Abstract
This paper offers an overview of available methodologies and provisions for the structural analysis and mechanical design of buried welded steel water pipelines subjected to earthquake action. Both transient (wave-shaking) and permanent ground actions (from tectonic faults, soil subsidence, landslides, and liquefaction-induced lateral spreading) are considered. In the first part of the paper, following a brief presentation of seismic hazards, modeling of the interacting pipeline–soil system is discussed in terms of either simple analytical models or more rigorous finite elements, pinpointing their main features. The second part of the paper outlines pipeline resistance, with emphasis on the corresponding limit states. Possible mitigation measures for reducing seismic effects are presented, and the possibility of employing gasketed joints in seismic areas is discussed. Finally, the discussed analysis methodologies and design provisions are applied in a design example of a buried steel water pipeline located in an area with severe seismic action.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research work was partially supported by a financial grant from the European Commission through the Research Fund for Coal and Steel (RFCS Programme), Contract No. RFSR-CT-20011-00027, “Safety of Buried Steel Pipelines Under Ground-Induced Deformations” (GIPIPE). The authors also would like to thank Prof. C. B. Papazachos, Aristotle University of Thessaloniki, Greece, for his valuable comments on the wave propagation effects.
References
ALA (American Lifelines Alliance). (2005). “Seismic guidelines for water pipelines.” Washington, DC.
ASCE. (1984). “Guidelines for the seismic design of oil and gas pipeline systems.” Reston, VA.
ASME. (2006). “Pipeline transportation systems for liquid hydrocarbons and other liquids.” ANSI/ASME B31.4, New York.
ASME. (2007). “Gas transmission and distribution piping systems.” ANSI/ASME B31.8, New York.
AWWA (American Water Works Association). (2004). Steel water pipe: A guide for design and installation, manual M11, Denver.
Bardet, J. P., Tobita, T., Mace, N., and Hua, J. (2002). “Regional modelling of liquefaction-induced ground deformation.” Earthquake Spectra, 18(1), 19–46.
Bathe, K. J., and Almeida, C. A. (1982). “A simple and effective pipe elbow element—Interaction effects.” J. Appl. Mech., 49(1), 165–171.
CEN (European Committee for Standardization). (2000). “Gas supply systems—Pipelines for maximum operating pressure over 16 bar.” EN 1594 Standard, Brussels, Belgium.
CEN (European Committee for Standardization). (2003). “Petroleum and natural gas. Pipeline transportation systems.” EN 14161 Standard (ISO 13623:2000 modified), Brussels, Belgium.
CEN (European Committee for Standardization). (2006). “Part 4—Silos, tanks and pipelines.” Eurocode 8, CEN EN 1998-4, Brussels, Belgium.
CSA (Canadian Standard Association). (2007). “Oil and gas pipeline systems.” CSA-Z662, Mississauga, ON, Canada.
Dama, E., Karamanos, S. A., and Gresnigt, A. M. (2007). “Failure of locally buckled pipelines.” J. Pressure Vessel Technol., 129(2), 272–279.
Det Norske Veritas. (2012). “Submarine pipeline systems.” Offshore Standard DNV-OS-F101, Oslo, Norway.
EERI (Earthquake Engineering Research Institute). (1999). “Kocaeli, Turkey Earthquake of August 17.”, El Cerrito, CA.
Gresnigt, A. M. (1986). “Plastic design of buried steel pipes in settlement areas.” HERON, 31(4), 1–113.
Gresnigt, A. M., and Karamanos, S. A. (2009). “Local buckling strength and deformation capacity of pipes.” 19th Int. Offshore and Polar Engineering Conf., International Society of Offshore and Polar Engineers, Cupertino, CA, 212–223.
Iwamoto, T., Yamamura, Y., and Miyamoto, H. (1988). “Observation on behavior of buried pipelines and ground strain during earthquakes.” Proc. 9th World Conf. on Earthquake Engineering, Vol. 7, Earthquake Engineering Research Institute, Oakland, CA, 35–40.
Jibson, R. (1994). “Predicting earthquake-induced landslide displacement using Newmark’s sliding block analysis.” Transp. Res. Rec., 1411, 9–17.
