Influence of Pulse-Like Near-Fault Ground Motions on the Base-Isolated Buildings with LRB Devices
Publication: Practice Periodical on Structural Design and Construction
Volume 26, Issue 4
Abstract
Seismic base isolation is a passive structural control system that has been effectively utilized as an innovative seismic-resistant design method in the past decades. The properties of earthquake ground motions have significant effects on the response of the base isolation system. Many recent studies were dedicated to the influence of near-fault ground motions on the response of seismically isolated buildings. These previous studies concluded that near-fault ground motions mostly impose larger displacement on the seismic isolators and, in some cases, larger floor acceleration; furthermore, the velocity pulse period influences the seismic isolator displacement and the floor acceleration. Most of the previous studies were conducted using ground motions simulated with certain parametric conditions of near-fault ground motions and/or a limited number of real earthquake ground motions. This study intended to examine the conclusions of previous studies through response history analysis of a seismically isolated prototype building with lead–rubber bearing (LRB) isolators using a large number of real near-fault earthquake ground accelerations. It was found that no consistent resonance phenomenon can be observed when the velocity pulse period is close to the natural period of the isolated building in terms of floor acceleration and isolator displacement, in contrast to the findings of other studies.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Models and ground motions that support the findings of this study are available from the authors upon reasonable request.
References
Alhan, C., and S. O. Davas. 2016. “Performance limits of seismically isolated buildings under near-field earthquakes.” Eng. Struct. 116 (Jun): 83–94. https://doi.org/10.1016/j.engstruct.2016.02.043.
Alhan, C., and Y. Göktas. 2009. “Effects of near-field earthquakes on seismically isolated buildings.” In Proc., WCCE-ECCE-TCCE Joint Conf.: Earthquake and Tsunami. London: Turkish Chamber of Civil Engineers, European Council of Civil Engineers, World Council of Civil Engineers.
ASCE. 2016. Minimum design loads for buildings and other structures. ASCE/SEI 7/16. Reston, VA: ASCE.
Aydin, E., B. Ozturk, and O. F. Kilinc. 2012. “Seismic response of low-rise base isolated structures.” In Proc., 15th World Conf. on Earthquake Engineering. Lisbon, Portugal: Sociedade Portuguesa de Engenharia Sísmica.
Baker, J. W. 2011. “Conditional mean spectrum: Tool for ground-motion selection.” J. Struct. Eng. 137 (3): 322–331. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000215.
Carlton, B., and N. Abrahamson. 2014. “Issues and approaches for implementing conditional mean spectra in practice.” Bull. Seismol. Soc. Am. 104 (1): 503–512. https://doi.org/10.1785/0120130129.
Disaster and Emergency Management Presidency, Ministry of Interior, the Republic of Turkey. 2018. Turkish building seismic code. Ankara, Turkey: Disaster and Emergency Management Presidency, Ministry of Interior, the Republic of Turkey.
Erdik, M., M. Demircioğlu, K. Şeşetyan, E. Durukal, and B. Siyahi. 2004. “Assessment of probabilistic earthquake hazard in the Marmara Region, Turkey.” Soil Dyn. Earthquake Eng. 24 (8): 605–631. https://doi.org/10.1016/j.soildyn.2004.04.003.
Heaton, T. H., J. F. Hall, and M. W. Halling. 1995. “Response of high-rise and base-isolated buildings to a hypothetical 7.0 blind thrust earthquake.” Science 267 (5195): 206–211. https://doi.org/10.1126/science.267.5195.206.s.
Jangid, R. S. 2005. “Optimum friction pendulum system for near-fault motions.” Eng. Struct. 27 (3): 349–359. https://doi.org/10.1016/j.engstruct.2004.09.013.
Jangid, R. S. 2007. “Optimum lead–rubber isolation bearings for near-fault motions.” Eng. Struct. 29 (10): 2503–2513. https://doi.org/10.1016/j.engstruct.2006.12.010.
Jangid, R. S., and J. M. Kelly. 2001. “Base isolation for near-fault motions.” Earthquake Eng. Struct. Dyn. 30 (5): 691–707. https://doi.org/10.1002/eqe.31.
Kelly, J. M. 1999. “The role of damping in seismic isolation.” Earthquake Eng. Struct. Dyn. 28 (1): 3–20. https://doi.org/10.1002/(SICI)1096-9845(199901)28:1%3C3::AID-EQE801%3E3.0.CO;2-D.
Kömür, M. A., İ. Ö. Deneme, and R. Oruç. 2019. “Seismic response of fixed-base and LRB base-isolated RC frame systems under NF and FF excitations.” J. Struct. Eng. 2 (4): 174–189. https://doi.org/10.31462/jseam.2019.04174189.
Kwong, N. S., and A. K. Chopra. 2017. “A generalized conditional mean spectrum and its application for intensity-based assessments of seismic demands.” Earthquake Spectra 33 (1): 123–143. https://doi.org/10.1193/040416eqs050m.
Lu, L. Y., C. C. Lin, and G. L. Lin. 2013. “Experimental evaluation of supplemental viscous damping for a sliding isolation system under pulse-like base excitations.” J. Sound Vib. 332 (8): 1982–1999. https://doi.org/10.1016/j.jsv.2012.12.008.
