Seismic Base Isolation for Buildings in Regions of Low to Moderate Seismicity: Practical Alternative Design
Publication: Practice Periodical on Structural Design and Construction
Volume 17, Issue 1
Abstract
Although Dhaka city has experienced any moderate to large earthquakes in the past, some recent ground shakings are certainly indications of its earthquake source and vulnerability. In addition, microseismicity data also supports the existence of at least four earthquake source points in and around Dhaka. However, it is important to appropriately consider the seismic lateral load effect in structural design. A newly adopted technology of seismic design is to isolate the superstructure from the substructure with the use of a base isolator. This paper covers the design of base isolators for a building located in Dhaka, Bangladesh, along with its structural and economic feasibility. A time history is generated for Dhaka, adjusting peak ground acceleration as per seismic region from a nearby recorded earthquake. The response spectrum curve based on the site geology of Dhaka is also generated from this time history. Linear static as well as dynamic (time history and response spectrum) analyses have been carried out for both isolated and nonisolated buildings. Similar analyses have also been repeated for buildings with different heights but similar plan areas. The study reveals that for low-to medium-rise buildings, isolation can reduce seismic force along with some savings in structural cost of the building, though incorporating base isolators increase the overall price and installation cost. A meticulous review indicates that savings may be in the order of 5–10% of the total structural cost of the respective building.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors thankfully wish to acknowledge the effort by the Bangladesh Earthquake Society, the Bangladesh University of Engineering and Technology as well as the support provided by the Research University Grant, No. UNSPECIFIEDRG093/10AET, University of Malaya, which further enhanced our research and success.
References
Ariga, T., Kanno, Y., and Takewaki, I. (2006). “Resonant behaviour of base-isolated high-rise buildings under long-period ground motions.” Struct. Des. Tall Spec., 15(3), 325–338.
Balkaya, C., and Kalkan, E. (2003). “Nonlinear seismic response evaluation of tunnel form building structures.” Comput. Struct., 81(3), 153–165.
Bangladesh National Building Code (BNBC). (1993). Bangladesh: Housing and Building Research Institute, Bangladesh Standard and Testing Institute.
Baratta, A., and Corbi, I. (2004). “Optimal design of base-isolators in multi-storey buildings.” Comput. Struct., 82(23–26), 2199–2209.
Bhuiyan, A. R., Okui, Y., Mitamura, H., and Imai, T. (2009). “A rheology model of high damping rubber bearings for seismic analysis: Identification of nonlinear viscosity.” Int. J. Solids Struct., 46(7–8), 1778–1792.
Casciati, F., and Hamdaoui, K. (2008). “Modelling the uncertainty in the response of a base isolator.” Probabilist. Eng. Mech., 23(4), 427–437.
Dall’Asta, A., and Ragni, L. (2006). “Experimental tests and analytical model of high damping rubber dissipating devices.” Eng. Struct., 28(13), 1874–1884.
Dall’Asta, A., and Ragni, L. (2008). “Nonlinear behavior of dynamic systems with high damping rubber devices.” Eng. Struct., 30(12), 3610–3618.
Deb, S. K. (2004). “Seismic base isolation—An overview.” Curr. Sci. India, 87(10), 1426–1430.
Dicleli, M., and Buddaram, S. (2007). “Comprehensive evaluation of equivalent linear analysis method for seismic-isolated structures represented by sdof systems.” Eng. Struct., 29(8), 1653–1663.
Di Egidio, A., and Contento, A. (2010). “Seismic response of a non-symmetric rigid block on a constrained oscillating base.” Eng. Struct., 32(10), 3028–3039.
Hong, W-K., and Kim, H-C. (2004). “Performance of a multi-story structure with a resilient-friction base isolation system.” Comput. Struct., 82(27), 2271–2283.
International Conference of Building Officials (ICBO). (1997). “Earthquake regulations for seismic isolated structures.” Uniform building code, Whittier, CA.
Islam, A. B. M. S., Hussain, R. R., Jameel, M., and Jumaat, M. Z. (2011a). “Non-linear time domain analysis of base isolated multi-storey building under site specific bi-directional seismic loading.” Autom. Constr., .
