Initial Assessment of Liquefied Scrap Tire Concrete
Publication: Journal of Materials in Civil Engineering
Volume 33, Issue 5
Abstract
A new approach to incorporate scrap tire material into concrete was investigated, in which two reclaimed waste tire components, carbon black and fuel oil, were used to replace a portion of water. The effect of liquid tire content to water ratios from 5% to 40% on an otherwise typical concrete mix were assessed, and compressive and flexural strength, flexural toughness, modulus of elasticity, and several fresh concrete properties were determined. Results were compared with typically expected results of traditional shredded tire mixes with equivalent tire content. It was found that the liquid tire mixes had significantly smaller losses of compressive strength and workability than did shredded rubber mixes; increased flexural strength compared with traditional concrete mix; and significantly decreased stiffness compared with traditional and shredded tire mixes.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some or all data, models, or code that support the findings of this study are available from the corresponding author upon reasonable request.
References
ACI (American Concrete Institute). 2014. Building code requirements for structural concrete and commentary. ACI 318-14. Farmington Hills, MI: ACI.
Alaloul, W., M. Musarat, B. Tayeh, S. Sivalingam, M. F. B. Rosli, S. Sani Haruna, and M. Khan. 2020. “Mechanical and deformation properties of rubberized engineered cementitious composite (ECC).” Case Stud. Constr. Mater. 13: e00385. https://doi.org/10.1016/j.cscm.2020.e00385.
Aslani, F. 2016. “Mechanical properties of waste tire rubber concrete.” J. Mater. Civ. Eng. 28 (3): 04015152. https://doi.org/10.1061/(ASCE)MT.1943-5533.0001429.
ASTM. 2010. Standard test method for slump of hydraulic-cement concrete. ASTM C143. West Conshohocken, PA: ASTM.
ASTM. 2011a. Standard practice for making and curing concrete test specimens in the field. ASTM C31. West Conshohocken, PA: ASTM.
ASTM. 2011b. Standard test method for air content of freshly mixed concrete by the pressure method. ASTM C231. West Conshohocken, PA: ASTM.
ASTM. 2011c. Standard test method for compressive strength of cylinder concrete specimens. ASTM C39. West Conshohocken, PA: ASTM.
ASTM. 2014. Standard test method for flexural properties of unreinforced and reinforced plastics and electrical insulating materials. ASTM D790. West Conshohocken, PA: ASTM.
ASTM. 2016. Standard test method for flexural strength of concrete (using simple beam with center-point loading). ASTM C293. West Conshohocken, PA: ASTM.
ASTM. 2019. Standard classification system for carbon blacks used in rubber products. ASTM D1765. West Conshohocken, PA: ASTM.
Brentin, R., and P. Sarnacke. 2011. Rubber compounds: A market opportunity study. Midland, MI: Omni Tech International.
Chou, L-H., C.-K. Yang, M.-T. Lee, and C.-C. Shu. 2010. “Effects of partial oxidation of crumb rubber on properties of rubberized mortar.” Composites, Part B. 41 (8): 613–616. https://doi.org/10.1016/j.compositesb.2010.09.009.
Danko, M., E. Cano, and J. Pena. 2006. Use of recycled tires as partial replacement of coarse aggregate in the production of concrete. West Lafayette, IN: Purdue Univ.
Eamon, C., and A. Nowak. 2005. “Effect of edge-stiffening and diaphragms on the reliability of bridge girders.” J. Bridge Eng. 10 (2): 206–214. https://doi.org/10.1061/(ASCE)1084-0702(2005)10:2(206).
Eldin, N., and A. Senouci. 1993. “Rubber-tire particles as concrete aggregates.” J. Mater. Civ. Eng. 5 (4): 478–496. https://doi.org/10.1061/(ASCE)0899-1561(1993)5:4(478).
Gomez-Hernandez, R., Y. Panecatl-Bernal, and M. Mendez-Rojas. 2019. “High yield and simple one-step production of carbon black nanoparticles from waste tires.” Heliyon 5 (7): e02139.
Habib, A., U. Yildirim, and O. Eren. 2020. “Mechanical and dynamic properties of high strength concrete with well graded coarse and fine tire rubber.” Constr. Build. Mater. 246 (Jun): 118502. https://doi.org/10.1016/j.conbuildmat.2020.118502.
Khatib, Z., and F. Bayomy. 1999. “Rubberized portland cement concrete.” J. Mater. Civ. Eng. 11 (3): 206–213. https://doi.org/10.1061/(ASCE)0899-1561(1999)11:3(206).
