened truss model theory and utilizes a newly proposed cracking angle of the concrete strut. The cracking angle is developed using a regression analysis of the reported shear capacity values of 100 experimental shear walls. The analysis pays particular attention to parameters expected to influence the walls’ shear capacity including the geometric properties, reinforcement ratios, internal stresses, and concrete strength. The proposed method has been used to predict the shear capacity of the tested walls, and their deformation behavior both pre- and postcracking, and the results compared well with the experimental data. The proposed strut cracking angle also matched well the cracking patterns obtained experimentally.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The Egyptian Ministry of Higher Education and the Egyptian Cultural Bureau in London are gratefully acknowledged for their sponsorship of this research.
References
American Concrete Institute (ACI). (2005). “Building code requirements for structural concrete.” (ACI 318-05) and Commentary (ACI 318R-05), Farmington Hills, MI.
Barda, F., Hanson, J. M., and Corley, W. G. (1977). “Shear strength of low-rise walls with boundary elements.” Reinforced concrete structures in seismic zones, publication SP-53, American Concrete Institute, Detroit, 149–202.
Cardenas, A. E., Russell, H. G., and Corley, W. G. (1980). “Strength of low-rise structural walls, reinforced concrete structures subjected to wind and earthquake forces.” Reinforced concrete structures subjected to wind and earthquakes forces, publication SP-63, American Concrete Institute, Detroit, 221–241.
Dabbagh, H. (2005). “Strength and ductility of high-strength concrete shear walls under reversed cyclic loading.” Ph.D. thesis, The Univ. of New South Wales, Sydney, Australia.
Farvashany, F. E., Foster, F. J., and Rangan, B. V. (2008). “Strength and deformation of high-strength concrete shearwalls.” ACI Struct. J., 105(1), 21–29.
Fintel, M. (1991). “Shearwalls—An answer for seismic resistance?” Concr. Int., 13(7), 48–53.
Fintel, M. (1995). “Performance of buildings with shear walls in earthquakes of the last thirty years.” PCI J., 40(3), 62–80.
Gulec, C. K., Whittaker, A. S., and Stojadinovic, B. (2008). “Shear strength of squat rectangular reinforced concrete walls.” ACI Struct. J., 105(4), 488–497.
Gupta, A. (1996). “Behaviour of high strength concrete structural walls.” Ph.D. thesis, Curtin Univ. of Technology, Perth, Australia.
Gupta, A., and Rangan, B. V. (1998). “High-strength concrete (HSC) structural walls.” ACI Struct. J., 95(2), 194–205.
Hirosawa, M. (1975). “Past experimental results on reinforced concrete shear walls and analysis on them.” Kenchiku Kenkyu Shiryo, No. 6, Build. Res. Inst., Ministry of Construction, Tokyo, 277 (in Japanese).
Hsu, T. T. C. (1993). “Unified theory of reinforced concrete.” New directions in civil engineering, CRC, Boca Raton, FL, London.
Hwang, S. J., Fang, W. H., Lee, H. J., and Yu, H. W. (2001). “Analytical model for predicting shear strength of squat walls.” J. Struct. Eng., 127(1), 43–50.
Kabeasawa, T., Kuramoto, H., and Matsumoto, K. (1993). “Tests and analyses of high strength shear walls.” Proc., 1st Meeting of the Multilateral Project on the Use of High Strength Concrete, Kyoto, Japan, 1–26.
Lefas, L. D., Kotsovos, M. D., and Ambraseys, N. N. (1990). “Behaviour of reinforced concrete structural walls: Strength, deformation characteristics, and failure mechanism.” ACI Struct. J., 87(1), 23–31.
Maier, J., and Thurliamann, B. (1985). “Bruchversuche an Satahlbetonscheiben [Fracture tests on reinforced concrete plates].” Institut fur Baustatik und Konstruktion ETH, Zurich, Switzerland, 130 (in German).
Mansour, M. Y., Dicleli, M., and Lee, J. Y. (2004). “Nonlinear analysis of R/C low-rise shear walls.” Adv. Struct. Eng., 7(4), 345–361.
Mau, S. T., and Hsu, T. C. (1987). “Shear behaviour of reinforced concrete framed wall panels with vertical loads.” ACI Struct. J., 84(3), 228–234.
Mo, Y. L. (1993). “Dynamic tests on reinforced concrete shearwalls.” National Science Council Project Rep. No. NSC81-0410-E006-521, July, Taiwan (in Chinese).
Oesterle, R. G., Aristizabal-Ochoa, J. D., Shiu, K. N., and Corley, W. G. (1984). “Web crushing of reinforced concrete structural walls.” ACI J., 81(3), 231–241.
Paulay, T., and Priestley, M. J. N. (1992). Seismic design of reinforced concrete and masonry buildings, Wiley, New York.
Paulay, T., Priestley, M. J. N., and Synge, A. J. (1982). “Ductility in earthquake resisting squat shearwalls.” ACI J., 79, 257–269.
Vecchio, F., and Collins, M. P. (1986). “The modified-field compression theory for reinforced concrete elements subjected to shear.” ACI J., 83(2), 219–231.
Warner, R. F., Rangan, B. V., and Hall, A. S. (1989). Reinforced concrete, Longman Cheshire Pty. Ltd., Melbourne, Australia.
Yu, H. W., and Hwang, S. J. (2005). “Evaluation of softened truss model for strength prediction of reinforced concrete squat walls.” J. Eng. Mech., 131(8), 839–846.
Zhang, L. -X. B., and Hsu, T. T. C. (1998). “Behavior and analysis of 100 MPa concrete membrane elements.” J. Struct. Eng., 124(1), 24–34.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Aug 18, 2008
Accepted: Mar 9, 2010
Published online: Mar 12, 2010
Published in print: Oct 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.