Load-History Effects on Deformation Capacity of Flexural Members Limited by Bar Buckling
Publication: Journal of Structural Engineering
Volume 136, Issue 1
Abstract
Buckling of reinforcement is one of the possible phenomena that limit the deformation capacity of reinforced concrete members under reversed cyclic loading. Previous experimental research suggests that occurrence of buckling is linked to displacement history, a parameter that is not explicitly accounted for in the available expressions for ultimate drift or curvature ductility capacities. This problem is explored in the present paper, by following through analytical expressions that relate the critical buckling strain as defined by the hysteretic stress-strain model of the reinforcement and the imposed cyclic history in terms of displacement. The analytical expressions thus derived are evaluated parametrically in order to establish behavioral trends. It is shown that when controlled by bar buckling, deformation capacity cannot be defined uniquely as it varies with the path of applied load. A primary conclusion of the research is that any quantifiable indices of deformation capacity referred to in the framework of displacement-based design using deterministic approaches need be adjusted to represent conservative lower bounds rather than approximations to the actual values of nominal failure.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Partial funding for this research was provided by the Hellenic General Secretariat for Research and Technology under Program ARISTION.
References
Bae, S., Mieses, A. M., and Bayrak, O. (2005). “Inelastic buckling of reinforcing bars.” J. Struct. Eng., 131(2), 314–321.
Berry, M., Parrish, M., and Eberhard, M. (2004). PEER structural performance database—User’s manual, Pacific Earthquake Engineering Research Center, University of California, Berkeley, Calif.
Berry, M. P., and Eberhard, M. O. (2005). “Practical performance model for bar buckling.” J. Struct. Eng., 131(7), 1060–1070.
Biskinis, D., and Fardis, M. (2006). “Assessment and upgrading of resistance and deformation capacity of concrete piers.” Proc., First European Conf. on Earthquake Engineering and Seismology, Geneva, 315.
Dhakal, R. P., and Maekawa, K. (2002a). “Modeling for postyield buckling of reinforcement.” J. Struct. Eng., 128(9), 1139–1147.
Dhakal, R. P., and Maekawa, K. (2002b). “Path-dependent cyclic stress-strain relationship of reinforcing bar including buckling.” Eng. Struct., 24, 1383–1396.
El-Bahy, A., Kunnath, S. K., Stone, W. C., and Taylor, A. (1999a). “Cumulative seismic damage of circular bridge columns: Benchmark and low-cycle fatigue tests.” ACI Struct. J., 96(4), 633–641.
El-Bahy, A., Kunnath, S. K., Stone, W. C., and Taylor, A. W. (1999b). “Cumulative seismic damage of circular bridge columns: Variable amplitude tests.” ACI Struct. J., 96(5), 711–720.
Elwood, K. J., and Moehle, J. P. (2005). “Drift capacity of reinforced concrete columns with light transverse reinforcement.” Earthquake Spectra, 21(1), 71–89.
Eurocode 2. (2004). “Design of concrete structures—Common rules for buildings and civil engineering structures.” European Committee for Standardisation.
Hoehler, M. S., and Stanton, J. F. (2006). “Simple phenomenological model for reinforcing steel under arbitrary load.” J. Struct. Eng., 132(7), 1061–1069.
Inel, M. (2002), “Displacement-based strategies for performance-based seismic design of ‘short’ bridges with embankment flexibility.” Ph.D. thesis, Department of Civil Engineering, Univ. of Illinois at Urbana-Champaign.
Inel, M., Aschheim, M., and Pantazopoulou, S. J. (2007). “Seismic deformation capacity estimates for concrete columns.” Mag. Concrete Res., 59(4), 297–310.
Lehman, D. E., and Moehle, J. P. (2000). “Seismic performance of well-confined concrete bridge columns.” Pacific Earthquake Engineering Research Center Rep. No. 1998/01, U.C. Berkeley, Calif.
Menegotto, M., and Pinto, P. (1977). “Slender R/C compressed members in biaxial bending.” J. Struct. Div., 103(ST3), 587–605.
Monti, G., and Nuti, C. (1992). “Nonlinear cyclic behavior of reinforcing bars including buckling.” J. Struct. Eng., 118(12), 3268–3284.
Panagiotakos, T., and Fardis, M. N. (2001). “Deformation of R.C. members at yielding and ultimate.” ACI Struct. J., 98(2), 135–148.
Pantazopoulou, S. J. (1998). “Detailing for reinforcement stability in RC members.” J. Struct. Eng., 124(6), 623–632.
Pantazopoulou, S. J. (2003). “Seismic assessment and retrofit of R.C. buildings.” fib Bulletin No. 24, Chap. 4, Lausane, Switzerland.
Papia, M., Russo, G., and Zingone, G. (1988). “Instability of longitudinal bars in RC columns.” J. Struct. Eng., 114(2), 445–461.
Priestley, M. J. N., Seible, F., and Calvi, M. (1996). Seismic design and retrofit of bridges, Wiley, New York, 678.
Pujol, S., Sozen, M., and Ramirez, J. (2006). “Displacement history effects of drift capacity of reinforced concrete columns.” ACI Struct. J., 103(2), 253–262.
Ranf, R. T., Eberhard, M. O., and Stanton, J. F. (2006). “Effects of displacement history on lightly confined, reinforced concrete bridge columns.” ACI Special Publication, 236, 23–42.
Rodriguez, M. E., Botero, J. C., and Villa, J. (1999). “Cyclic stress-strain behavior of reinforcing steel including effect of buckling.” J. Struct. Eng., 125(6), 605–612.
Sasani, M. (2007). “Life-safety and near-collapse capacity models for seismic shear behavior of reinforced concrete columns.” ACI Struct. J., 104(1), 30–38.
Sezen, H., and Moehle, J. (2004). “Strength and deformation capacity of RC columns with limited ductility.” Proc., 13th WCEE, Vancouver, Canada, 279.
Syntzirma, D., and Pantazopoulou, S. J. (2002). “Performance-based seismic evaluation of R.C. building members.” Proc., 12th European Conf. on Earthquake Engineering, London, 816.
Syntzirma D., Thermou G., Pantazopoulou S., and Halkitis G. (2006). “Experimental research of R.C. elements with substandard details.” Proc., 1st European Conf. on Earthquake Engineering and Seismology, Geneva, 819.
Syntzirma, D. V., and Pantazopoulou, S. J. (2006). “Deformation capacity of R.C. members with brittle details under cyclic loads.” ACI Special Publication, 236, 1–22.
Tastani, S., Pantazopoulou, S., Zdoumba, D., Plakantaras, V., and Akritidis, E. (2006). “Limitations of FRP Jacketing in confining old-type R.C. members in axial compression.” J. Compos. Constr., 10(1), 13–25.
Wood, S. L., and Sittipunt, C. (1996). “Cyclic response of reinforced concrete structural walls.” Proc., Mete Sozen Symp., ACI SP-162:399‒430.
Zhu, L., Elwood, K. J., and Haukaas, T. (2007). “Classification and seismic safety evaluation of existing reinforced concrete columns.” J. Struct. Eng., 133(9), 1316–1330.
Zhu, L., Elwood, K. J., Haukaas, T., and Gardoni, P. (2006). “Application of a probabilistic drift capacity model for shear-critical columns.” ACI Special Publication, 236, 81–102.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Jan 8, 2008
Accepted: Jul 11, 2009
Published online: Jul 23, 2009
Published in print: Jan 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.