Karamanos, S. A., et al. (2015a). “Safety of buried steel pipelines under ground-induced deformations.”, Brussels, Belgium.
Karamanos, S. A., Antoniou, K., Keil, B., and Card, R. J. (2016). “Finite element analysis of the mechanical behavior of mitered steel pipe elbows under bending and pressure.” ASCE Pipelines Conf., ASCE, Reston, VA.
Karamanos, S. A., Koritsa, E., Keil, B., and Card, R. J. (2015b). “Analysis and behavior of steel pipe welded lap joints in geohazard areas.” ASCE Pipelines Conf., ASCE, Reston, VA.
Karamanos, S. A., and Tassoulas, J. L. (1996). “Tubular members. I: Stability analysis and preliminary results.” J. Eng. Mech., 64–71.
Kennedy, R. P., Chow, A. W., and Williamson, R. A. (1977). “Fault movement effects on buried oil pipeline.” J. Transp. Eng., 103, 617–633.
Kouretzis, G. P., Bouckovalas, G. D., and Gantes, C. J. (2006). “3-D shell analysis of cylindrical underground structures under seismic shear (S) wave action.” Soil Dyn. Earthquake Eng., 26(10), 909–921.
Liang, J., and Sun, S. (2000). “Site effects on seismic behavior of pipelines: A review.” J. Pressure Vessel Technol., 122(4), 469–475.
Mason, J. A., O’Rourke, T. D., Jones, S., and Tutuncu, I. (2010a). “Compression performance of steel pipelines with welded slip joints.” J. Pipeline Syst. Eng. Pract., 2–10.
Mason, J. A., O’Rourke, T. D., and Jung, J. K. (2010b). “Direct tension performance of steel pipelines with welded slip joints.” J. Pipeline Syst. Eng. Pract., 133–140.
McPherson, D. L., Duffy, M., Koritsa, E., Karamanos, S. A., and Plattsmier, J. R. (2016). “Improving the performance of steel pipe welded-lap joints in geohazard areas.” ASCE Pipelines Conf., ASCE, Reston, VA.
Meyersohn, W. D. (1991). “Analytical and design considerations for the seismic response of buried pipelines.” Thesis, Graduate School of Cornell Univ., Ithaca, NY.
National Information Center of Earthquake Engineering. (2007). “IITK-GSDMA guidelines for seismic design of buried pipelines: Provisions with commentary and explanatory examples.” NICEE Publications, Kanpur, India.
NEN (Nederlands Normalisatie-Instituut). (2006). “Requirements for pipeline systems, NEN 3650. Part-1: General, and Part-2: Steel pipelines.” Delft, Netherlands.
Newmark, N. M., (1967). “Problems in wave propagation in soil and rocks.” Proc., Int. Symp. on Wave Propagation and Dynamic Properties of Earth Materials, Albuquerque, NM, 7–26.
Newmark, N. M., and Hall, W. J. (1975). “Pipeline design to resist large fault displacement.” Proc., U.S. National Conf. on Earthquake Engineering, Earthquake Engineering Research Institute, Oakland, CA, 416–425.
O'Rourke, M. J., and Hmadi, K. E. (1988). “Analysis of continuous buried pipelines for seismic wave effects.” Earthquake Eng. Struct. Dyn., 16, 917–929.
O’Rourke, M. J. (2003). “Buried pipelines.” Earthquake engineering handbook, C. Scawthorn and W. F. Chen, eds., CRC Press, Boca Raton, FL.
O’Rourke, M. J., Filipov, E., and Uçkan, E. (2015). “Towards robust fragility relations for buried segmented pipe in ground strain areas.” Earthquake Spectra, 31(3), 1839–1858.
O’Rourke, M. J., and Liu, X. (2012). “Seismic design of buried and offshore pipelines.”, Buffalo, NY.
Palmer, A. C., and King, R. A. (2008). Subsea pipeline engineering, 2nd Ed., PennWell Corp. Books, Tulsa, OK.
Paolucci, R., and Smerzini, C. (2008). “Earthquake-induced transient ground strains from dense seismic networks.” Earthquake Spectra, 24(2), 453–470.
