Sewer Rehabilitation Using an Ultraviolet-Cured GFR Cured-in-Place Pipe
Publication: Practice Periodical on Structural Design and Construction
Volume 20, Issue 1
Abstract
Lack of knowledge about the performance of emerging sewer rehabilitation technologies represents a critical shortcoming in the water infrastructure industry. This has led the leading aging water infrastructure research organizations to develop pipe rehabilitation technology demonstration programs. Specific scenarios of interest include technologies applicable to challenging site conditions and pipes with challenging configurations. The results of these programs are intended to enhance the industry’s awareness of available technologies and their capabilities. This paper describes the demonstration of an emerging ultraviolet (UV)-cured, glass fiber–reinforced (GFR) cured-in-place pipe (CIPP) technology used to rehabilitate 271 m (888 ft) of 250-mm (10-in.) clay pipe in Frisco, Texas. This technology met the utility owner’s requirements, and mechanical testing showed that the liner exceeded the minimum design requirements. A key takeaway from this project was the importance of using the proper test method when evaluating the liner’s structural properties. These findings are valuable for water infrastructure system engineers in need of alternatives to traditionally disruptive pipeline renewal methods.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The author thanks the Water Environment Research Foundation (WERF) for supporting this research. The author also thanks the research teams from Louisiana Tech University and Carollo Engineers for their support throughout this project. Finally, the author thanks the project stakeholders from Frisco, Texas, Fuquay, and Reline America for their efforts in getting this project completed.
References
ASTM. (2005). “Standard test method for rubber property-durometer hardness.” D2240, West Conshohocken, PA.
ASTM. (2009). “Standard practice for rehabilitation of existing pipelines and conduits by the inversion and curing of a resin-impregnated tube.” F1216, West Conshohocken, PA.
ASTM. (2010a). “Standard test method for tensile properties of plastics.” D638, West Conshohocken, PA.
ASTM. (2010b). “Standard test methods for flexural properties of unreinforced and reinforced plastics and electrical insulating materials.” D790, West Conshohocken, PA.
ASTM. (2011). “Standard practice for rehabilitation of existing pipelines and conduits by the pulled-in-place installation of glass-reinforced plastic (GRP) cured-in-place thermosetting resin pipe (CIPP).” F2019, West Conshohocken, PA.
ISO. (2008). “Standard for quality management: Requirements.” ISO 9001:2008, Geneva.
Matthews, J., Condit, W., Wensink, R., and Lewis, G. (2012a). “Performance evaluation of innovative water main rehabilitation CIPP lining product in Cleveland, OH.” EPA/600/R-12/012, U.S. EPA, Washington, DC.
Matthews, J., Condit, W., Wensink, R., Lewis, G., and Sterling, R. (2012b). “Performance evaluation of innovative water main rehabilitation spray-on lining product in Somerville, NJ.” EPA/600/R-12/009, U.S. EPA, Washington, DC.
Melcher, B. (2010). “Small diameter sewer rehabilitation: Experiences with fiberglass UV-cured technology.” Proc., No-Dig Show, North American Society for Trenchless Technology (NASTT), Arlington, VA, 532–541.
O’Rourke, T., Druschel, S., and Netravali, A. (1990). “Shear strength characteristics of sand-polymer interfaces.” J. Geotech. Engrg., 451–469.
Sterling, R., Simicevic, J., Allouche, E., Condit, W., and Wang, L. (2010). “State of technology for rehabilitation of wastewater collection systems.” EPA/600/R-10/078, U.S. EPA, Washington, DC.
Sterling, R., Wang, L., and Morrison, R. (2009). “Rehabilitation of wastewater collection and water distribution systems: State of technology review report.” EPA/600/R-09/048, U.S. EPA, Washington, DC.
Thépot, O. (2004). “International comparison of methods for the design of sewer linings.” 3R Int., 43(8–9), 520–526.
Timoshenko, S., and Gere, J. (1961). Theory of elastic stability, 2nd Ed., McGraw Hill, New York.
U.S. EPA. (2007). “Innovation and research for water infrastructure for the 21st century: Research plan.” EPA/600/X-09/003, Washington, DC.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Nov 14, 2013
Accepted: Dec 4, 2013
Published online: Dec 6, 2013
Published in print: Feb 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.