Long-Term Behavior of Composite Beams under Positive and Negative Bending. I: Experimental Study
This article is a reply.
VIEW THE ORIGINAL ARTICLEThis article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Structural Engineering
Volume 136, Issue 7
Abstract
This paper presents an experimental program designed to examine the long-term behavior of composite steel-concrete beams under sustained loads. The test program consisted of two simply supported beams under positive bending moments and two cantilever beams under negative bending moments. Long-term deflections, strains, and the cracking behaviors of the specimen beams were monitored over a period of 3 years. The primary observations are: (1) the deflection of the simply supported beam under positive bending moment increased quite significantly over the time due to creep and shrinkage, with the midspan deflections after 3 years of loading reached 2.5 times of the initial deflections, and (2) the cracking of concrete occurred in hogging moment regions for cantilever beams due to the combined effects of concrete shrinkage and sustained negative bending moments. Current design codes were evaluated through a comparison between the calculations and testing results. It was found that the effective modulus method provides a satisfactory prediction on deflections and strains for beams under positive bending moments. But for beams under negative bending moment, the stiffness reduction due to cracking effect should be considered in calculation.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The experimental investigation presented in this paper was carried out in the Engineering Structure Laboratory at Tsinghua University, and was financed by the Chinese National Science Foundation (Grant No. UNSPECIFIED50408001). The assistance of the laboratory staff and the financial support are gratefully acknowledged.
References
American Association of State Highway and Transportation Officials (AASHTO). (1998). LRFD bridge design specifications, 2nd Ed., Washington, D.C.
American Concrete Institute (ACI). (1982). “Building code requirements for structural concrete and commentary.” ACI 209, Detroit.
American Concrete Institute (ACI). (1997). “Cracking of concrete members in direct tension.” ACI 224, Detroit.
Bazant, Z. P., and Murphy, W. P. (1995). “Creep and shrinkage prediction model for analysis and design of concrete structures—Model B3.” Mater. Struct., 28, 357–365.
Bazant, Z. P., and Panula, L. (1978). “Practical prediction of time-dependent deformations of concrete. Part I—Shrinkage.” Mater. Struct., 11(5), 317–328.
Bradford, M. A., and Gilbert, R. I. (1991). “Experiments composite beams at service loads.” Civ. Engng. Trans. Instn. Engrs. Austral., 33(4), 284–291.
Comité Euro-International du Beton (CEB-FIP) (1993). “CEB-FIP model code 1990 for concrete structures.” CEB-FIP 90, Thomas Telford, London.
Dezi, L., Leoni, G., and Tarantino, A. M. (1998). “Creep and shrinkage analysis of composite beams.” Prog. Struct. Eng. Mater., 1(2), 170–177.
European Committee for Standardization (CEN). (2004). “Design of concrete structures, part 1.1: General rules and rules for buildings.” EN 1992-1-1, Eurocode 2, Brussels, Belgium.
European Committee for Standardization (CEN). (2005). “Design of composite steel and concrete structures, part 2: General rules and rules for bridges.” EN 1994-2, Eurocode 4, Brussels, Belgium.
Johnson, R. P. (1987). “Shrinkage induced curvature in composite beams with a cracked concrete flange.” Struct. Eng., 65B(4), 72–76.
Johnson, R. P., and Allison, R. W. (1981). “Shrinkage and tension stiffening in negative moment regions of comopsite beams.” Struct. Eng., 56B(1), 10–16.
Johnson, R. P., and Buckby, R. J. (1986). Bridges, 2nd Ed., Vol. 2, Composite Structures of Steel and Concrete, Blackwell Scientific Publications, London.
Ministry of Housing and Urban-Rural Development (MOHURD). (2002). “Code for design of concrete structures.” GB 50010-2002, Beijing (in Chinese).
Nie, J., Fan, J., and Cai, C. S. (2008). “Experimental study of partially shear-connected composite beams with profiled sheeting.” Eng. Struct., 30(1), 1–12.
Roll, F. (1971). “The effects of differential shrinkage and creep on a composite steel concrete structure.” ACI Special Publication, Vol. 8, American Concrete Institute, Detroit, 187–214.
Wright, H. D., Witek, J. L., and Rakib, S. N. (1992). “Long-term creep and shrinkage in composite beams with partial connection.” Proc. Instn Civ. Eng., Struct. Build., 94(5), 187–195.
Xue, W., Ding, M., He, C., and Li, J. (2008). “Long-term behavior of prestressed composite beams at service loads for one year.” J. Struct. Eng., 134(6), 930–937.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Mar 12, 2009
Accepted: Dec 20, 2009
Published online: Dec 29, 2009
Published in print: Jul 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.