Pournara, A. E., Papatheocharis, T., Karamanos, S. A., and Perdikaris, P. C. (2015). “Structural integrity of buckled steel pipes.” Offshore Mechanics and Arctic Engineering Conf., ASME, New York.
PRCI (Pipeline Research Council International). (2004). “Guidelines for the seismic design and assessment of natural gas and liquid hydrocarbon pipelines.” Houston.
PRCI (Pipeline Research Council International). (2009). “Guidelines for constructing natural gas and liquid hydrocarbon pipelines through areas prone to landslide and subsidence hazards.” Houston.
Saiyar, M., Ni, P., Take, W. A., and Moore, I. D. (2016). “Response of pipelines of differing flexural stiffness to normal faulting.” Géotechnique, 66(4), 275–286.
Sarvanis, G. C., et al. (2016). “Soil-pipe interaction models for simulating the mechanical response of buried steel pipelines crossing active faults.” Int. Ocean and Polar Engineering Conf., International Society of Offshore and Polar Engineers, Cupertino, CA.
Sarvanis, G. C., and Karamanos, S. A., (2016). “Analytical methodologies for pipeline design in geohazard areas.” ASME Pressure Vessels and Piping Division Conf., ASME, New York.
Smith, G. (2006). “Steel water pipe joint testing.” ASCE Pipelines Conf., ASCE, Reston, VA.
Trifunac, M. D., and Lee, V. W. (1996). “Peak surface strains during strong earthquake motion.” Soil Dyn. Earthquake Eng., 15(5), 311–319.
Tsetseni, S., and Karamanos, S. A. (2007). “Axial compression capacity of welded-lap pipeline joints.” J. Transp. Eng., 335–340.
USGS. (2004). “Landslide types and processes.” ⟨https://pubs.usgs.gov/fs/2004/3072/⟩ (Feb. 15, 2016).
Van Es, S. H. J., Gresnigt, A. M., Vasilikis, D., and Karamanos, S. A. (2016). “Ultimate bending capacity of spiral-welded steel tubes. Part I: Experiments.” Thin-Walled Struct., 102, 286–304.
Vasilikis, D., Karamanos, S. A., Van Es, S. H. J., and Gresnigt, A. M. (2016). “Ultimate bending capacity of spiral-welded steel tubes. Part II: Predictions.” Thin-Walled Struct., 102, 305–319.
Vazouras, P., Dakoulas, P., and Karamanos, S. A. (2015). “Pipe-soil interaction and pipeline performance under strike-slip fault movements.” Soil Dyn. Earthquake Eng., 72, 48–65.
Vazouras, P., Karamanos, S. A., and Dakoulas, P. (2010). “Finite element analysis of buried steel pipelines under strike-slip fault displacements.” Soil Dyn. Earthquake Eng., 30(11), 1361–1376.
Vazouras, P., Karamanos, S. A., and Dakoulas, P. (2012). “Mechanical behaviour of buried steel pipelines under strike-slip and normal/reverse fault displacements.” Soil Dyn. Earthquake Eng., 41, 164–180.
Wang, X., et al. (2010). “Strain-based design—Advances in prediction methods of tensile strain capacity.” 12th Int. Offshore and Polar Engineering Conf., International Society of Offshore and Polar Engineers, Cupertino, CA.
Wells, D. L., and Coppersmith, K. J. (1994). “Updated empirical relationships among magnitude, rupture length, rupture area and surface displacement.” Bull. Seismol. Soc. Am., 84(4), 974–1002.
Wham, B. P., and O’Rourke, T. D. (2016). “Jointed pipeline response to large ground deformation.” J. Pipeline Syst. Eng. Pract., 04015009.
Xie, X., et al. (2013). “Numerical modeling of buried HDPE pipelines subjected to normal faulting: A case study.” Earthquake Spectra, 29(2), 609–632.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Mar 21, 2016
Accepted: Mar 28, 2017
Published online: Jul 14, 2017
Published in print: Nov 1, 2017
Discussion open until: Dec 14, 2017
Notes
A shorter version of this manuscript was presented at the ASCE Pipelines 2014 Conference, Portland, Oregon.
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.