Effect of Marble Waste Powder and Silica Fume on the Bond Behavior of Corroded Reinforcing Bar Embedded in Concrete
Publication: Journal of Materials in Civil Engineering
Volume 35, Issue 3
Abstract
Bond behavior is the mutual effect and the force transmission between concrete and reinforcing bar that directly influence the behavior of reinforced concrete structures. Considering the silica fume (SF) and marble waste powder (MWP) could enhance the concrete matrix and improve its adherence, the bond-slip behavior of corroded reinforcing bar in concrete containing SF and MWP as ordinary portland cement (OPC) is examined in this work. Three of 16 concrete mixes were selected for this investigation: one control mix, a second mix containing 10% SF and 5% MWP as OPC replacements, and the third containing 10% SF and 20% MWP as OPC replacements. The pullout test was applied to the specimens with 0%, 2%, 5%, and 10% corroded reinforcement. According to the results of specimens with uncorroded reinforcement, replacing 10% of cement by SF and 5% or 20% by MWP, the bond strength between concrete and reinforcing bar increased by 27% and 13%, respectively, compared to that of the control specimens. Also, the samples containing SF and MWP showed higher corrosion resistance and their bond strength’s loss due to the corrosion of reinforcing bars was less than the control samples. The results also indicate that bond stress at low corrosion (2%) levels is partially increased because of the friction resulting from the accumulation of corrosion products on reinforcement’s surface. However, for higher corrosion levels (5% and 10%), the bond strength decreases. By comparing the two diameters of reinforcing bars (12 and 16 mm), it was recognized that the reduction of bond strength due to the corrosion is more severe in the reinforcements with greater diameters.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All data, models, and code generated or used during the study appear in the published article.
Acknowledgments
Ghalehnovi would like to acknowledge the support received from the Ferdowsi University of Mashhad.
References
Almusallam, A. A., A. S. Al-Gahtani, and A. R. Aziz. 1996. “Effect of reinforcement corrosion on bond strength.” Constr. Build. Mater. 10 (2): 123–129. https://doi.org/10.1016/0950-0618(95)00077-1.
Asadi Shamsabadi, E. A., N. Roshan, S. A. Hadigheh, M. L. Nehdi, A. Khodabakhshian, and M. Ghalehnovi. 2022. “Machine learning-based compressive strength modelling of concrete incorporating waste marble powder.” Constr. Build. Mater. 324 (Mar): 126592. https://doi.org/10.1016/j.conbuildmat.2022.126592.
ASTM. 2017. Standard practice for preparing, cleaning, and evaluating corrosion test specimens. ASTM G1-03. West Conshohocken, PA: ASTM.
Belarbi, A., D. N. Richardson, M. K. Swenty, and L. H. Taber. 2010. “Effect of contamination on reinforcing bar-concrete bond.” J. Perform. Constr. Facil. 24 (3): 206–214. https://doi.org/10.1061/(ASCE)CF.1943-5509.0000091.
Chen, J., C. Fu, H. Ye, and X. Jin. 2020. “Corrosion of steel embedded in mortar and concrete under different electrolytic accelerated corrosion methods.” Constr. Build. Mater. 241 (Apr): 117971. https://doi.org/10.1016/j.conbuildmat.2019.117971.
Choudhary, R., R. Gupta, T. Alomayri, A. Jain, and R. Nagar. 2021. “Permeation, corrosion, and drying shrinkage assessment of self-compacting high strength concrete comprising waste marble slurry and fly ash, with silica fume.” Structures 33 (Oct): 971–985. https://doi.org/10.1016/j.istruc.2021.05.008.
Dotto, J. M. R., A. G. De Abreu, D. C. C. Dal Molin, and I. L. Müller. 2004. “Influence of silica fume addition on concretes physical properties and on corrosion behaviour of reinforcement bars.” Cem. Concr. Compos. 26 (1): 31–39. https://doi.org/10.1016/S0958-9465(02)00120-8.
El Maaddawy, T. A., and K. A. Soudki. 2003. “Effectiveness of impressed current technique to simulate corrosion of steel reinforcement in concrete.” J. Mater. Civ. Eng. 15 (1): 41–47. https://doi.org/10.1061/(ASCE)0899-1561(2003)15:1(41).
Fahmy, M. F., S. A. Ahmed, and Z. Wu. 2021. “Bar surface treatment effect on the bond-slip behavior and mechanism of basalt FRP bars embedded in concrete.” Constr. Build. Mater. 289 (Jun): 122844. https://doi.org/10.1016/j.conbuildmat.2021.122844.
Fang, C., K. Lundgren, L. Chen, and C. Zhu. 2004. “Corrosion influence on bond in reinforced concrete.” Cem. Concr. Res. 34 (11): 2159–2167. https://doi.org/10.1016/j.cemconres.2004.04.006.
Fang, C., K. Lundgren, M. Plos, and K. Gylltoft. 2006. “Bond behaviour of corroded reinforcing steel bars in concrete.” Cem. Concr. Res. 36 (10): 1931–1938. https://doi.org/10.1016/j.cemconres.2006.05.008.
Ghalehnovi, M., N. Roshan, A. Taghizadeh, E. Asadi Shamsabadi, S. A. Hadigheh, and J. de Brito. 2022. “Production of environmentally friendly concrete incorporating bauxite residue and silica fume.” J. Mater. Civ. Eng. 34 (2): 04021423. https://doi.org/10.1061/(ASCE)MT.1943-5533.0004060.
