Effect of Sulfate Drying and Wetting Cycles on the Interfacial Bonding Properties between CFRP and Clay Brick
Publication: Journal of Materials in Civil Engineering
Volume 35, Issue 3
Abstract
To study the effects of sulfate drying and wetting cycles on the bond performance between fiber-reinforced polymer (FRP) and clay brick, a test was performed in this study by simulating the sulfate environment through the cyclic accelerated sulfate drying and wetting cycles. Results showed that the failure mode of the carbon fibre-reinforced polymer (CFRP) and clay brick interface was greatly affected by the sulfate wetting and drying cycles. Furthermore, the interfacial bonding properties (including ultimate bearing capacity and peak shear stress) increased slightly at the beginning and then showed a rapid decline. Based on the experiment and the existing interface theory, a bond–slip model that considers the cycle times is proposed. After comparing the predicted data with the experimental data, the results showed that the model can well reflect the degradation law of the interface bonding performance under the actions of sulfate drying and wetting cycles.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some or all data, models, or code that support the findings of this study are available from the corresponding author upon reasonable request.
References
Aiello, M. A., and S. M. Sciolti. 2006. “Bond analysis of masonry structures strengthened with CFRP sheets.” Constr. Build. Mater. 20 (1–2): 90–100. https://doi.org/10.1016/j.conbuildmat.2005.06.040.
Alecci, V., S. B. Bati, and G. Ranocchiai. 2009. “Study of brick masonry columns confined with CFRP composite.” J. Compos. Constr. 13 (3): 179–187. https://doi.org/10.1061/(ASCE)1090-0268(2009)13:3(179).
Barbieri, G., L. Biolzi, M. Bocciarelli, and S. Cattaneo. 2015. “Pull out of FRP reinforcement from masonry pillars: Experimental and numerical results.” Composites, Part B 69 (Feb): 516–525. https://doi.org/10.1016/j.compositesb.2014.10.025.
Carloni, C., and K. V. Subramaniam. 2009. “Investigation of the interface fracture during debonding between FRP and masonry.” Adv. Struct. Eng. 12 (5): 731–743. https://doi.org/10.1260/136943309789867890.
Chen, Y., Q.-F. Wang, Y.-H. Huang, Y.-X. Yang, and J.-H. Lin. 2007. “Numerical analysis for bonding in the interface between GFRP and clay brick.” Eng. Mech. 24 (5): 119–124.
China Building Materials Federation. 2017. Fired common bricks. GB/T 5101-2017. Beijing: China Building Materials Federation.
Hawileh, R. A., W. Nawaz, and J. A. Abdalla. 2015. “Effect of flexural CFRP sheets on shear resistance of reinforced concrete beams.” Compos. Struct. 122 (Apr): 468–476. https://doi.org/10.1016/j.compstruct.2014.12.010.
Huang, T. L. 2014. Analysis of bond performance between FRP and brick with cohesive zone model. Quanzhou, China: Univ. of Huaqiao.
Huang, T. L., and Y. H. Huang. 2015. “Analysis of the effective bond length between fiber reinforced polymer and brick.” Sichuan Build. Sci. 41 (2): 195–198.
Huang, Y. H. 2008. Studies on FRP-brick interface and its application. Quanzhou, China: Univ. of Huaqiao.
Ji, Y., and Y. J. Kim. 2017. “Effects of sulfuric acid on durability characteristics of CFRP composite sheets.” J. Mater. Civ. Eng. 29 (10): 04017159. https://doi.org/10.1061/(ASCE)MT.1943-5533.0002008.
Jiang, T., and J. G. Teng. 2007. “Analysis-oriented stress-strain models for FRP-confined concrete.” Eng. Struct. 29 (11): 2968–2986. https://doi.org/10.1016/j.engstruct.2007.01.010.
Jin, W. Q., D. Nie, Q. Wang, and J. W. Zhang. 2021. “The drying and watering cycle of sulfate’s influence on the adhesion of the interface of the bricks of burnt clay.” J. Railway Sci. Eng. 18 (5): 1248–1255.
Jin, W. Q., J. C. Zhao, and Q. Wang. 2020. “Effects of freeze-thaw cycles on interfacial bonding property between CFRP and sintered clay brick.” Acta Materiae Compositae Sin. 37 (9): 2294–2302.
Li, T. J., Y. Zhen, F. Gao, and J. He. 2012. “Bond-slip constitutive behavior between fiber-reinforced polymer and masonry.” J. Sichuan Univ. Sci. Eng. 25 (5): 80–83.
Liu, L. X. 2001. “Brief introduction on the study of erosion and prevention of concrete in salt lake and saline soil area of Chaerhan, Chaidamu.” J. Build. Mater. 4 (4): 395–400.
Liu, S. W. 2018. Research on degradation law and mechanism of CFRP sheet-concrete interfacial bonding performance under sulfate environment. Lanzhou, China: Univ. of Lanzhou Jiaotong.