Islam, A. B. M. S., Jameel, M., Ahmad, S. I., and Jumaat, M. Z. (2011b). “Study on corollary of seismic base isolation system on buildings with soft story.” Int. J. Phys. Sci., 6(11), 2654–2661.
Islam, A. B. M. S., Jameel, M., Ahmad, S. I., Salman, F. A., and Jumaat, M. Z. (2011c). “Engendering earthquake response spectra for Dhaka region usable in dynamic analysis of structures.” Sci. Res. Essays, 6(16), 3519–3530.
Islam, A. B. M. S., Jameel, M., and Jumaat, M. Z. (2011d). “Study on optimal isolation system and dynamic structural responses in multi-story buildings.” Int. J. Phys. Sci., 6(9), 2219–2228.
Islam, A. B. M. S., Jameel, M., Rahman, M. A., and Jumaat, M. Z. (2011e). “Earthquake time history for Dhaka, Bangladesh as competent seismic record.” Int. J. Phys. Sci., 6(16), 3921–3926.
Islam, A. B. M. S., Jameel, M., Uddin M. A., and Ahmad, S. I. (2011f). “Simplified design guidelines for seismic base isolation in multi-storey buildings for Bangladesh National Building Code (BNBC).” Int. J. Phys. Sci., 6(23), 5467–5486.
Ismail, M., Rodellar, J., and Ikhouane, F. (2010). “An innovative isolation device for aseismic design.” Eng. Struct., 32(4), 1168–1183.
Jangid, R. S. (2007). “Optimum lead–rubber isolation bearings for near-fault motions.” Eng. Struct., 29(10), 2503–2513.
Kelly, T. E. (2001). Base isolation of structures: Design guidelines, Holmes Consulting Group Ltd.
Kilar, V., and Koren, D. (2009). “Seismic behaviour of asymmetric base isolated structures with various distributions of isolators.” Eng. Struct., 31(4), 910–921.
Komodromos, P. (2008). “Simulation of the earthquake-induced pounding of seismically isolated buildings.” Comput. Struct., 86(7–8), 618–626.
Komodromos, P., Polycarpou, P., Papaloizou, L., and Phocas, M. C. (2007). “Response of seismically isolated buildings considering poundings.” Earthquake Eng. Struct. Dyn., 36(12), 1605–1622.
Lu, L-Y., and Lin, G-L. (2008). “Predictive control of smart isolation system for precision equipment subjected to near-fault earthquakes.” Eng. Struct., 30(11), 3045–3064.
Matsagar, V. A., and Jangid, R. S. (2004). “Influence of isolator characteristics on the response of base-isolated structures.” Eng. Struct., 26(12), 1735–1749.
Micheli, I., Cardini, S., Colaiuda, A., and Turroni, P. (2004). “Investigation upon the dynamic structural response of a nuclear plant on aseismic isolating devices.” Nucl. Eng. Des., 228(1–3), 319–343.
Olsen, A. H., Aagaard, B. T., and Heaton, T. H. (2008). “Long-period building response to earthquakes in the San Francisco Bay area.” B. Seismol. Soc. Am., 98(2), 1047–1065.
Pocanschi, A., and Phocas, M. C. (2007). “Earthquake isolator with progressive nonlinear deformability.” Eng. Struct., 29(10), 2586–2592.
Polycarpou, P. C., and Komodromos, P. (2010). “Earthquake-induced poundings of a seismically isolated building with adjacent structures.” Eng. Struct., 32(7), 1937–1951.
Providakis, C. P. (2008). “Effect of LRB isolators and supplemental viscous dampers on seismic isolated buildings under near-fault excitations.” Eng. Struct., 30(5), 1187–1198.
SAP2000 Version 9 [Computer software]. Computer & Structures, Berkeley, CA.
Spyrakos, C. C., Koutromanos, I. A., and Maniatakis, C. A. (2009). “Seismic response of base-isolated buildings including soil–structure interaction.” Soil Dyn. Earthquake Eng., 29(4), 658–668.
Information & Authors
Information
Published In
Practice Periodical on Structural Design and Construction
Volume 17 • Issue 1 • February 2012
Pages: 13 - 20
Copyright
© 2012 American Society of Civil Engineers.
History
Received: Mar 2, 2010
Accepted: Dec 20, 2010
Published online: Dec 22, 2010
Published in print: Feb 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.