Lu, L. Y., M. H. Shih, S. W. Tzeng, and C. S. Chang. 2003. “Experiment of a sliding isolated structure subjected to near-field ground motion.” In Proc., 7th Pacific Conf. on Earthquake Engineering. Wellington, New Zealand: New Zealand Society for Earthquake Engineering.
Mazza, F., and A. Vulcano. 2009. “Nonlinear response of RC framed buildings with isolation and supplemental damping at the base subjected to near-fault earthquakes.” J. Earthquake Eng. 13 (5): 690–715. https://doi.org/10.1080/13632460802632302.
Mazza, F., and A. Vulcano. 2012. “Effects of near-fault ground motions on the nonlinear dynamic response of base-isolated RC framed buildings.” Earthquake Eng. Struct. Dyn. 41 (2): 211–232. https://doi.org/10.1002/eqe.1126.
McVitty, W. J., and M. C. Constantinou. 2015. Property modification factors for seismic isolators: Design guidance for buildings. New York: Univ. of Buffalo, State Univ. of New York.
Moustafa, A., K. Ueno, and I. Takewaki. 2010. “Critical earthquake loads for SDOF inelastic structures considering evolution of seismic waves.” Earthquake Struct. 1 (2): 147–162. https://doi.org/10.12989/eas.2010.1.2.147.
Naeim, F., and J. M. Kelly. 1999. Design of seismic isolated structures: From theory to practice. New York: Wiley.
Noroozinejad Farsangi, E., A. A. Tasnimi, T. Y. Yang, I. Takewaki, and M. Mohammadhasani. 2018. “Seismic performance of base-isolated buildings under multi-directional earthquake excitations.” Smart Struct. Syst. 22 (4): 383–397.
Özuygur, A. R. 2021. “A comparative study of floor accelerations of different structural systems with lead-rubber-bearing (LRB) isolators.” Can. J. Civ. Eng. 99 (999): 1–12. https://doi.org/10.1139/cjce-2019-0382.
PEER (Pacific Earthquake Engineering Research Center). 2019. “NGA-West2 database of Pacific Earthquake Engineering Research Center.” Accessed October 17, 2019. http://ngawest2.berkeley.edu.
Providakis, C. P. 2008. “Effect of LRB isolators and supplemental viscous dampers on seismic isolated buildings under near-fault excitations.” Eng. Struct. 30 (5): 1187–1198. https://doi.org/10.1016/j.engstruct.2007.07.020.
Rong, Q. 2020. “Optimum parameters of a five-story building supported by lead-rubber bearings under near-fault ground motions.” J. Low Freq. Noise Vibr. Act. Control 39 (1): 98–113. https://doi.org/10.1177/1461348419845829.
Information & Authors
Information
Published In
Copyright
© 2021 American Society of Civil Engineers.
History
Received: Nov 8, 2020
Accepted: Apr 13, 2021
Published online: Jun 23, 2021
Published in print: Nov 1, 2021
Discussion open until: Nov 23, 2021
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.
Cited by
- Yun-Peng Zhu, Z. Q. Lang, Kohei Fujita, Izuru Takewaki, Analysis and design of non-linear seismic isolation systems for building structures—An overview, Frontiers in Built Environment, 10.3389/fbuil.2022.1084081, 8, (2023).
- Masoud Pourmasoud, Alan R.L. Park, Iman Hajirasouliha, James Lim, Amirmahmoud Behzadi, Validation of a New Equation to Estimate the Yield Strength of Lead Rubber Bearings, Procedia Structural Integrity, 10.1016/j.prostr.2023.01.077, 44, (590-597), (2023).
- Masoud Pourmasoud, Alan R. L. Park, Iman Hajirasouliha, James Lim, Amirmahmoud Behzadi, Validation of a New Equation to Estimate the Yield Strength of Lead Rubber Bearings, Seismic Isolation, Energy Dissipation and Active Vibration Control of Structures, 10.1007/978-3-031-21187-4_25, (304-313), (2023).
- Mohamed Hechmi El Ouni, Mahdi Abdeddaim, Said Elias, Nabil Ben Kahla, Review of Vibration Control Strategies of High-Rise Buildings, Sensors, 10.3390/s22218581, 22, 21, (8581), (2022).
- Baokui Chen, Yuxin Qiu, Jingang Xiong, Yaru Liu, Yanqing Xu, Seismic Performance and Optimization of a Novel Partial Seismic Isolation System for Frame Structures, Buildings, 10.3390/buildings12070876, 12, 7, (876), (2022).
- Salah Djerouni, Abdelhafid Ounis, Said Elias, Mahdi Abdeddaim, Rajesh Rupakhety, Optimization and performance assessment of tuned mass damper inerter systems for control of buildings subjected to pulse-like ground motions, Structures, 10.1016/j.istruc.2022.02.007, 38, (139-156), (2022).
- M. Pourmasoud, I. Hajirasouliha, A. Park, J.B.P. Lim, A new approach to estimate the lead core characteristic strength of lead rubber bearings, Engineering Structures, 10.1016/j.engstruct.2022.114817, 270, (114817), (2022).