Ghorbani, S., I. Taji, M. Tavakkolizadeh, A. Davodi, and J. De Brito. 2018. “Improving corrosion resistance of steel rebars in concrete with marble and granite waste dust as partial cement replacement.” Constr. Build. Mater. 185 (Oct): 110–119. https://doi.org/10.1016/j.conbuildmat.2018.07.066.
Khodabakhshian, A., J. De Brito, M. Ghalehnovi, and E. A. Shamsabadi. 2018a. “Mechanical, environmental and economic performance of structural concrete containing silica fume and marble industry waste powder.” Constr. Build. Mater. 169 (Apr): 237–251. https://doi.org/10.1016/j.conbuildmat.2018.02.192.
Khodabakhshian, A., M. Ghalehnovi, J. De Brito, and E. A. Shamsabadi. 2018b. “Durability performance of structural concrete containing silica fume and marble industry waste powder.” J. Cleaner Prod. 170 (Jan): 42–60. https://doi.org/10.1016/j.jclepro.2017.09.116.
Kore, S. D., A. K. Vyas, and S. A. Kabeer KI. 2020. “A brief review on sustainable utilisation of marble waste in concrete.” Int. J. Sustainable Eng. 13 (4): 264–279. https://doi.org/10.1080/19397038.2019.1703151.
Liu, S., and W. Zhao. 2020. “Effect of marble dust and silica fume admixtures replaced in ordinary portland cement on corrosion behavior of carbon steel in the concrete after exposure to 5 wt% NaCl solution.” Int. J. Electrochem. Sci. 15 (Apr): 3825–3835. https://doi.org/10.20964/2020.05.51.
Lundgren, K. 2007. “Effect of corrosion on the bond between steel and concrete: An overview.” Mag. Concr. Res. 59 (6): 447–461. https://doi.org/10.1680/macr.2007.59.6.447.
Ma, Y., Z. Guo, L. Wang, and J. Zhang. 2017. “Experimental investigation of corrosion effect on bond behavior between reinforcing bar and concrete.” Constr. Build. Mater. 152 (Oct): 240–249. https://doi.org/10.1016/j.conbuildmat.2017.06.169.
Panesar, D. K. 2019. “Supplementary cementing materials.” In Developments in the formulation and reinforcement of concrete, 55–85. Cambridge, MA: Woodhead Publishing.
Ramganesh, V., M. A. Kumar, K. M. Mini, V. Vignesh, and R. Karthikeyan. 2020. “Effect of nano -epoxy composite in bond strength and corrosion resistance of rebar embedded in micro-silica modified concrete.” J. Phys. Conf. Ser. 1706 (1): 012122. https://doi.org/10.1088/1742-6596/1706/1/012122.
Rana, A., P. Kalla, and L. J. Csetenyi. 2015. “Sustainable use of marble slurry in concrete.” J. Cleaner Prod. 94 (May): 304–311. https://doi.org/10.1016/j.jclepro.2015.01.053.
Ribeiro, D. V., S. A. Pinto, N. S. A JúniorJ. S. A. Neto, I. H. Santos, S. L. Marques, and M. J. França. 2021. “Effects of binders characteristics and concrete dosing parameters on the chloride diffusion coefficient.” Cem. Concr. Compos. 122 (Sep): 104114. https://doi.org/10.1016/j.cemconcomp.2021.104114.
RILEM/CEB/FIP (International Union of Laboratories and Experts in Construction Materials/Comité Euro-International du Béton/Fédération International de la Précontrainte). 1983. “Bond test for reinforcing steel 2: Pullout test.” In Recommendation RC6, 218–220. London: E & FN Spon.
Shekarchi, M., A. Rafiee, and H. Layssi. 2009. “Long-term chloride diffusion in silica fume concrete in harsh marine climates.” Cem. Concr. Compos. 31 (10): 769–775. https://doi.org/10.1016/j.cemconcomp.2009.08.005.
Siddique, R. 2011. “Utilization of silica fume in concrete: Review of hardened properties.” Resour. Conserv. Recycl. 55 (11): 923–932. https://doi.org/10.1016/j.resconrec.2011.06.012.
Yalciner, H., O. Eren, and S. Sensoy. 2012. “An experimental study on the bond strength between reinforcement bars and concrete as a function of concrete cover, strength and corrosion level.” Cem. Concr. Res. 42 (5): 643–655. https://doi.org/10.1016/j.cemconres.2012.01.003.
Zhou, Y., B. Gencturk, K. Willam, and A. Attar. 2015. “Carbonation-induced and chloride-induced corrosion in reinforced concrete structures.” J. Mater. Civ. Eng. 27 (9): 04014245. https://doi.org/10.1061/(ASCE)MT.1943-5533.0001209.
Information & Authors
Information
Published In
Copyright
© 2022 American Society of Civil Engineers.
History
Received: Sep 3, 2021
Accepted: Jun 20, 2022
Published online: Dec 23, 2022
Published in print: Mar 1, 2023
Discussion open until: May 23, 2023
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.
Cited by
- Sidar Nihat Bicakci, Servan Baran, Busra Boyaci, Hasan Nuri Turkmenoglu, O. Tugrul Turan, Hakan Nuri Atahan, Evaluation of Microsilica and Nanosilica on Bond Properties between Moderate–High Strength Concrete and Plain–Ribbed Steel Rebar, Journal of Materials in Civil Engineering, 10.1061/JMCEE7.MTENG-15661, 36, 2, (2024).