Li, D., J. Mills, T. Benn, X. Ma, R. Gravina, and Y. Zhuge. 2016a. “Review of the performance of high-strength rubberized concrete and its potential structural applications.” Adv. Civ. Eng. Mater. 5 (1): 20150026. https://doi.org/10.1520/ACEM20150026.
Li, G., Z. Wang, C. K. Y. Leung, S. Tang, J. Pan, W. Huang, and E. Chen. 2016b. “Properties of rubberized concrete modified by using silane coupling agent and carboxylated SBR.” J. Cleaner Prod. 112 (Jan): 797–807. https://doi.org/10.1016/j.jclepro.2015.06.099.
MDEQ (Michigan Department of Environmental Equality). 2011. Scrap tire regulatory program–scrap tire market development grant. Lansing, MI: MDEQ.
Moulin, L., S. Da Silva, A. Bounaceur, M. Herblot, and Y. Soudais. 2017. “Assessment of recovered carbon black obtained by waste tires steam water thermolysis: An industrial application.” Waste Biomass Valorization 8 (8): 2757–2770. https://doi.org/10.1007/s12649-016-9822-8.
Mouri, H. 2016. “Bridgestone’s view on circular economy.” In Towards a circular economy: Corporate management and policy pathways, edited by V. Anbumozhi, 31–42. Jakarta, Indonesia: Economic Research Institute for the Association of Southeast Asian Nations and East Asia.
Muñoz-Sánchez, B., M. J. Arévalo-Caballero, and M. C. Pacheco-Menor. 2017. “Influence of acetic acid and calcium hydroxide treatments of rubber waste on the properties of rubberized mortars.” Mater. Struct. 50 (1): 75. https://doi.org/10.1617/s11527-016-0912-7.
Najim, K. B., and M. R. Hall. 2013. “Crumb rubber aggregate coatings/pre-treatments and their effects on interfacial bonding, air entrapment and fracture toughness in self-compacting rubberised concrete (SCRC).” Mater. Struct. 46 (12): 2029–2043. https://doi.org/10.1617/s11527-013-0034-4.
NSF (National Science Foundation). 2014. Old tires become material for new and improved roads. Alexandria, VA: NSF.
Piskorz, J., P. Majerski, D. Radlein, T. Wik, and D. S. Scott. 1999. “Recovery of carbon black from scrap rubber.” Energy Fuels 13 (3): 544–551. https://doi.org/10.1021/ef980054i.
Roychand, R., R. J. Gravina, Y. Zhuge, X. Ma, O. Youssf, and J. E. Mills. 2020. “A comprehensive review on the mechanical properties of waste tire rubber concrete.” Constr. Build. Mater. 237 (Mar): 117651. https://doi.org/10.1016/j.conbuildmat.2019.117651.
Segre, N., and I. Joekes. 2000. “Use of tire rubber particles as addition to cement paste.” Cem. Concr. Res. 30 (9): 1421–1425. https://doi.org/10.1016/S0008-8846(00)00373-2.
Tamanna, K., M. Tiznobaik, N. Banthia, and M. Shahria Alam. 2020. “Mechanical properties of rubberized concrete containing recycled concrete aggregate.” ACI Mater. J. 117 (3): 169–180.
Thomas, B., and R. Gupta. 2016. “A comprehensive review on the applications of waste tire rubber in cement concrete.” Renewable Sustainable Energy Rev. 54 (Feb): 1323–1333. https://doi.org/10.1016/j.rser.2015.10.092.
Xu, X., Z. Zhang, Y. Hu, and X. Wang. 2020. “Bearing strength of crumb rubber concrete under partial area loading.” Materials 13 (11): 2446. https://doi.org/10.3390/ma13112446.
Zhang, X., H. Li, Q. Cao, L. Jin, and F. Wang. 2018. “Upgrading pyrolytic residue from waste tires to commercial carbon black.” Waste Manage. Res. 36 (5): 436–444. https://doi.org/10.1177/0734242X18764292.
Zhang, Z., H. Ma, and S. Qian. 2015. “Investigation on properties of ECC incorporating crumb rubber of different sizes.” J. Adv. Concr. Technol. 13 (5): 241–251. https://doi.org/10.3151/jact.13.241.
Information & Authors
Information
Published In
Copyright
© 2021 American Society of Civil Engineers.
History
Received: May 28, 2020
Accepted: Oct 6, 2020
Published online: Feb 26, 2021
Published in print: May 1, 2021
Discussion open until: Jul 26, 2021
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.