Maljaee, H., B. Ghiassi, P. B. Loureno, and D. V. Oliveira. 2016. “FRP-brick masonry bond degradation under hygrothermal conditions.” Compos. Struct. 147 (Jul): 143–154. https://doi.org/10.1016/j.compstruct.2016.03.037.
Ministry of Construction of the People's Republic of China. 2019. Technical standard for inspection of building structure. GB/T 50344-2019. Beijing: China Architecture & Building Press.
MOHURD (Ministry of Housing and Urban-Rural Development of the People’s Republic of China). 2009. Standard test methods for long-term performance and durability of ordinary concrete. GB/T50082-2009. Beijing: MOHURD.
Nakaba, K., T. Kanakubo, T. Furuta, and H. Yoshizawa. 2001. “Bond behavior between fiber-reinforced polymer laminates and concrete.” ACI Struct. J. 98 (3): 359–367.
Popovics, S. 1973. “A numerical approach to the complete stress-strain curve of concrete.” Cem. Concr. Res. 3 (5): 583–599. https://doi.org/10.1016/0008-8846(73)90096-3.
Qian, C. G. 2007. Experimental research on bonded property of interface between FRP and fired common brick. Quanzhou, China: Univ. of Huaqiao.
Rasheed, H. A., K. H. Larson, and S. N. Amiri. 2013. “Analytical solution of interface shear stresses in externally bonded FRP-strengthened concrete beams.” J. Eng. Mech. 139 (1): 18–28. https://doi.org/10.1061/(ASCE)EM.1943-7889.0000341.
Rotunno, T., L. Rovero, U. Tonietti, and S. B. Bati. 2015. “Experimental study of bond behavior of CFRP-to-brick joints.” J. Compos. Constr. 19 (3): 04014063. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000528.
Sciolti, M. S., M. A. Aiello, and M. Frigione. 2012. “Influence of water on bond behavior between CFRP sheet and natural calcareous stone.” Composites, Part B 43 (8): 3239–3250. https://doi.org/10.1016/j.compositesb.2012.03.002.
Tao, Y., J. B. Gu, and R. Xin. 2019. “Seismic performance of multistorey masonry wall repaired by carbon fiber reinforced polymer grids.” J. Southwest Jiaotong Univ. 54 (6): 1258–1267.
Tedeschi, C., A. Kwiecień, M. R. Valluzzi, B. Zajac, E. Garbin, and L. Binda. 2014. “Effect of thermal ageing and salt decay on bond between FRP and masonry.” Mater. Struct. 47 (12): 2051–2065. https://doi.org/10.1617/s11527-014-0448-7.
Triantafillou, T. C. 1998. “Strengthening of structures with advanced FRP.” Prog. Struct. Eng. Mater. 1 (2): 126–134. https://doi.org/10.1002/pse.2260010204.
Wang, F. S., R. L. Sun, and X. J. Qin. 2002. “The investigation of concrete durability under natural condition of Ca Er Han Salt Lake.” Bull. Chin. Ceram. Soc. 21 (4): 16–22.
Wang, Q. F., Y. Chen, and Y. H. Huang. 2008. “Experimental study on single shear strength between GFRP and clay brick.” Build. Struct. 38 (5): 106–108.
Wang, Z. H., J. B. Wang, S. Y. Sheng, and L. Chen. 2022. “Effect of freeze-thaw cycles on bond properties of FRP sheet-brick.” Acta Materiae Compositae Sin. 39: 1–12.
Xie, J. 2005. Study on the new technique of repairing and strengthening masonry walls with continuous carbon fiber sheet. Tianjin, China: Univ. of Tianjin.
Yang, W. X. 2019. Study on the influence of erosion environment on the bonding properties of FRP sheet rein-forced blocks. Beijing: Univ. of Beijing Civil Engineering and Architecture.
Yarigarravesh, M., V. Toufigh, and M. Mofid. 2018. “Experimental and analytical evaluation of FRPs bonded to masonry-long term.” Surf. Coat. Technol. 344 (Jun): 729–741. https://doi.org/10.1016/j.surfcoat.2018.02.088.
Ye, L. P., and P. Fen. 2006. “Applications and development of fiber-reinforced polymer in engineering structures.” China Civ. Eng. J. 39 (3): 24–34.
Zheng, Y., L. Li, and M. Liu. 2010. “Study on anchorage strength models for F-RP attached to masonry.” J. Shenyang Jianzhu Univ. 26 (1): 27–30.
Zinno, A., G. P. Lignola, A. Prota, G. Manfredi, and E. Cosenza. 2010. “Influence of free edge stress concentration on effectiveness of frp confinement.” Composites, Part B 41 (7): 523–532. https://doi.org/10.1016/j.compositesb.2010.07.003.
Information & Authors
Information
Published In
Copyright
© 2022 American Society of Civil Engineers.
History
Received: Feb 11, 2022
Accepted: Jun 28, 2022
Published online: Dec 27, 2022
Published in print: Mar 1, 2023
Discussion open until: May 27, 2023
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.